WPC 160 A Series • Installation Guide
The Extron WPC 160 A EU and WPC 160 A MK are wall mounted plates that accept video, audio, and USB signals through one
female 15-pin HD connector, one 3.5 mm tip-ring-sleeve (TRS) connector, and one USB B connector. The signals pass through
the unit without modification and are output from the back via captive screw connectors. The captive screw connectors take wires
from 18 AWG (1.02 mm) to 26 AWG (0.40 mm).
The two form factors are shown in the figure
at right:
z
The WPC 160 A EU (left) mounts
onto 80 mm one-gang European
EU junction boxes. The plate is
3.1 inches x 3.1 inches
COMPUTER
AUDIO
COMPUTER
AUDIO
(81 mm x 81 mm).
USB
USB
z
The WPC 160 A MK (right) mounts
onto MK type one-gang UK
electric junction boxes. The plate is
3.35 inches x 3.35 inches
WPC 160 EU
(85 mm x 85 mm).
WPC 160 MK
WPC 160 EU
WPC 160 MK
VGA Wiring
NOTE: Extron recommends Extron MHRVGA bulk cable (part number
22‑024‑01) or assembled cables (part numbers 26‑112‑15, 26‑112‑36,
26‑238‑01, and 26‑238‑25). The wire colors for these products are
shown in the VGA Connections table at the top of the next page. If other
cable products are used, the colors may not correspond to those shown
in the table.
O
I
D
U
R
E
T
U
P
M
O
C
The DDC and ID bit DIP switches, the +5 V pin, and the DDC pins are optional
but they can affect the monitors supported by the system (see the table to the
right of “DDC and ID Bit DIP Switch Settings” on the next page).
B
S
U
U
E
0
6
1
EU Junction Box
C
P
W
To connect wires from the VGA input to these modules, some wires must be
cut shorter than others (see the table in the “VGA Connections” section on the
next page). Follow these instructions:
Extron
WPC 160 EU
20 mm M3
Screws (2)
1. Run the unterminated end of the cable to the junction box.
2. Strip away 3 inches (7.5 cm) from the end of the outer jacket of the cable.
3. Unravel each of the coaxial shields and twist each, individually, to make
a wire.
4. Cut 1 inch (2.5 cm) from the end of the individual wires marked with an
asterisk in the VGA Connections table on the next page.
5. Strip 3/16 inches (5 mm) of the inner jacket from the end of each wire and
secure the wire to the appropriate captive screw connector (see the VGA
Connections and TRS Connections tables on the next page).
O
I
D
U
A
R
E
T
U
P
M
O
C
B
S
U
6. Secure the faceplate to the junction box using the screws provided (see
K
M
0
6
1
the figures at right).
C
P
W
UK Junction Box
30 mm M3.5
Screws (2)
7. Connect the VGA input, audio input, or both.
Extron
WPC 160 MK
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|