DO
Document # PG01-008
Revised 05/25/10 Page 1/2
PLANNING
GUIDE
Double, Distinctive
Wall Oven
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
WARNING
Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
Top of
chassis
•
•
L
B
This appliance must be installed in accordance with the
accompanying installation instructions.
Utility
cutout
J
F
G
H
C
D
21 1/8”
(53.7 cm)
A
MODEL DO230
m)
ng
K
Control panel
front
E
M
Chassis Notch
Side View
(E) Control
all (B) Chassis (C) Overall (D)* Chassis
Panel
Overlay
th
Width
Height
Height
29 3/4”
28 3/8”
49 15/16”
49 1/16”
15/16”
(75.6 cm)
(72.1 cm)
(126.8 cm)
(124.6 cm)
(2.4 cm)
* To top of chassis notch behind control panel
(F) Utility
(G) Utility
(H) Utility
(J) Control
Panel Depth
(K) Notch
Depth
(L) Chassis
(M) Notch
Height
Cutout Width Cutout Height Cutout Depth
Depth
5”
5 ¼”
6”
1”
1 5/8”
24”
1”
(12.7 cm)
(13.3 cm)
(15.2 cm)
(2.5 cm)
(4.1 cm)
(61.0 cm)
(2.5 cm)
ELECTRICAL SPECIFICATIONS
Dedicated Circuit
Requirements
Total Connected Load
240 Vac 60 Hz.,
4-wire,** 40 Amp.
7.8 kW (33 Amp.)
** Two 120 Vac hot (L1 and L2), one neutral, one ground.
The above specifications are for reference only. See the
appliance data plate for exact specifications.
Specifications subject to change without notice.
Install all appliances according to accompanying installation instructions.
Phone: (800) 793-0093
1.11
Download from Www.Somanuals.com. All Manuals Search And Download.
|