Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly, operating,
inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual
near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and
the receipt in a safe and dry place for future reference.
10 Ft. x 20 Ft.
All-PurposeCanopy
Vehicle not included.
ITEM 69034
Email our technical support at: [email protected]
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-800-444-3353 as soon as possible.
©
®
Copyright 2012 by Harbor Freight Tools . All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein.
Tools required for assembly and service may not be included.
Read this material before using this product.
Failure to do so can result in serious injury.
SAVE THIS MANUAL.
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
Assembly Precautions
1. Do not assemble in windy conditions.
5. Keep assembly area clean and well lit.
2. Assemble and install only on
6. Keep bystanders out of the area during assembly.
flat, level, hard surface.
7. Do not assemble when tired or when under
the influence of drugs or medication.
3. Assemble and anchor only according to
these instructions. Improper assembly or
inadequate anchoring can create hazards.
8. Product capabilities apply to properly and
completely assembled product only.
4. Wear ANSI-approved safety goggles and
heavy-duty work gloves during assembly.
Use Precautions
1. Do not use grill or any other type of
fire under cover. Cover may catch fire
if exposed to heat rising from fire.
5. Use as intended only.
Do not use for long-term shelter.
6. Inspect regularly, tighten all loose hardware and
loose cords, and secure all loosened anchors.
If any parts are damaged, bent, or stretched, they
must be replaced. Hardware may loosen during
normal operation stresses. Loose hardware
or damaged/altered parts will compromise
the structural integrity of this product.
2. Do not allow snow or debris to
accumulate on this item.
3. Heavy, wet snow or strong wind could cause
damage or sudden collapse. Remove the Cover
when these or similar conditions are expected.
4. This product is not a toy. Do not allow
children to play with or near this item.
7. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
SAVE THESE INSTRUCTIONS.
Specifications
Center Height
Side Height
9′ 3″
6′ 3″
Item 69034
For technical questions, please call 1-800-444-3353.
Page 3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Do not leave this product partially assembled. Assemble this product completely at one time.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts List and Diagram on page 10.
Note: Much of this product’s assembly is done using slip fit construction. Make sure all parts seat completely
and securely. A rubber mallet (sold separately) can be used to gently tap parts in place to ensure a tight fit.
5
2
4
2
6
2
4
2
5
2
2
3
2
3
5
2
3
4
2
5
6
2
4
2
Figure 1: Roof Assembly - 1
1. Assemble one half of the roof using 11x Swaged Tubes (2), 3x Rafter Tubes (3),
4x Straight Cross Tubes (4), 4x 3-Way Connectors (5), and 2x 4-Way Connectors (6).
Align the 3- and 4-Way Connectors so that the free ends are all on the
same side of the assembly, as shown in Figure 1.
5
6
5
2
2
2
3
2
3
5
2
4
3
6
2
4
2
Figure 2: Roof Assembly - 2
5
2. Connect a Swaged Tube (2) to each 3- and 4-Way Connector (5,6) at the top of the roof.
Connect a Rafter Tube (3) to the end of each Swaged Tube (2).
Connect 4x Swaged Tubes (2), 2x Straight Cross Tubes (4), 2x 3-Way Connectors (5), and
1x 4-Way Connector (6) together, then attach that assembly to the ends of the Rafter Tubes (3).
Page 4
For technical questions, please call 1-800-444-3353.
Item 69034
Download from Www.Somanuals.com. All Manuals Search And Download.
eyelet
straps
9
Figure 3: Roof Tarp (9)
3. Place the Roof Tarp (9) over the top of the roof assembly with its eyelet straps facing down, on the inside.
Figure 4: Connecting Ball Tie-downs (10)
4. Use the Ball Tie-downs (10) to attach the Roof Tarp to the tubes using the eyelets on the eyelet straps.
5
6
5
1
1
warning
label
1
1
0
f
t
ft
Portxa2b0le
Car Canopy
W
ARNING
T
o
p
r
e
v
e
n
t
s
e
r
i
o
u
s
i
n
j
u
r
y
,
property damage,
and collapse:
1
.
D
O
N
O
T
U
S
E
I
N
HIGH WIND. Remove
cover if harsh weather
or heavy rain threatens.
2. Do not allow snow
rainwater or debris
to accumulate or
pool on shelter
,
,
.
3. Anchor securely to flat,
level, solid surface able
to support shelter and
vehicle according to
m
a
n
u
a
l
i
n
s
t
r
u
c
t
i
o
n
s
.
2
4. Inspect before assembly
and every use; do not
assemble or use if parts
loose or damaged.
5. Wear ANSI-approved
safety goggles,
heavy-duty work gloves,
and hard hat during
assembly and service.
