EF-S55-250mm f/4-5.6 IS II
ENG
Download from Www.Somanuals.com. All Manuals Search And Download.
Instruction
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Do not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes or
modifications should be made, you could be required to stop
operation of the equipment.
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. Thse limits are designed to provide reasonable protection
against hmful interference in a residential installation. This
ment enerates, uses and can radiate radio frequency
y and, f not installed and used in accordance with the
inructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
a Safety Precautions
• Do not look at the sun or a bright light source
through the lens or camera. Doing so could
result in loss of vision. Looking at the sun directly
through the lens is especially hazardous.
• Whether it is attached to the camera or not, do
not leave the lens under the sun without the
lens cap attached. This is to prevent the lens from
concentrating the sun’s rays, which could cause a
fire.
Handling Cautions
• If the lens is taken from a cold environment in
a warm one, condensation may develop on the
lens surface and internal parts. To prevnt
condensation in this case, first put the lens ito n
airtight plastic bag before taking it from a cold to
warm environment. Then take out the lens after it
has warmed gradually. Do the same when taking
the lens from a warm environment into a cold one.
• Do not leave the lens in excessive heat such as in
a car in direct sunlight. High temperatures can
cause the lens to malfunction.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
This Class B digital apparatus complies with Canadian ICES-003.
ENG-2
Download from Www.Somanuals.com. All Manuals Search And Download.
Nomenclature
Focusing ring (→ 4)
Hood mount
(→ 5)
Focus mode switch (→ 4)
Zoom position index
Filter mounting
thread (→ 8)
Image stabilizer switch
(→ 6)
Zoom ring (→ 5)
Lens mount index (→ 4)
Contacts (→ 4)
For detailed information, reference page numbers are provided in parentheses (→ **).
ENG-3
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting and Detaching the Lens
Setting the Focus Mode
1
2
See your camera’s instructions for details on
mounting and detaching the lens.
To shot in autofocus mode, set the focus mode
switch AF.
se oly manual focusing, set the focus mode
sitch to MF, and focus by turning the focusing
ring.
¡After detaching the lens, place the lens with the
rear end up to prevent the lens surface and
electrical contacts from getting scratched.
¡If the contacts get soiled, scratched, or ave
fingerprints on them, corrosion or faulty
connections can result. The camera and ens
may not operate properly.
¡Do not touch the rotating parts of the lens while
autofocus is active.
¡If the contacts get soiled or have fingerprints on
them, clean them with a soft cloth.
¡Do not adjust focus manually when the focus
mode switch is set to AF.
¡If you remove the lens, cover it with the dust
cap. To attach it properly, align the lens mount
index and the ¢ index of the dust cap as shown
in the diagram, and turn clockwise. To remove
it, reverse the order.
ENG-4
Download from Www.Somanuals.com. All Manuals Search And Download.
Zooming
Hood (Sold Separately)
3
4
The ET-60 hood can keep unwanted light out of
the lens, and also protects the lens from rain,
snow, and dust.
To zoom, turn the lens’ zoom ring.
Be sure to finish zooming before focusing.
Changing the zoom ring after focusing can affect
the focus.
Turn the hood in the direction of the arrow to
attach it securely.
The hood can be reverse-mounted on the lens
for storage.
¡When attaching or detaching the hood, grasp
the base of the hood to turn it. To prevent
deformation, do not grasp the rim of the hood to
turn it.
¡Part of the picture may be blocked if the hood is
not attached properly.
ENG-5
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
5
You can use the image stabilizer in AF or MF
mode.
¡The Image Stabilizer cannot compensate for a
blurred shot caused by a subject that moved.
The Image Stabilizer may not be fully effective if you shoot
from a violently shaking vehicle or other transportation.
¡The Image Stabilizer consumes more power
than normal shooting, so fewer shots can be
taken if you use the function.
This function provides optimal image stabilization
depending on shooting conditions (such as
shooting still subjects and following shots).
¡
¡Wen shooting a still subject, it compensates for
caera shake in all directions.
¡It compensates for vertical camera shake during
following shots in a horizontal direction, and
compensates for horizontal camera shake
during following shots in a vertical direction.
