Fisher Price Motorcycle T6197 User Manual

T6197  
Please keep this instruction sheet for future reference, as it contains important information.  
Adult assembly is required. Tools required for assembly:  
Phillips Screwdriver, Hammer and Scrap Block of Wood (not included).  
Requires three "AA" batteries (included).  
Age: 2-6 years.  
Weight limit: 60 lbs (27 kg).  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Rear Wheel  
(Indented Side Up)  
Cap Nut  
Hubcap  
(Peg Side Down)  
Cover  
Straight Axle  
Frame  
Hubcap  
Rear Wheel  
(Indented Side Down)  
Hubcap  
(Peg Side Up)  
Assembled  
Rear Wheel  
Straight Axle  
Scrap Block  
of Wood  
Cap Nut  
Assembly Tool  
3
1
Turn the frame on its side with the exposed end of the  
straight axle up.  
• Place the cap nut assembly tool under the assembled rear  
wheel and onto the cap nut.  
• Slide a hubcap (peg side up) onto the straight axle.  
• Slide a rear wheel (indented side down) onto the  
straight axle.  
• Slide a rear wheel (indented side up) onto the end of the  
straight axle.  
Frame  
• Slide a hubcap (peg side down) onto the straight axle.  
• Place a cap nut on the end of the straight axle. Tap the  
cap nut with a hammer. Gently pull the rear wheel up  
to be sure the cap nut is securely attached to the  
straight axle.  
• Insert one of the tabs on a cover into a slot in the hubcap.  
Push to snap the cover into place. Repeat this procedure  
to attach the other cover to the other hubcap.  
Hole  
Hole  
Pedal Hub  
Tab  
Pedal Axle  
Tab  
Slot  
Straight Axle  
Pedal Hub  
2
4
BOTTOM VIEW  
• Fit two pedal hubs onto the pedal axle tabs. Make sure the  
tabs fit into the slot in each pedal hub.  
Turn the frame upside down.  
• Insert the straight axle through the holes in the rear of  
the frame.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Pedal Hubs  
Pedal  
Pedal Axle  
Front Wheel  
Pedal Axle  
Hole  
5
Scrap Block of Wood  
• While holding the pedal hubs  
on the pedal axle, insert the  
pedal axle through the hole in the center of the front wheel.  
• Push the pedal hubs into the center of the front wheel until  
they are flush with the surface of the front wheel.  
7
• Fit the pedal on the pedal axle. Tap the pedal with  
a hammer until it is secure.  
• Pull the pedal up to be sure it is secure. If you can remove  
it, you have not secured it properly. Tap it with the  
hammer again.  
Pedal Hub  
Fork Arms  
Fork Cover  
Pedal Hub  
Groove  
8
6
Pedal Axle  
• Place the front wheel assembly between the fork arms.  
Make sure the pedal axle fits into the groove at the bottom  
of each fork arm.  
• Place a fork cover over the pedal axle on one fork arm.  
• Insert two #8 x 3/4" screws into the fork cover and tighten.  
Turn the front wheel  
assembly over.  
• Insert the remaining pedal hubs on top of and below the  
pedal axle and into the hole in the center of the front wheel.  
• Push the pedal hubs into the center of the front wheel until  
they are flush with the surface of the front wheel.  
• Repeat this procedure to attach the other fork cover to the  
other fork arm.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
Assembly  
Handlebar  
Basket Mount  
Frame  
Neck  
Fork  
Post  
11  
Fork Cover  
Rear of Trike  
• Fit the basket mount onto the front of the handlebar.  
• Insert four #6 x ½" screws into the holes and tighten.  
9
• Insert the fork post up through the hole in the neck of the  
frame. Make sure the fork is positioned so that the fork  
covers face the rear wheels.  
• Place the handlebar onto the fork post and push it down  
onto the frame. Make sure the handlebar is positioned so  
that the screw hole faces the rear wheels and aligns with  
the screw hole in the fork post.  
Basket  
Hint: You may need to rotate the handlebar to align the holes.  
