Parts
Brace
Artist’s Tray
Easel Board
Cap
Storage Tray
Back Panel
2 Accessory Bins
2 Handles
2 Legs
2 Clips
Parts Not Shown
6 Dry-Erase Markers
3
"
)
#6 x /4 (1.9 cm Chrome Screw – 21
(Assembly steps 1, 4, 8, 10, 12 and 16)
2 Scene Starter Backgrounds
5 Color-By-Sound Activity Pages*
12 Magic-Sound Magnets
2 Magic-Sound 3D Models
"
)
#8 x 1 (2.5 cm Gold Tone Screw – 10
(Assembly steps 5, 7 and 14)
* Additional color-by-sound activity
pages sold separately and subject
to availability.
Both Shown Actual Size
Note: Tighten and loosen all screws with a
Phillips screwdriver. Do not over-tighten.
Inspiration Pod
with Pen
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Clips
Easel Board
Handles
1
2
• Turn the easel board upright.
• “Snap” both clips to the front side of the easel board.
• Place the easel board face down.
• Fit the handles to the grooves in each side of the
easel board.
• Insert two #6 x 3/4” chrome screws into each handle
and tighten.
Artist’s Tray
Legs
Storage Tray
5
6
• Position the storage tray between the legs, as shown.
• Fit the pegs on the storage tray into the holes in the legs.
• Insert two #8 x 1” gold tone screws through each leg and
into the storage tray. Tighten the screws.
• Fit the pegs on the artist’s tray into the holes in the legs.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Cap
4
3
• Place the easel board face down again.
• Fit the cap to the top of the easel board.
• Make sure the tab on each end of the cap fits into the slots
in the top of the easel board.
• Insert five #6 x 3/4” chrome screws into the easel board
and tighten.
• Set the easel board assembly aside.
7
8
• First, insert two #8 x 1” gold tone screws through each leg
and into the artist’s tray. Tighten the screws.
• Then, insert two #6 x 3/4” chrome screws through the
artist’s tray and into each leg. Tighten the screws.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
C
Turn
Brackets
Easel Board
C
Bracket
B
Lift
B
Lift
Column
Column
A
Press
Button
A
Press
Button
Bracket
9
10
• Position the easel board upright.
• Fit the easel board to the brackets.
A
• Press the button on each leg
.
• Grasp the column inside each leg and lift to the highest
• Insert two #6 x 3/4” chrome screws into each bracket
B
position
.
and tighten.
• While holding the columns in place, turn the brackets until
C
they “click” into position
.
13
14
Brace
• Insert two #8 x 1” gold tone screws though each leg and into
the brace. Tighten the screws.
• With the ribbed side facing you, fit the brace to the legs.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Assembly
Back Panel
Tabs
B
A
A
12
11
• Position the back panel with ribbed side facing you and the
tabs at the top.
• Insert four #6 x 3/4” chrome screws into the back panel
and tighten.
• First, fit the bottom edge of the back panel into the slot in the
A
B
legs . Then, fit the back panel tabs onto the columns
.
Hooked
Tab
Slot
Accessory
Bin
Accessory
Bin
15
16
• Insert two #6 x 3/4” chrome screws into the artist’s tray and
each accessory bin. Tighten the screws.
• Fit the hooked tab on each accessory bin into the slot in
each leg.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation
1.5V x 3
"AA" (LR6)
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that
can cause a chemical burn injury or ruin your product. To
avoid battery leakage:
• Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always
remove exhausted batteries from the toy. Dispose of
batteries safely. Do not dispose of the product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as
recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product
before charging.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Inspiration Pod
• Loosen the screws in the battery compartment door with a
Phillips screwdriver. Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer
battery life.
• Replace the battery compartment door and tighten
the screws.
• When sounds become faint or stop, it's time for an adult to
change the batteries!
• Protect the environment by not disposing of this
product with household waste (2002/96/EC). Check
your local authority for recycling advice and facilities
(Europe only).
