2 inch Brad Nailer
Visit us at chpower.com
Close pressure
regulator, Turn
ON compressor and
Allow tank to reach
maximum pressure.
Attach air
CHN70200
1
2
hose to regulator
outlet. Adjust
regulator knob so
outlet pressure is
between 60 psi and
100 psi.
Setup Like a Pro
Easy Setup Guide
Projects are easier with
Campbell Hausfeld products.
Screw
100
60
psi
psi
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
Battery Replacement
© 2009 Campbell Hausfeld/Scott Fetzer
IN728001AV 6/09
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Load fasteners. See manual for further information regarding length and type
of fasteners.
Attach coupler on air
hose to nailer inlet.
3
4
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Press magazine latch button
Load nails with points all the
Close magazine.
and pull magazine open.
way into the groove.
Setup Like a Pro
CHN70200 — Air Powered Brad Nailer
Download from Www.Somanuals.com. All Manuals Search And Download.
|