™
Monogram.
ZBD4500DSS - GE Monogram Built-In Dishwasher
Dimensions and Specifications (in inches)
24"
Design Information: Designed for versatility, these dishwashers adapt
to virtually any installation. This dishwasher is supplied as a stainless
steel model.
4 1/2"
To achieve a custom flush appearance, standard 24" base cabinets
should be moved forward by use of spacer blocks.
Optional Kits:
• GPF53 Mounting Kit-Special brackets for installing dishwasher
beneath countertops of stone or other materials which will not
accept screws.
34" Min.
35" Max.
Additional Specifications: A 120 Volt, 60 Hz power supply is required
when using a power cord, an individual properly grounded branch
circuit protected by a 15 or 20 amp circuit breaker or time delay fuse is
recommended. Install a 3-prong electrical receptacle at least 6" above
the floor and within 18" of the right or left adjacent cabinet wall.
Otherwise wiring must enter the cutout in shaded area shown. A double,
side-by-side installation requires two separate circuits.
4"
25"
(Including 1/4"
Rear Insulation)
24 3/4"
The hot water line must enter the cutout in the shaded area from the
right, left, rear or through the floor. The water line should be 3/8" O.D.
copper or 1/2" O.D. plastic. Installation of an easily accessible hand
shut-off valve is strongly recommended.
The dishwasher should be placed no more than 10 feet from the sink for
proper drainage.
For a corner installation, allow 2” clearance between dishwasher and
adjacent cabinet or wall.
Toekick
3 1/4"
This Wall Area
must be Free of
Pipes or wires
24"
Min.
4"
34-1/2"±1/4"
Underside of
Countertop
to Floor
5"
5"
4"
®
For answers to your Monogram,
GE Profile Performance Series,
Plumbing and Electric Services
Must Enter Inside This Area
™
Cabinets
Square
and Plumb
GE Profile™ or GE appliance questions, call
GE Answer Center® service, 800.626.2000.
6"
24"
Min.
Listed by
Underwriters
Laboratories
R
Specification Revised 10/99
Download from Www.Somanuals.com. All Manuals Search And Download.
|