EverFocus Security Camera EI350 User Manual

EVERFOCUS  
1/3” 560 TVL Pure Vision Lens  
Integrated Color Camera  
Operation Instructions  
Model No. EI350  
Please read this manual first for correct installation and operation. This manual should be retained  
for future reference. The information in this manual was current when published. The  
manufacturer reserves the right to revise and improve its products. All specifications are therefore  
subject to change without notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,  
audio speakers since the magnetic fields generate from above devices will distort the video  
images.  
2. Never disassemble the camera nor put impurities in it.  
Disassembly or impurities may result in trouble or fire.  
3. Never face the camera toward the sun.  
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.  
4. Keep the power cord away from water and liquid.  
Touching the wet power cord may result in electric shock.  
5. Never install the camera in areas exposed to water, oil or gas.  
Water, oil or gas may result in failure, electric shock or fire.  
6. Cleaning  
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from  
the camera body. Use lens tissue or a cotton swab and ethanol to clean the sensor and the  
Download from Www.Somanuals.com. All Manuals Search And Download.  
SPECIFICATIONS  
Pickup Device  
Video Format  
1/3'' SONY Super HAD CCD  
NTSC or PAL  
NTSC: 525 TV lines, 60 fields/sec  
PAL: 625 TV lines, 50 fields/sec  
768 x 494(NTSC) ; 752 x 582(PAL)  
560TVL  
Scanning System  
Picture Elements  
Horizontal Resolution  
Sensitivity  
0.5Lux/F=1.2  
S/N Ratio  
Over 48dB(AGC off)  
1/50(1/60)~1/100,000  
Vari-focal lens, Auto Iris  
f=3.8~9.5mm, F=1.2  
ON/OFF Switch  
Electronic Shutter  
Lens Type  
Back Light Comp.  
Auto Gain Control  
Flickerless  
ON/OFF Switch  
ON/OFF Switch  
Auto White Balance  
Gamma Correction  
Video Output  
Yes  
0.45  
BNC 1.0Vp-p , 75ohm  
Line Lock/Internal Sync  
12VDC/24VAC  
Sync. Mode  
Power Source  
24VAC: 7.5VA max.  
Power Consumption  
12VDC: 4.5W max.  
66mm(W) x 59mm(H) x 146mm(D);  
2.56" (W) x 2.3"(H) x 5.7"(D)  
Dimensions  
Weight  
0.4kg ; 0.9lbs  
Aluminum, Dimension 145 (H) x 56.5 (O.D.) mm / 5.7"(H) x  
2.2(O.D); Max Load 3 kgs  
Mounting Bracket:  
Operating Temperature  
Service Kit:  
0°C~50°C ; 32°F~122°F(20%~80% Humidity)  
Mounting bracket x 1 pcs  
FCC/CE  
Certifications  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
DIMENSIONS  
USING SPECIAL FEATURES  
Lens adjustment  
You may adjust the focus and zoom of the lens to bring the object in focus.  
This lens has two focal distances. The change of Tele/Wide can be done with  
zooming. You could switch focus between Tele/Wide, by re-adjusting focusing once again.  
Back Light Compensation  
When BLC is turned on, the AGC, ES or IRIS operating point is determined by averaging  
over the center area instead of entire field-of-view, so that a dimly-lit foreground object at  
center area can be clearly distinguished from brightly-lit backgrounds.  
BLC should not be used unless it is needed to compensate for back-lit.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Back Panel  
1
2
3
5
4
1. Auto IRIS adjustment  
2. Function switcher  
Flickerless On/Off  
When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of  
electronic shutter at 1/100(NTSC) or 1/120(PAL) automatically, and reduce the flicker  
immediately.  
BLC (Back Light Compensation) Normal/On  
When BLC is turned on, the AGC, ES and IRIS operating points are determined by  
averaging over the center area instead of entire field-of-view, so that a dimly-lit foreground  
object at center area can be clearly distinguished from brightly-lit backgrounds.  
