important assembly and
safety information
1.
always wear ansi-approved safety gog-
gles, heavy-duty work gloves, and niosh-
approved respirator when using this hot
wire foam cutter - Do not pick up, or touch
with bare hands.
hot wire
foam cutter
66788
2.
3.
this hot wire foam cutter gets very hot
(428°), and is not a toy. Do not allow chil-
dren to play with or near this item.
do not leave this hot wire foam cutter
lying on foam, or any combustible surface
- Keep hot pad, or non-combustible surface
handy to lay Foam Cutter for cooling.
instructions and
precautions
4.
disconnect from power source before
inspection, or cleaning - Wait at least 30
minutes to cool before performing mainte-
nance.
®
distributed exclusively by harbor freight tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
5.
6.
use only for intended purpose - Do not
use this Hot Wire Foam Cutter to cut any
material but foam.
saVe these
instructions.
read all
precautions and
instructions.
This product contains or, when used, pro-
duces a chemical known to the State of Cali-
fornia to cause cancer and birth defects or
other reproductive harm. (California Health
& Safety Code § 25249.5, et seq.)
©
®
Copyright 2009 by Harbor Freight Tools . All
rights reserved. No portion of this document or any
artwork contained herein may be reproduced in any
shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this document
may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the
product described herein. Tools required for assembly
and service may not be included.
7.
Maintain product labels and nameplates -
These carry important safety information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
operation instructions
Put on ANSI-approved safety goggles and
heavy-duty work gloves.
1.
2.
for technical questions or replacement parts,
please call 1-800-444-3353.
Plug Adapter into 120V power outlet. This
Adapter must remain plugged in while you
are using the Hot Wire Foam Cutter.
specifications
3.
Press the ON/OFF Button and hold. This
Button will go to OFF position if released.
note: This is a safety precaution and must
not be tampered with by using tape or other
methods to hold down continuously.
Adapter: 120VAC, 60Hz
Electrical Information
Power: 7.5V DC, 1200mA
Cutting Temperature
Wire Size
428° F (220° C)
32 AWG (0.008” Dia.)
4.
5.
Press hot wire into foam using gentle pres-
sure to move through the workpiece. Let the
Hot Wire Foam Cutter move slowly. Do not
force the cutting action.
unpacking
When unpacking, make sure that the item is
intact and undamaged. If any parts are missing or
broken, please call Harbor Freight Tools at
1-800-444-3353 as soon as possible.
When you are finished cutting, release the
ON/OFF Button. Unplug the Adapter and set
reV 09c
Download from Www.Somanuals.com. All Manuals Search And Download.
|