¡When you use a tripod, the Image Stabilizer
should be turned off to save battery power.
Set the STABILIZER switch to
¡If you are not going to use the image
stabilizer function, set the switch to
1
¡
Even with a monopod, the Image Stabilizer will be
as effective as during hand-held shooting.
.
However, depending on the shooting environment,
the Image Stabilizer effect may be less effective.
The image stabilizer function also operates when the
lens is used with an Extension Tube EF12 ll or EF25 ll.
When you press the shutter button
2halfway, the Image Stabilizer will
¡
start operating.
¡If you set the camera’s Custom Function to
change the assigned button to operate the AF,
the Image Stabilizer will operate when you press
the newly assigned AF button.
¡Make sure the image in the viewfinder is
stable, then press the shutter button the
rest of the way down to take the picture.
ENG-6
Download from Www.Somanuals.com. All Manuals Search And Download.
Image Stabilizer
The image stabilizer in this lens is effective for hand-held shots under the following
conditions.
¡In semi-darkened areas such as indoors or
outdoors at night.
¡When panning subjects in motion.
¡In locations where flash photography is
prohibited, such as art museums and theater
stages.
¡In situations where your footing is uncertain.
¡In situations where fast shutter settings cannot
be used.
ENG-7
Download from Www.Somanuals.com. All Manuals Search And Download.
Filters (Sold Separately)
Extension Tubes (Sold Separately)
6
7
You can attach filters to the filter mounting
thread on the front of the lens.
You can attach Extension Tube EF12 II or EF25
II for magnified shots. The shooting distance and
magnification are shown below.
¡The front end of the lens rotates, so hold it when
attaching the filter.
¡Use a genuine Canon filter (58mm).
¡To adjust the polarizing filter, first remove the
lens hood.
Camera-to-Subject
Magnification
Distance (mm)
Near
351
Far
411
Near
0.28×
0.60×
0.47×
0.46×
Far
55mm
250mm
55mm
250mm
0.22×
0.05×
0.48×
0.11×
EF12 II
EF25 I
1075
281
5274
297
918
2692
Manual focusing is recommended for accurate
focusing.
ENG-8
Download from Www.Somanuals.com. All Manuals Search And Download.
Close-up Lenses (Sold separately)
8
Attaching a 250D or 500D (58mm) Close-up
Lens enables close-up photography.
The magnification will be as follows.
¡Close-up Lens 250D: 0.23x - 1.42x
¡Close-up Lens 500D: 0.11x - 0.86x
Manual focusing is recommended for accurate
focusing.
ENG-9
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
9
Image Size
15.1 × 22.7 mm
Focal Length/Aperture
Lens Construction
Minimum Aperture
Angle of View
Min. Focusing Distance
Max. Magnification
Field of View
Filter Diameter
Max. Diameter and Length
Weight
55 – 250 mm f/4 – 5.6
10 groups, 12 elements
f/22 – 32
Diagonal: 27° 50’ – 6° 15’ Vertical: 15° 40’ – 3° 30’ Horizontal: 23° 20’ – 5° 20’
1.1 m/3.6 ft.
0.31 × (at 250 mm)
218 × 328 – 49 × 73 mm/8.6 × 12.9 – 1.9 × 2.9 inch (at 1.1 m)
58 mm
70 × 108 mm/2.8 × 4.h
approx. 390 g/13oz
ET-60 (Sold sey)
E-58/E-5II
Hood
Lens Cap
Case
LP1019 (Sold separately)
¡Equivalent to 88-400 mm in the 35 mm film format.
¡The lens length is measured from the mount surface to the front end of the lens. Add 21.5 mm to include the
E-58 lens cap and dust cap, and 24.2 mm for the E-58 II.
¡The size and weight listed are for the lens only, except as indicated.
¡Aperture settings are specified on the camera. The camera automatically compensates for variations in the
aperture setting when the camera is zoomed in or out.
¡The EF1.4X III/EF2X III extenders cannot be used with this lens.
¡All data listed is measured according to Canon standards.
¡Product specifications and appearance are subject to change without notice.
ENG-10
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
0812Ni © CANON INC. 2011
CT1-8577-001
|