NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
MARCY DIAMOND ELITE
WEIGHT BENCH
MD-377
Hardware Identifier
Assembly Instruction
Parts List
Warranty
Ordering Parts
Model
MD-377
Retain This
Manual for
Reference
07-18-08
OWNER'S
MANUAL
IMPEX® INC.
14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
Tel: (800) 999-8899 Fax: (626) 961-9966
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT leave
children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine near water
or outdoors.
5. Keep hands and feet away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear robes or
other clothing that could become caught in the machine. Running or aerobic shoes are
also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO NOT use
attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or physician in
attendance.
10. Before using the machine to exercise, always do stretching exercises to properly warm
up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
CARE AND MAINTENANCE
1. Lubricate moving parts with WD-40 or light oil periodically.
2. Inspect and tighten all parts before using the machine.
3. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
4. Maximum weight capacity on the uprights: 200 lbs.
5. Maximum user’s weight: 250 lbs.
6. Maximum weight capacity on the leg developer: 100 lbs.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE
OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL
INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC. ASSUMES
NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE
SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING LABEL REPLACEMENT
The Warning Label shown here has been placed on the Cross Brace. If the label is missing or illegible, please
call customer service at 1-800-999-8899 for replacement. Apply the label in location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
HARDWARE PACK
NOTE: The following parts are not drawn to scale. Please use your own ruler to measure the size.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Plug the two Upright End Caps (#17) onto the bottom of the Right & Left Upright
Beams (#1 & #2). Secure each Cap with a ST5 Screw (#40).
B.) Connect the two Upright Beams by a Cross Brace (#4) in the Mid-span. Secure them
with two M10 x 3 1/8” Carriage Bolts (#27), one Curved Bracket (#13), two ∅ ¾”
Curved Washers (#37), and two M10 Aircraft Nuts (#38) on each end of Cross Brace.
C.) Insert the Backrest Adjustment Bar (#9) through the holes on the two Uprights to
obtain desired incline of Backrest.
DIAGRAM 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Plug a Front Leg End Cap (#19) onto the bottom of Front Leg (#5). Attach the Front
Leg to the Main Seat Support (#3). Secure it with three M8 x 5/8” Allen Bolts (#30) and
three Ø 5/8” Washers (#35). DO NOT tighten the Bolts yet.
B.) Attach the Main Seat Support to the Cross Brace (#4). Secure it with two M10 x 2 3/8”
Carriage Bolts (#28), one Bracket (#12), two Ø ¾” Washers (#34), and M10 Aircraft
Nuts (#34). DO NOT tighten the Bolts yet.
C.) Attach one end of Diagonal Support (#8) to the Front Leg. Secure it with one M8 x 5/8”
Allen Bolt (#30) and Ø 5/8” Washer (#35). Attach the other end to the Main Seat
Support. Secure it with one M8 x 2 1/8” Allen Bolt (#29), two Ø 5/8” Washers (#35),
and one M8 Aircraft Nut (#39).
D.) Securely tighten all Nuts and Bolts previously installed.
DIAGRAM 2
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#7) to the Front Leg (#5). Secure it with one M8 x 3 1/8”
Allen Bolt (#31), two Ø 5/8” Washers (#35), and one M8 Aircraft Nut (#39).
B.) Insert two Foam Tubes (#11) halfway through the holes on the Leg Developer. Push
four Foam Rolls (#22) onto the Tubes from both sides.
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the Backrest Supports (#12) onto both ends of the pivot on the Main Seat Support
(#3). Place the other end rest against the Backrest Adjustment Bar (#9).
B.) Place the Backrest Board (#26) onto the Backrest Supports. Secure it with four M6 x 1 ½”
Hex Bolts (#32) and Ø ½” Washers (#36).
C.) Place the Seat Pad (#33) onto the Main Seat Support. Secure it with four M6 x 1 ¼” Hex
Bolts (#33) and Ø ½” Washers (#36).
DIAGRAM 4
8
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 5 (See Diagram 5)
A.) Attach the Arm Curl Pad (#24) to the Arm Curl Stand (#6). Secure it with
two M8 x 5/8” Allen Bolts (#30) and two Ø 5/8” Washers (#35).
B.) Insert the Arm Curl Stand into the top opening on the Front Leg (#5). Use
a Lock Knob (#14) to hold the Arm Curl Stand in position.
C.) When using Leg Developer, remove the Arm Curl Stand from the Front Leg.
DIAGRAM 5
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
10
PARTS LIST
KEY NO.
1
DESCRIPTION
QUANTITY
Right Upright Beam
Left Upright Beam
Main Seat Support
Cross Brace
Front Leg
Arm Curl Stand
Leg Developer
Diagonal Support
Backrest Adjustment Bar
Backrest Support
Foam Tube
Bracket
Curve Bracket
1
1
1
1
1
1
1
1
1
2
2
1
2
1
2
6
2
2
1
1
3
4
2
1
1
1
4
2
1
6
1
4
4
2
10
8
4
6
2
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
Lock Knob
1” Square End Cap
Ø 1” Foam Tube End Cap
Upright End Cap
Bushing
Front Leg End Cap
Ø 2 3/8” x Ø 2” Sleeve
Ø 2” End Cap
Foam Roll
Ø 1” End Cap
Arm Curl Pad
Seat Pad
Backrest Board
M10 x 3 1/8” Carriage Bolt
M10 x 2 3/8” Carriage Bolt
M8 x 2 1/8” Allen Bolt
M8 x 5/8” Allen Bolt
M8 x 3 1/8” Allen Bolt
M6 x 1 ½” Hex Bolt
M6 x 1 ¼” Hex Bolt
Ø ¾” Washer
Ø 5/8” Washer
Ø ½” Washer
Ø ¾” Curved Washer
M10 Aircraft Nut
M8 Aircraft Nut
ST5 Screw
#5 Allen Wrench (Tool)
Download from Www.Somanuals.com. All Manuals Search And Download.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX® INC.
LIMITED WARRANTY
®
IMPEX Inc. ("IMPEX ") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase.
This warranty extends only to the original purchaser. IMPEX's obligation under this Warranty is limited
to replacing or repairing, at IMPEX's option.
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX
Customer Service Department at 1-800-999-8899. All freights for products return to IMPEX must be
prepaid by the customer. This warranty does not extend to any product or damage to a product caused
by or attributable to freight damage, abuse, misuse, improper or abnormal usage or repairs not provided
by an IMPEX authorized service center or for products used for commercial or rental purposes. No other
warranty beyond that specifically set forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic
loss, loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation
or other consequential damages or whatsoever natures. Some states do not allow the exclusion or
limitation of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the
above limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights which vary from state to
state. Register on-line www.impex-fitness.com
®
IMPEX INC.
14777 Don Julian
City of Industry, CA 91746
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-
8899 during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
12
Download from Www.Somanuals.com. All Manuals Search And Download.
|