GE Monogram Speaker ZIC360NR User Manual

ZIC360NR – GE Monogram 36" Built-In Bottom Freezer Refrigerator  
with Automatic Icemaker  
The Installation Space  
Door Swing Clearances  
The finished cutout width must be 35-1/2".  
The installation must allow for clearances to adjacent walls or cabinets.  
These refrigerators are equipped with a 2-position door stop. The  
factory-set 130° door swing can be adjusted to 90° if clearance to  
adjacent cabinets or walls is restricted.  
35-1/2"  
Finished Width  
Wall View  
2-5/16"  
10"  
25"  
Min. to  
Wall  
23-7/8"  
Behind  
Frame  
6"  
90° Door Swing  
130° Door Swing  
Electrical  
Area  
75" From  
Floor to Bottom  
of Electrical  
Area  
84-1/2" max  
83-1/2" min  
Finished  
24" Cutout Depth  
5"  
36-3/4"  
Opening  
5"  
Water Supply  
3 1/2"  
90°  
130°  
3 1/2"  
4" Min.  
to Wall  
The cutout depth must be 24"  
The refrigerator will project forward, slightly beyond adjacent cabinetry,  
depending on your installation.  
The cutout depth beneath a soffit  
When installed beneath a soffit, the soffit cannot exceed the 24"  
installation depth shown. The top case trim overlaps the bottom  
of the soffit.  
Allow 25" minimum clearances for a full 130° door swing. Allow 15"  
for pan removal.  
• 4" minimum clearance is required when the door swing is adjusted to  
90°. If the 90° door stop position is used, pan access is maintained,  
but pan removal is restricted.  
• See door swing illustrations to determine interaction with adjacent  
cabinets or countertops.  
Electrical  
A 115V, 60Hz., 15 or 20 amp power supply is required. An individual  
properly grounded branch circuit or circuit breaker is recommended.  
Install a properly grounded 3-prong electrical receptacle recessed  
into the back wall. Electrical must be located on rear wall as shown.  
ZUG2, ZUGSS2 Unified Grille Panel Kit  
• If you are installing two refrigerators side by side, the installation space  
must be 71-1/2" wide.  
Note: GFI (ground fault interrupter) is not recommended.  
Water Line  
All models are equipped with an automatic icemaker. The water line can  
enter the opening through the floor or back wall. Route GE SmartConnect™  
Kit or 1/4" O.D. copper tubing between the cold water line and the water  
connection location at the front of the refrigerator. The installation of an  
easily accessible shut-off valve in the water line is required.  
Note: Additional cutout width may be required when side panels are  
used. Add side panel thickness to the finished cutout to calculate  
rough-in width.  
• The water and electrical locations for each product must be located  
as shown.  
• A separate 115V, 60Hz., 15 or 20 amp power supply is recommended for  
each product.  
Product Dimensions  
71-1/2" Finished Width  
35"  
Case Width  
Case Depth:  
25-3/8" Framed Models  
25-3/4" Stainless Steel Models  
2-5/16"  
Wall View  
Electrical  
24-3/16"  
6"  
*Shipping Height. The  
refrigerator can be  
10"  
10"  
*84" From  
Floor to  
adjusted to fit into a  
cutout that is 83-1/2" min.  
to 84-1/2" max. height.  
The top case trim at the  
front is 1/2" higher and  
will overlap upper  
84-1/2" max  
83-1/2" min  
Finished  
24" Cutout  
Depth  
75" From  
Floor to Bottom  
of Electrical  
Area  
*83-1/2"  
at  
Top Frame  
Rear  
Opening  
5"  
5"  
Water Supply  
26"  
Water Supply  
26"  
cabinetry or soffit.  
3-1/2"  
3-1/2"  
36"  
Frame to Frame Width  
Use leveling legs and  
wheels for a maximum  
1" height adjustment.  
®
For answers to your Monogram, GE Profileor  
GE appliance questions, visit our website at  
GEAppliances.com or call  
Depth Including Handles:  
26-7/8" Framed Models  
Listed by  
Underwriters  
Laboratories  
27-3/4" Stainless Steel Models  
R
Specification Created 5/04  
GE Answer Center® service, 800.626.2000.  
110100  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ZIC360NR – GE Monogram 36" Built-In Bottom Freezer Refrigerator  
with Automatic Icemaker  
1/4" Framed Panel Dimensions  
3/4" Overlay Panel Dimensions  
If you choose to install framed panels,  
they must be cut to the dimensions  
shown. The panels will slide into the  
frame on the door, drawer and grille.  
For a more custom appearance, overlay  
panels may be installed on trimmed  
models. The overlay panel must be  
secured to a 1/4"-thick backer panel  
which slides into the trim. A spacer  
panel 0.10" thick must be placed  
5/16"  
Trim  
Door/Drawer  
Door/Drawer  
Reveal  
Overlay  
Panel  
If the custom panel is less than 1/4"  
thick, and it fits loosely in the door  
frame, it can be backed up with a  
piece of filler material or foam tape  
to improve the fit.  
1/4"  
Panel  
between the overlay and backer panel.  
Important Note: Maximum weight for  
fresh food panel is 50 pounds,  
30 pounds for freezer drawer panel  
and 11 pounds for the grille panel.  
1/4"  
Backer  
Panel  
.10"  
Spacer  
.250" + .10" + .750" =  
1.100" Total Panel Thickness  
Center each panel over  
the other. Assemble the  
panels with glue and  
screws. Screws must  
be countersunk into the  
backer panel.  
