Extron electronic Network Card GMK 1 User Manual

GMK 1 • Installation Guide  
The Extron GMK 1 (see figure to the right) is an accessory for the  
SMB 1 kit and is used to mount the TLP Pro 320M or the TLP Pro 520M  
on a glass surface. This guide provides instructions for experienced,  
professional installers to mount and install either touchpanel using the  
GMK 1 and SMB 1 mounting kits.  
(4) Studs  
The GMK 1 is a flat plate with a powerful adhesive on one surface that  
bonds strongly to a glass surface. The opposite surface has four studs  
(one in each corner) for securing the SMB 1.  
ATTENTION: The installation shall be in accordance with the  
applicable provisions of National Electrical Code ANSI/NFPA 70,  
article 725 and the Canadian Electrical Code part 1, section 16.  
GMK 1  
Notch in shorter  
(bottom) edge  
NOTE: The diagrams in this guide show the TLP Pro 520M. The  
TLP Pro 320M is mounted in exactly the same way.  
Securing the GMK 1 to a Glass Surface  
1. Decide where the touchpanel will be placed and clean  
the surface of the glass with a 50:50 mixture of isopropyl  
alcohol and water.  
2. Use a level and apply painter tape to the glass to mark  
the position where the GMK 1 will be mounted.  
ATTENTION: The lower edge of the GMK 1 is the  
shorter edge with the notch.  
2
3. Remove the backing from the surface of the GMK 1 to  
Level  
expose the adhesive.  
4. Carefully align the lower edge of the GMK 1 with the  
tape from step 2. Hold the GMK 1 at a slight angle so  
that the adhesive does not come in contact with the  
glass until you are ready to press it into place.  
3
Remove Backing  
4
2
Align GMK 1  
with Painter Tape  
5
ATTENTION:  
Painter Tape  
Once the GMK 1 is attached to the glass, it  
is very difficult to remove. Align the GMK 1  
exactly where you need it before pressing it  
into place.  
If you need to remove the plate, slide a thin  
wire or use a fine tooth saw or other sharp  
cutting tool between the plate and the glass.  
Once the plate has been removed from the  
glass, it should not be reattached.  
5. Once aligned, angle the GMK 1 onto the glass and press  
firmly. If possible, allow the bond to set for 72 hours for  
maximum strength.  
CAUTION: The maximum load for the GMK 1  
must not exceed 5 lb (2.27 kg).  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  

Echo Paint Sprayer MS 41BP User Manual
Edelbrock Automobile Parts 1967 User Manual
Extron electronic Switch Extender Series User Manual
Fisher Price Motorized Toy Car L3938 User Manual
FoodSaver Food Saver V3860 Series User Manual
Franke Consumer Products Cooktop FMY 907 User Manual
Frigidaire Refrigerator FSC23F7DSB0 User Manual
FujiFilm Digital Camera Z33WP User Manual
Gateway Personal Computer E 6300 User Manual
Gianni Industries Door L NH300 User Manual