9. To disconnect, turn all controls to the off position,
then remove plug from outlet.
1. Your lighted makeup mirror will swivel so that
you can use either the normal, flat mirror or the
magnifying mirror located on the opposite side.
IMPORTANT
SAFETY
10. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
2. Plug cord into any standard 120 volt wall outlet. To
turn on lights, simply turn the dial on the base to desired
light setting.
11. Do not use on a soft surface such as a bed, where
openings may be blocked.
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
3. After use, always turn switch to the off position.
12. Turn switch to off position and unplug cord before
replacing light bulbs.
4. The beauty and design of the Classique™ Collection
mirror complement any decor. Therefore, you may
wish to leave the mirror displayed. However, if you
choose to store the mirror, see STORAGE, below, for
detailed information.
13. Do not place or store mirror where it can fall or be
pulled into a tub or sink.
READ ALL INSTRUCTIONS BEFORE
USING THIS MIRROR
14. If mirror falls into water, unplug it immediately.
Do not reach into the water.
15. Never use while sleeping.
SPECIAL FEATURES
DANGER–
TO REDUCE THE RISK OF
ELECTRIC SHOCK: ALWAYS UNPLUG THIS MIRROR
FROM THE ELECTRICAL OUTLET BEFORE CLEANING.
16. Do not use bulb greater than 20 watts. Use in any
120 volt, 60 hertz AC electric outlet (ordinary house
current). Do not use it in any other electrical outlet.
This lighted makeup mirror uses incandescent light
bulbs with special coating, reproducing shadow-free
lighting in four different settings: evening, home, office
and day.
Figure 1
17. To protect against electrical hazards, do not use
while bathing or in the shower.
WARNING–
TO REDUCE THE RISK
OF BURNS, ELECTROCUTION, FIRE, OR INJURY
TO PERSONS:
18. Unplug the mirror from outlet before cleaning. Do
not leave mirror unattended when it is plugged in.
TO REPLACE BULB
CAUTION: TURN OFF POWER AND UNPLUG.
ALLOW TO COOL AT LEAST 3 MINUTES BEFORE
REPLACING BULB.
1. Unplug from outlet before putting on or taking
off parts.
FOR HOUSEHOLD USE ONLY
2. This mirror should not be used by or near children
or individuals with certain disabilities.
NOTE: Do not use a bulb greater than 20 watts. Contact a
Conair service center at 1-800-3 CONAIR for replacement
bulb information (ask for replacement bulb [#RP34-clear,
#RP35-blue). Bulbs are $1.50 each, including shipping
and handling.]
SAVE THESE
INSTRUCTIONS
3. Use this mirror only for its intended use
as described in these instructions. Do not
use attachments not recommended by the
manufacturer.
1. Remove screws from top and bottom of mirror (Fig. 1).
4. Never operate this mirror if it has a damaged
cord or plug, if it is not working properly, if it
has been dropped or damaged, or dropped into
water. Return the mirror to a service center for
examination and repair.
OPERATING
2. Carefully lift off the removable housing from the half
that is affixed to the stand.
INSTRUCTIONS
3. Unscrew the old bulb and replace with the
new bulb (Fig. 2).
To reduce the risk of electric shock, this mirror has
a polarized plug (one blade is wider than the other).
This plug will fit into a polarized outlet only one
way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet.
Do not change the plug in any way.
5. Keep the cord away from heated surfaces.
6. Never drop or insert an object into any opening.
7. Do not use outdoors.
4. Carefully replace the removable half after locating
and aligning the screw holes to the fixed half.
Figure 2
5. Insert screws into screw holes and tighten.
8. Do not operate where aerosol (spray) products are
being used or where oxygen is being administered.
Download from Www.Somanuals.com. All Manuals Search And Download.
|