Overlay Panel  
A
Grille Panel  
B
C
Spacer Panel  
Backer Panel  
Fresh Food  
Panel  
NOTE: Left-to-right offset is not always equal to top-to-bottom offset.  
ZUG2 Grille Panel Dimensions  
The ZUG2 Unified Grille Panel Kit will accept a framed or overlay  
grille panel.  
Freezer Drawer  
Panel  
D
• Assemble the overlay panel in the same manner as the door and  
drawer panels.  
Framed Panel Dimensions (in inches)  
A (Width) B (Grille Ht.) C (FF Ht.) D (FZ Ht.)  
1/4" Framed Panel 33-7/8 8-7/8 46-1/16 21-7/8  
A
B
Grille Panel  
3/4" Overlay Panel Dimensions (in inches)  
A (Width) B (Grille Ht.) C (FF Ht.) D (FZ Ht.)  
Framed Panel Dimensions  
1/4" Backer Panel 33-7/8  
.10" Spacer Panel 32-1/2  
3/4" Overlay Panel 34-1/8  
8-7/8  
7-5/8  
9
46-1/16  
44-11/16  
46-5/16  
21-7/8  
20-1/2  
22  
A (Width)  
B (Height)  
8-7/8"  
1/4" Framed Panel  
69-7/8"  
Overlay Panel Dimensions  
A (Width)  
B (Height)  
8-7/8"  
7-5/8"  
9"  
1/4" Backer Panel  
.10" Spacer Panel  
3/4" Overlay Panel  
69-7/8"  
68-1/2"  
70-1/8"  
For answers to your Monogram, GE Profileor  
GE appliance questions, visit our website at  
GEAppliances.com or call  
®
Listed by  
Underwriters  
Laboratories  
R
Specification Created 5/04  
GE Answer Center® service, 800.626.2000.  
110100  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ZIC360NM – GE Monogram 36" Built-In Bottom Freezer Refrigerator  
with Automatic Icemaker  
Advance Planning for Built-In Custom Bottom-Freezer Refrigerators  
Use this page to determine door  
swing interaction with adjacent  
cabinets or countertops.  
Frameless Cabinets: The case trim overlaps cabinets at the top and sides.  
Therefore, frameless cabinets may require filler strips to prevent interference  
with cabinet door swing. The opening must allow for filler strips.  
Refrigerator  
23-7/8" From  
Rear of  
Refrigerator  
1"  
2"  
3"  
Case  
Trim  
3/4"  
1-3/4"  
1-1/2"  
1-1/4"  
2-3/4"  
2-1/2"  
2-1/4"  
1/2"  
1/4"  
1/4"  
1/2"  
3/4"  
1"  
3/4" Overlay  
Panel  
(Nominal Size)  
Door  
1/4"  
Top View  
1/2"  
3/4"  
130° Door Swing  
(Optional setting)  
Scale 1:1  
1"  
1-1/4"  
Listed by  
Underwriters  
Laboratories  
R
®
For answers to your Monogram, GE Profileor  
GE appliance questions, visit our website at  
GEAppliances.com or call  
GE Answer Center® service, 800.626.2000.  
Specification Created 5/04  
110100  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ZIC360NM – GE Monogram 36" Built-In Bottom Freezer Refrigerator  
with Automatic Icemaker  
Advance Planning for Built-In Custom Bottom-Freezer Refrigerators  
Use this page to determine door  
swing interaction with adjacent  
cabinets or countertops.  
Refrigerator  
Case Trim  
23-7/8"  
From Rear of  
Refrigerator  
Frameless Cabinets: The case trim  
overlaps cabinets at the top and sides.  
Therefore, frameless cabinets may require  
filler strips to prevent interference with  
cabinet door swing. The opening must  
allow for filler strips.  
1/4"  
1/2"  
3/4"  
1"  
1-1/4"  
1-1/2"  
Top View  
90° Door Swing  
(Optional setting)  
Scale 1:1  
Door  
3/4" Overlay  
Panel  
(Nominal Size)  
1/4"  
Listed by  
Underwriters  
Laboratories  
R
1/2"  
®
For answers to your Monogram, GE Profileor  
GE appliance questions, visit our website at  
GEAppliances.com or call  
3/4"  
1"  
GE Answer Center® service, 800.626.2000.  
Specification Created 5/04  
110100  
1-1/4"  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ZIC360NR – GE Monogram 36" Built-In Bottom Freezer Refrigerator  
with Automatic Icemaker  
Features and Benefits  
• 20.6 Cu. Ft. Capacity  
• Upfront electronic controls with digital readout  
• Multi-shelf air management tower  
• 2 Sealed, adjustable humidity vegetable/fruit pans with  
easy access lids and full extension slides  
• 2 Sealed deli pans with full extension slides  
• Adjustable spillproof glass cabinet shelves  
• Slide-out freezer compartment with full  
extension slides  
• Model ZIC360NRRH – Right-handed door swing  
(Door panels required)  
• Model ZIC360NRLH – Left-handed door swing  
(Door panels required)  
Specification Created 5/04  
110100  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Compaq Network Card CP 2E User Manual
Compaq Personal Computer 4103TH User Manual
CPG Printer PageMaster 402N User Manual
Craftsman Lawn Mower 9173875 User Manual
Creda Dishwasher IDI60 User Manual
Cub Cadet Lawn Mower 1105 292 User Manual
Cuisinart Blender 11 Cup Series User Manual
Curtis Car Stereo System RCD641 User Manual
Dimplex Thermostat MCN20 User Manual
Electro Voice Range P3000RL User Manual