Mounting Instructions for Model 6370C Parallel Power Kit
For Honda E3000i Generators Only
Thank you for purchasing this Parallel Power Kit. Do not return this product
to the store! If any parts are missing or damaged, please contact us toll free
intended for use with two Honda EU3000i generators ONLY. Do NOT attempt
to parallel two unlike generators! For 125 Volt Use Only.
TOOLS NEEDED FOR ASSEMBLY:
10 mm socket wrench or nut driver
11/32 nut driver
HARDWARE INCLUDED:
(2) 8/32 Nylok nuts
(2) M6-35 Standoffs
Configuration of receptacle
50 amps, 125 V
(L6377)
1
2
STEP 2
STEP 1
Mount Parallel Power Kit mounting plate on two bottom
NEVER connect Parallel Power Kit while generator is
running! Using the 10 mm socket wrench, remove the four
(4) cap nuts on the end of the generator, and set aside.
studs, and reattach bottom two cap nuts loosely.
3
4
STEP 4
Attach support bar with recesses over the standoffs.
Reattach the remaining two cap nuts over the standoffs,
and hand tighten. Then attach two Nylok nuts onto the
studs protruding from the mounting plate to secure the
support bar. Tighten all nuts moderately using a tool.
STEP 3
Insert two standoffs into the two upper holes, and
hand tighten.
Download from Www.Somanuals.com. All Manuals Search And Download.
|