| ® Undercounter Dishwasher   PRODUCT MODEL NUMBERS   OVERALL DIMENSIONS   TUD8700R   TUD8700S   TUD8750R   TUD8750S   25-1/4" (64.1 cm)   3/4" (1.9 cm)   insulation – may be   compressed (not used   on all models)   23-7/8"   (60.6 cm)   24-1/2"   (62.2 cm)   Electrical: 120-volt, 60-Hz, AC-only, 15- or   20-amp. electrical supply. Use copper wire only. A   time-delay fuse or circuit breaker and separate   circuit is recommended.   Water: A hot water line with 20-120 psi   (138-862 kPa) water pressure. Water temperature   must be 120°F (49°C) at dishwasher. Use 3/8" O.D.   copper tubing with compression fitting or flexible   stainless steel braided fill line (1/2" minimum plastic   tubing is optional but not recommended). Use a 90°   elbow with 3/8" N.P.T. external pipe threads on one   end to connect to water inlet valve. Do not solder   within 6" (15.2 cm) from water inlet valve.   33-7/8"   (86 cm) min. with   wheels removed   21" (53.3 cm)   Side view   Drain: Use the new drain hose supplied with your   dishwasher. If this is not suitable, use a new drain   hose with a maximum length of 12 feet (3.7 m)   that meets all current AHAM/IAPMO test   standards, is resistant to heat and detergent, and   fits the drain connector of the dishwasher. Must   have a high drain loop 20 inches (50.8 cm) above   the subfloor or floor. Connect drain hose to waste   tee or disposer inlet above drain trap in house   plumbing and 20 inches (50.8 cm) minimum   above the floor. An air gap must be used if the   drain hose is connected to house plumbing lower   than 20 inches (50.8 cm) above subfloor or floor.   Use 1/2" minimum I.D. drain line fittings.   Rear view   CABINET OPENING DIMENSIONS   24" (61 cm)**   All surfaces must be free   from intrusions   2-1/2"   34"   (86.4 cm)   min.*   (6.4 cm)‡   6-3/4"   (17.2 cm)‡   24"   (61 cm)   min.   10-1/2"   (26.7 cm)   1-3/4"   (4.4 cm)‡   3"   (7.6 cm)‡   6-1/4"   (15.9 cm)***   2"   4"   (5.1 cm)‡   (10.2 cm)‡   3"   6-1/4"   (15.9 cm)‡***   (7.6 cm)‡   2"   (5.1 cm)   9"   (22.9 cm)   10"   (25.4 cm)   1-3/4"   4-1/4"   (4.4 cm)‡ (10.8 cm)‡   clear area‡   Cut holes in shaded area of cabinet walls or floor as specified below:   water line – 1/2" (1.3 cm)   drain line – 1-1/2" (3.8 cm)   direct wire – 3/4" (1.9 cm)   power supply cord – 1-1/2" (3.8 cm)   * Measured from the lowest point on the underside of countertop. May be   reduced to 33-7/8" (86 cm) by removing wheels from dishwasher.   ** Minimum, measured from narrowest point of opening.   *** May be increased to 6-7/8" (17.5 cm) if height of opening is 34-1/2" (87.6 cm)   at its lowest point.   ‡ Both sides   Because Whirlpool Corporation policy includes a continuous commitment to improve   our products, we reserve the right to change materials and specifications without notice.   Dimensions are for planning purposes only. For complete details, see Installation   Instructions packed with product. Specifications subject to change without notice.   Ref. 8575348   01-15-07   Download from Www.Somanuals.com. All Manuals Search And Download.   |