• Insert the #8 x 3" screw through the hole in the handlebar  
and into the fork post so that part of the screw (about 3/4")  
is still visible. Tighten the screw.  
Cap  
12  
• Fit the basket on the tab on the front of the handlebar assembly.  
• Insert two #8 x ¾" screws into the top of the basket  
and tighten.  
Seat Retainer  
Seat  
10  
• Insert and “snap” the cap into the hole in the frame.  
Peg  
Holes  
13  
• Position the seat upside down.  
• Fit the small pegs on the seat retainer into the holes in  
the seat.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Label Decoration  
Attaching the Seat  
Hint: The seat can be attached to the frame in any of three  
positions, depending on the size of your child. Check  
your child’s fit on the trike by observing the seat to pedal  
distance, as it is being ridden. If the pedals seem too far  
away or too close for your child, move the seat up or down.  
(Place label 9 on  
opposite side)  
12  
8
(Place label 13 on  
opposite side)  
Seat  
Tabs  
14  
(Place label  
15 on opposite  
side of seat)  
Seat  
Retainer  
2
6
10  
(Place  
label  
11 on  
opposite  
side)  
Slots  
7
(Place label 3 on  
opposite side)  
1
(Place remaining label 1’s on  
opposite side of front wheel)  
SIDE VIEW  
Middle Position  
Lower Position  
Upper Position  
• At an angle, insert the tabs on the seat into any of the top  
three sets of slots for the lower, middle or upper position.  
• Lower the seat so that the seat retainer inserts and snaps  
into the slots in the frame.  
• Pull up on the seat to be sure it is secure.  
4
5
DASH VIEW  
• Make sure the areas where the labels will be applied are  
clean and dry. Wipe your vehicle with a clean, soft, dry  
cloth to remove any dust or oils.  
• For best results, avoid applying a label more than once.  
• Apply the labels as shown in the illustration above.  
• After applying the label, rub the label firmly with a cloth to  
make sure the label is adhered to your vehicle.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Battery Replacement  
For best performance, we recommend replacing the batteries that  
came with this trike with three, new alkaline "AA" (LR6) batteries.  
Battery Compartment  
Basket  
3
1,5V x 3  
AA(LR6)  
1
Hint: When sound or lights become faint or stop, it's time  
for an adult to replace the batteries. We recommend the  
use of alkaline batteries for longer battery life.  
• Loosen and remove the two screws in the basket.  
Remove the basket.  
• Loosen the screw in the battery compartment door. Open  
the battery compartment door.  
Basket Mount  
• Insert three "AA" (LR6) alkaline batteries.  
• Close the battery compartment door and tighten the screw.  
• Replace the basket mount and basket. Replace the screws  
and tighten.  
• If this product begins to operate erratically, you may need  
to reset the electronics. Slide the power switch off and then  
back on.  
• Protect the environment by not disposing of this  
product with household waste (2002/96/EC).  
Check your local authority for recycling advice  
and facilities (Europe only).  
Battery Safety Information  
In exceptional circumstances, batteries may leak fluids that can  
cause a chemical burn injury or ruin your product. To avoid  
battery leakage:  
• Do not mix old and new batteries or batteries of different  
types: alkaline, standard (carbon-zinc) or rechargeable  
(nickel-cadmium).  
2
• Then, loosen and remove the four screws from the basket  
mount. Remove the basket mount.  
• Insert batteries as indicated inside the battery compartment.  
• Remove batteries during long periods of non-use. Always  
remove exhausted batteries from the product. Dispose of  
batteries safely. Do not dispose of this product in a fire.  
The batteries inside may explode or leak.  
• Never short-circuit the battery terminals.  
• Use only batteries of the same or equivalent type,  
as recommended.  
• Do not charge non-rechargeable batteries.  
• Remove rechargeable batteries from the product  
before charging.  
• If removable, rechargeable batteries are used, they are  
only to be charged under adult supervision.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
Removing the Seat  
Consumer Information  
Seat  
CONSUMER ASSIS
TANCE  
1-800-432-5437 (US & Canada)  
1300 135 312 (Australia)  
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.  
