MODEL H0581
3
⁄
4" HEAVY-DUTY
AIR IMPACT WRENCH
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 150 PSI!
Personal injury could
occur.
Figure 1. Model H0581.
SHATTERING HAZARD!
Use sockets rated for
impact wrench use only.
The impact wrench MUST have 6-8 drops of air
tool oil directly dropped into the air fitting before
each use. For best results, use the automatic oiler
setup shown in Figure 2.
Introduction
•
•
•
•
•
•
•
Operates at 90 PSI
12 CFM air consumption
1/4" air inlet
Quick
Quick
Connector
Lubricator
Regulator
3800 RPM no load speed
900 ft/lbs maximum torque
Weighs 12 lbs
Connector
Your
Tool
Air
Compressor
95 db sound level
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Inventory
3
A.
⁄4" Industrial Impact Wrench ...................... 1
Figure 2. Installing your tool.
Operation
Install any ⁄4" drive socket onto your impact
wrench. Choose from clockwise (R) to tighten,
or counterclockwise (L) to loosen by pushing the
direction valve (Ref # 47) in or out. Adjust the
torque with the direction valve knob. One (1) is the
highest setting, six (6) is the lowest.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
3
COPYRIGHT © JUNE, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8336 PRINTED IN TAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|