TM
HIGHLINE TENT 12’ X 12’
MODEL 2000001091
Before you begin
Parts and Components
Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard
or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees.
Description
Part Number
Main Poles, Black (2)
Main Poles, Gray (2)
5010000433
5010000506
5010000507
Vestibule Pole, Long, Thin, Black (1)
• For best results in windy conditions, position end of tent into
the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the tent.
Rainfly Ridge Pole, Thin, Black w/ Metal Tips (1) 5010000434
Rear Awning Pole (1)
Rainfly
5010000508
5010000435
To Set Up Tent
Front & Back
Sleeves
Black,longer,
Main Poles
1. Unfold tent and spread out on a clean, level surface with
the door facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the shock-corded,
sections together. (See components section above for
list of poles.)
Door
Side Sleeve
3. Insert gray main poles through the sleeves on both
sides of tent; then insert black main poles through
sleeves, in front and back of tent. Make sure black poles
overlap the gray poles. (Fig. 1)
Side Sleeve
Gray, Main Poles
Fig. 1
2A
4. Insert end of each black & gray main pole into pins .
(Fig. 2 & 2A)
5. Go to opposite end of each pole and gradually apply
pressure to each forming arches. Insert the pin into each
pole end at the sides and corners of tent. (Fig. 2 & 2A)
6. Attach frame clips along edges of tent to the black &
gray main poles. (Fig. 2B)
2B
Door
7. Stretch tent until taut, then secure metal loops located
on both sides and corners of tent with stakes. (Fig. 2C)
2C
Fig. 2
To Attach Rainfly
1. Insert rainfly ridge pole with metal tips through sleeve
in underside of rainfly. (Fig. 3)
Sleeve in Rainfly
Metal Tip
2. Drape rainfly over tent with rainfly ridge pole centered
from above front door to back of tent & the green
vestibule flaps located in the front. (Fig 4).
3. Insert rainfly ridge pole into metal grommet on front of
tent, apply pressure until pole forms an arch, then
insert other end into back grommet. (Fig. 4 & 4A).
NOTE: Because of the position of the center
grommets, it may be necessary to gently pull to
on the front & back arches for easier access.
4. Insert vestibule pole through sleeve in rainfly at front
of tent. (Fig. 4)
Rainfly
Thin, Black,
Rainfly
Ridge Pole
Fig. 3
Fig. 4
4A
5. Locate all hook & loop fasteners on underside of
rainfly and wrap around black and gray poles to secure.
(Fig. 5)
Door
Vestibule
Pole
6. Stretch elastic straps and hook clip on each to the
metal loops at the four corners of the tent. (Fig. 6)
Sleeve in
Rainfly
Green Vestibule Flaps
Fig. 5
Fig. 6
(continued on other side)
Download from Www.Somanuals.com. All Manuals Search And Download.
|