Hearing-impaired consumers: 1-800-382-7470.  
Seat Retainer Tab  
Outside the United States:  
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,  
Great Britain: Mattel UK Ltd, Vanwall Business Park,  
Maidenhead SL6 4UB. Helpline: 01628 500303.  
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.  
Australia: Mattel Australia Pty. Ltd., 658 Church Street,  
Locked Bag #870, Richmond, Victoria 3121 Australia.  
New Zealand: 16-18 William Pickering Drive,  
Albany 1331, Auckland.  
Frame  
Care  
Seat Retainer Tab  
• Check the plastic parts regularly and if broken or cracked,  
dispose of them properly.  
• Check all fasteners regularly to be sure they are tight. If the  
fasteners are not tight, tighten them as necessary.  
To clean, use a mild soap and water solution and a clean  
cloth. Rinse clean with water to remove soap residue.  
Turn the frame on its side.  
• Squeeze the seat retainer tabs toward one another and lift  
the seat from the frame.  
FCC Statement (United States Only)  
This equipment has been tested and found to comply with  
the limits for a Class B digital device, pursuant to Part 15 of  
the FCC Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential installation.  
This equipment generates, uses and can radiate radio frequency  
energy and, if not installed and used in accordance with  
the instructions, may cause harmful interference to radio  
communications. However, there is no guarantee that interference  
will not occur in a particular installation. If this equipment does  
cause harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the user  
is encouraged to try to correct the interference by one or more of  
the following measures:  
Let's Go!  
IMPORTANT! It is good practice to start training children very  
young regarding the importance of helmet use. When children  
are older and riding bicycles and faster vehicles, it is important  
that they use a helmet each and every time they ride. For this  
reason, even while riding a tricycle, it is a good idea to familiarize  
your child with helmet use, so that it becomes a habit for life.  
Choose a helmet that complies with requirements of the  
applicable certifying agency for bicycle helmets.  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Consult the dealer or an experienced radio/TV technician for help.  
Note: Changes or modifications not expressly approved by the  
manufacturer responsible for compliance could void the user’s  
authority to operate the equipment.  
Music  
Weather  
Places  
to Go  
Ignition  
This device complies with Part 15 of the FCC Rules. Operation  
is subject to the following two conditions: (1) this device may  
not cause harmful interference and (2) this device must accept  
any interference received, including interference that may cause  
undesired operation.  
ICES-003  
Sounds  
This Class B digital apparatus complies with Canadian ICES-003.  
• Operation is subject to the following two conditions: (1) this  
device may not cause harmful interference and (2) this device  
must accept any interference received, including interference  
that may cause undesired operation.  
Power Switch  
Turn Signal  
Turn Signal  
NMB-003  
Horn  
• Cet appareil numérique de la classe B est conforme à la norme  
NMB-003 du Canada.  
Lutilisation de ce dispositif est autorisée seulement aux  
conditions suivantes : (1) il ne doit pas produire de brouillage  
et (2) l’utilisateur du dispositif doit être prêt à accepter tout  
brouillage radioélectrique reçu, même si ce brouillage est  
susceptible de compromettre le fonctionnement du dispositif.  
• Slide the power switch ON.  
Turn the ignition, “VRROOOM!”  
• Press the left or right turn signals for flashing blinkers.  
• Press any of the buttons for fun sounds!  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  

Edelbrock Automobile Parts Big Block Chevy User Manual
Euro Pro Frozen Dessert Maker KP160E User Manual
Exmark Lawn Mower 4500 450 User Manual
FieldServer Computer Drive FS 8700 19 User Manual
FireplaceXtrordinair Indoor Fireplace 36A BI User Manual
Fisher Price Motorized Toy Car 78537 User Manual
Frigidaire Microwave Oven FFCE1431LW User Manual
Garrett Metal Detectors Radar Detector 1140070 User Manual
GE Microwave Oven JES1143 User Manual
Goodman Mfg Heat Pump SS GSH10C User Manual