6. Read manual before
assembly and/or use.
M
a
d
e
i
n
C
h
i
n
a
.
1
2
a
I
T
E
M
6
9
0
3
4
D
O
N
O
T
R
E
M
O
V
E
.
2
2
Figure 5: Leg Assembly - 1
5. Attach a Straight Tube (1) to each 3- and 4-Way Connector (5, 6) on one side of the assembly.
Note: The warning label is on one of the Straight Tubes (1).
Turn that Tube so that the Warning label can be read easily.
Attach a Swaged Tube (2) to the bottom of each Straight Tube.
Item 69034
For technical questions, please call 1-800-444-3353.
Page 5
Download from Www.Somanuals.com. All Manuals Search And Download.
5
6
1
2
5
1
2
1
2
Figure 6: Leg Assembly - 2
6. Attach a Straight Tube (1) to each 3- and 4-Way Connector (5, 6) on the other side of the assembly.
Attach a Swaged Tube (2) to the bottom of each Straight Tube.
8
8
7
8
7
8
7
8
7
7
8
7
Figure 7: Foot Plate (8) Assembly
7. Place a Foot Plate (8) over the bottom of each Swaged Tube (2).
Use two Base Fastening Stakes (7) through each Foot Plate to anchor the Canopy.
Note: Verify that there are no utility lines nearby before driving anchors.
Page 6
For technical questions, please call 1-800-444-3353.
Item 69034
Download from Www.Somanuals.com. All Manuals Search And Download.
11
b
a
Figure 8: Securing Tarp Corner Hook (11)
8. For each corner of the Roof Tarp (9)
a. Connect the Tarp Corner Hook (11) to the hole on the inside corner of the Straight Tube (1).
b. Pull the end of the Rope snug and tie it off.
Figure 9: Rope Fastening Stakes (12)
9. Drive a Rope Fastening Stake (12) about 3 feet away from each corner of the canopy, angled inward.
Tie a Rope (13) around the 3-Way Connector (5) at each corner of the Canopy, then attach it to the Stake (12).
Note: Verify that there are no utility lines nearby before driving anchors.
Item 69034
For technical questions, please call 1-800-444-3353.
Page 7
Download from Www.Somanuals.com. All Manuals Search And Download.
Maintenance
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM PRODUCT FAILURE:
Do not use damaged products. If damage is noted, have the problem corrected before further use.
MONTHLY, inspect the general condition of the Portable Garage. Check for:
• loose ratchet tie downs, anchors, tube connections, and rail clamps (tighten as needed),
• torn or frayed covers, ropes, or cables,
• cracked, bent, or broken parts, and
• any other condition that may affect its safe operation.
Page 8
For technical questions, please call 1-800-444-3353.
Item 69034
Download from Www.Somanuals.com. All Manuals Search And Download.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only,
and are not available individually as replacement parts.
Item 69034
For technical questions, please call 1-800-444-3353.
Page 9
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts List and Diagram
Parts List
Note: Individual part illustrations not to scale.
Part
Description
Illustration
Qty
1
39″ Straight Tube
40 1/4″ Swaged Tube
24″ Rafter Tube
40 5/8″ Straight Cross Tube
3-Way Connector
4-Way Connector
Base Fastening Stake
Foot Plate
6
2
3
4
5
6
7
8
9
24
6
6
6
3
12
6
Roof Tarp
1
10 Ball Tie-down
20
4
11 Tarp Corner Rope and Hook
12 Rope Fastening Stake
13 Rope
4
4
Page 10
For technical questions, please call 1-800-444-3353.
Item 69034
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly Diagram
9
11
10
5
2
4
2
2
6
2
4
2
2
5
3
2
3
5
2
4
2
1
2
4
5
1
2
2
2
6
4
2
2
1
4
2
1
2
5
1
1
2
2
2
7
8
12
Item 69034
For technical questions, please call 1-800-444-3353.
Page 11
Download from Www.Somanuals.com. All Manuals Search And Download.
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards,
and warrants to the original purchaser that this product is free from defects in materials and workmanship for the
period of 90 days from the date of purchase. This warranty does not apply to damage due directly or indirectly,
to misuse, abuse, negligence or accidents, repairs or alterations outside our facilities, criminal activity, improper
installation, normal wear and tear, or to lack of maintenance. We shall in no event be liable for death, injuries
to persons or property, or for incidental, contingent, special or consequential damages arising from the use of
our product. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation of exclusion may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation charges
prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise.
If our inspection verifies the defect, we will either repair or replace the product at our election or we may
elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will
return repaired products at our expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353
Download from Www.Somanuals.com. All Manuals Search And Download.
|