v 1.0
MARINE ACTIVE SUBWOOFER
MS-AB108
SPECIFICATIONS
MAX POWER RATING
FREQUENCY RESPONSE
LOW PASS FILTER (VARIABLE)
TUNING
INSTALLATION
» Make sure the Marine Active Enclosure is firmly secured.
» Check before drilling or cutting holes.
210 Watts
30Hz – 250Hz
» DO NOT work near gas tanks, fuel lines, hydraulic lines or electrical
wiring.
» DO NOT mount the Marine Active Enclosure in such a way as to pinch
or damage the wires.
» Make sure everything is firmly connected, before attaching the +12V
wire. Make sure the +12V wire is fused as close as possible to the
battery. ALWAYS use a fuse with the recommended rating.
30Hz – 250Hz
Bass Reflex
WOOFER SIZE
8” down firing
10 Amp
FUSE
DIMENSIONS
Length 515mm - 20 1/4”
Width 233mm - 9 3/16”
Height 190mm - 7 1/2”
(Wiring diagram on reverse)
PRODUCT CONTENTS
1x MS-AB108 Active subwoofer
1x Power / GND/ Remote-ON wire loom
1x RCA Cable
Mounting Hardware
Manual
RECORD YOUR PURCHASE DETAILS HERE:
MODEL NUMBER
Warranty Card
DATE OF PURCHASE
CONTROL DESCRIPTIONS
LEVEL
AFFIX RECEIPT HERE
This allows the adjustment of the amplifier input level. Turn clockwise to
increase the level. If the sound becomes distorted reduce the level.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Marine Active
Enclosure will produce.
This should be adjusted to blend with your main speakers. Typically, this
will be set to around 100Hz (approximately the central position of the
control knob).
WARNING! Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB may cause permanent hearing loss!
PUBLISHED BY FUSION ELECTRONICS LIMITED: © Copyright 2009 by FUSION Electronics Limited. All rights reserved. Specifications and design are subject to change without notice.
YOU CAN HELP PROTECT THE ENVIRONMENT! Please remember to respect the local regulations: Hand in the non-working electrical equipment to an appropriate waste disposal center.
Download from Www.Somanuals.com. All Manuals Search And Download.
|