BLC should not be used unless it is needed to compensate for back-lit. The default setting is  
Normal.  
AGC (Automatic Gain Control) Off/On  
AGC ON: The sensitivity increases automatically when light is low.  
AGC OFF: A-low-noise picture is obtained under a low light condition.  
The default setting is ON.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
LL (Line-Lock) Off/On  
To select the sync mode between Internal Sync.(LL off) and Line-Lock (LL on).  
Set the line-lock off, the camera will synchronize to the internal time base. Set the line-lock  
on, the camera’s vertical synchronization can be driven by the AC signal in the power lines.  
The default setting is Off.  
Note: Line-Lock sync mode operation is possible only when used with an AC power  
source; it is not possible with a DC power source.  
3. Video output connector  
4. 12VDC/24VAC input terminal  
5. V Phase adjustment  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
INSTALLATION  
1. Connect the video output of the camera to a color monitor or other video device through a 75  
ohm type coaxial cable with BNC female connector at camera end.  
2. Plug the power cord to the outlet. Power indicator LED should light if the power source is  
properly connected.  
3. Remove the lens cover cap from the top of the camera for adjusting the vari-focal lens.  
4. Once the image appears on the monitor, adjust the focus and diaphragm of the lens to  
obtain the best picture.  
5. Mount the camera on the mounting bracket by using the mounting hole on the top and bottom  
of camera casing.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
EverFocus Electronics Corp.  
Europe Office:  
Head Office:  
Albert-Einstein-Strasse 1  
D-46446 Emmerich, Germany  
TEL: 49-2822-9394-0  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
FAX: +886-2-26982380  
China Office:  
Room B-05D-1, KESHI PLAZA , Shangdi  
Information Industry Base,  
USA L.A. Office:  
1801 Highland Ave. Unit A  
Duarte, CA 91010, U.S.A.  
TEL: +1-626-844-8888  
FAX: +1-626-844-8838  
Haidian District, Beijing China  
100085  
TEL: +86-10-62973336/37/38/39  
FAX: +86-10-62971423  
USA N.Y. Office:  
Japan Office:  
415 Oser Avenue Unit S  
Hauppauge, NY 11788  
TEL: 631-436-5070  
FAX: 631-436-5027  
1809 WBG MARIBU East 18F,  
2-6 Nakase.Mihama-ku.  
Chiba city 261-7118, Japan  
TEL: +81-43-212-8188  
FAX: +81-43-297-0081  
Your EverFocus product is designed and  
manufactured with high quality materials and  
components which can be recycled and  
reused.  
Ihr EverFocus Produkt wurde entwickelt und  
hergestellt mit qualitativ hochwertigen  
Materialien und Komponenten, die recycelt  
und wieder verwendet werden können.  
Dieses Symbol bedeutet, dass elektrische und  
elektronische Geräte am Ende ihrer  
Nutzungsdauer vom Hausmüll getrennt  
entsorgt werden sollen.  
This symbol means that electrical and  
electronic equipment, at their end-of-life,  
should be disposed of separately from your  
household waste.  
Please, dispose of this equipment at your  
local community waste collection/recycling  
centre.  
Bitte entsorgen Sie dieses Gerät bei Ihrer  
örtlichen kommunalen Sammelstelle oder im  
Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu erhalten, in  
der wir leben!  
In the European Union there are separate  
collection systems for used electrical and  
electronic product.  
Please, help us to conserve the environment  
we live in!  
P/N: MI35G00800_Ver.B  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  

Euro Pro Mixer EP585W User Manual
Extron electronic Network Card HSA 200 User Manual
Fender Stereo Amplifier 811 000X 010 User Manual
FilterStream Vacuum Cleaner V2210 User Manual
FireplaceXtrordinair Indoor Fireplace 95400411 User Manual
Frymaster Fryer UHC P 2 User Manual
Furuno Radar Detector FAR 2157 User Manual
GE Conference Phone 15 Feb User Manual
GE Microwave Oven JE1390 User Manual
GE Monogram Planer ZGG36N30YSS User Manual