Convert from Easel
Convert from
to Creativity Table
Creativity Table to Easel
B
B
C
A
D
A
• Fit your hands through the handles and press and hold both
• Fit your hands through the handles and squeeze the release
A
A
buttons under the easel board
.
levers
.
B
C
• Lift and turn the easel board until it “clicks” into the highest
• Turn the easel board down
• Lift the easel board slightly
.
B
position
.
D
and then lower it completely
.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
FCC Statement
Notes About
United States Only
Dry-Erase Markers
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential instal-
lation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Use only the dry-erase washable markers that came with
this toy.
• Dampen a soft cloth with water and wipe to clean the easel
board or backgrounds.
IMPORTANT!
• To completely remove marker residue from the easel board or
backgrounds, dampen the eraser and wipe after each use.
• Markers conform to ASTM D4236. Avoid contact with carpet,
clothing, walls and furniture. Do not use permanent markers
on the easel surface or dry-erase accessories. Recap
markers after use. Adult supervision is recommended.
• To remove marker from the skin, simply use soap and water.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician
for help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
Easel Height Adjustment
Easel Adjusts to Three Different Heights!
B
C
D
A
• Fit your hands through the handles and squeeze the
A
release levers
• Lift the easel board
• Lower the easel board until it “clicks” into the middle height
.
B
and let go of the release levers.
C
D
position
or the lowest height position
.
• To raise the easel board to a higher position again, simply
lift until it “clicks” into place.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Spark Imagination an
Use the Inspiration Pen on the easel, scene starter backg
color-by-sound activity pages to reveal interactive voice pro
Use the tip of the
pen to adjust volume
higher or lower.
Slide the power switch
on or off
.
Use the tip of the pen to “read” areas or objects
on scene starter backgrounds, magic-sound
magnets or magic-sound 3D models.
Create - Listen to fun sound effects.
Discover - Listen to items identified.
Use the tip of the pen to “read” areas or
objects on color-by-sound activity pages.
Create - Listen to coloring sug-
gestions or fun sound effects.
Discover - Listen to fun sound effects.
Select to hear draw-
ing suggestions.
Colors
Sounds
Objects
Repeat Last Sound
Adjust Volume
Optical reader technology lets
the Inspiration Pen “read” hidden
codes on dry-erase scene starter
backgrounds and more!
Note about color-by-sound activity pages: These pages
contain hidden codes that cannot be seen by copiers. Only
the original pages can be “read” by the Inspiration Pen.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
nd Inspire Creativity!
grounds, magic-sound magnets, magic-sound 3D models, or
ompts and sound effects that guide and encourage creativity!
Place magic-sound
magnets on the
easel board.
Slide scene starter back-
grounds, activity sheets or
regular drawing paper
under the clips.
Inspire with Color!
Inspire
with Sound Effects!
Use dry-erase markers
on the easel board or
scene-starter backgrounds.
Alphabet - Select a letter to hear
letter names and sounds or words
that begin with that letter.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Build the 3D Models
For countries outside the United States:
CANADA: Questions? 1-800-432-5437. Mattel Canada Inc., 6155 Freemont Blvd.,Mississauga, Ontario L5R 3W2; www.service.mattel.com.
GREAT BRITAIN: Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500303; www.service.mattel.com/uk
AUSTRALIA: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND: 16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China.
Fisher-Price, Inc., a subsidiary of Mattel, Inc. East Aurora, New York 14052, U.S.A.
©2006 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
K0026a-0920
PRINTED IN MEXICO
Download from Www.Somanuals.com. All Manuals Search And Download.
|
EAW Speaker MQ1312 User Manual
Echo Beverage Dispenser CS 330T User Manual
Electro Voice Microphone PL60 N D User Manual
Fellowes Chipper 72Ct User Manual
Fujitsu Printer DL6400 User Manual
Fusion Marine Sanitation System MS WR600C User Manual
Garmin GPS Receiver 182 182C User Manual
Garmin Marine GPS System 190 01219 00 User Manual
Gateway Computer Hardware E 6500 User Manual
Global Machinery Company Drill HD1400K User Manual