| USB PORT TO SERIAL PORT ADAPTER CABLE   For Use with Edelbrock QwikData or EFI Systems,   As Well As Other Data Acquisition or EFI Systems   Catalog #91147   ® INSTALLATION INSTRUCTIONS   PLEASE study these instructions carefully before beginning this installation. If you have any questions, please call our Technical Hotline at:   1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at [email protected].   DESCRIPTION: This is a USB to Serial communications adapter cable. It is used to convert a   Laptop or PC USB port to a 9-pin RS232 serial communications connector. This item is included   in all QwikData Data Acquisition and Edelbrock EFI kits. Software drivers are included on the   supplied CD.   KIT CONTENTS   ❑ 1 USB-to-Serial Adapter Cable   SYSTEM REQUIREMENTS   Hardware – A USB-enabled PC or Laptop   ® Software – Microsoft Windows 98SE/ME/2000/XP   INSTALLATION: The drivers for the USB-Serial Port adapter cable are located on the supplied CD.   ® Microsoft Windows Installation   Insert the disc into your CD-ROM drive and click on “Install USB-to-DB9” then follow the onscreen prompts.   NOTE: You may use the same program to un-install the driver if desired. Run the “PL-2303 Driver Installer” program again and   follow the prompts to un-install the driver.   TROUBLESHOOTING: If the adapter is not communicating after installation of the driver, follow the troubleshooting suggestions below.   • Many serial devices will not operate on a COM port higher than 4. If the COM port is higher than 4, change it to a lower number using the Device   Properties.   • To change the assigned COM number, go to the Start menu, click Control Panel then System. Select the Hardware tab and then Device Manager.   Select the category “Ports (COM & LPT)” and right click the device “USB-to-Serial (COM x)” (Or a similar name. “X” represents the assigned COM   number). Click the Port Settings tab, then the Advanced button. A box will be in the lower left corner to assign a different COM port to the adapter.   NOTE: This procedure applies only to Windows 98SE, ME, 2000, and XP.   Edelbrock Corporation • 2700 California St. • Torrance, CA 90503   Catalog #91147   Rev. 4/08 - AJ/mc   ©2008 Edelbrock Corporation   Brochure #63-91147   Download from Www.Somanuals.com. All Manuals Search And Download.   |