MODEL H6193
1
⁄
4" INDUSTRIAL
DIE GRINDER
INSTRUCTION SHEET
EyE/EAR INJURy HAzARD!
Wear safety glasses and
hearing protection during
use of this tool!
INJURy HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXpLOSION HAzARD!
Never exceed 90 pSI! Always
use accessories with correct
speed rating.
Figure 1. Model H6193.
RESpIRATORy HAzARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
Die Grinder MUSt have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in Figure 2.
Introduction
No load speed is 22,000 RPM and collet size is 1⁄4".
Requires a maximum of 90 PSI with a minimum of
4 CFM compressor capacity. Air inlet is 1⁄4" and air
exhaust is in the front. Weighs 1.2 lbs.
Inventory
A. Die Grinder................................................. 1
B. Wrenches ................................................... 2
Figure 2. lubricating directly into air fitting.
If you need help with your new pneumatic tool, call
our Tech Support at: (570) 546-9663.
Operation
Insert your 1⁄4" shank tool into the collet. Using the
two wrenches, secure tool by tightening the collet
against the spindle.
CoPyRIGHt © FebRUARy, 2006 by GRIzzly INDUStRIAl, INC. RevISeD SePteMbeR, 2009 (bl)
WARNING: NO pORTION OF THIS MANUAL MAy BE REpRODUCED IN ANy SHApE
OR FORM WITHOUT THE WRITTEN AppROvAL OF GRIzzLy INDUSTRIAL, INC.
#PC8031 PRINteD IN tAIWAN
Download from Www.Somanuals.com. All Manuals Search And Download.
|