3-1/2 inch 34° Framing Nailer
Visit us at chpower.com
Close pressure
regulator, Turn
ON compressor and
Allow tank to reach
maximum pressure.
Attach air
CHN70800
1
2
hose to regulator
outlet. Adjust
regulator knob so
outlet pressure is
between 70 psi and
120 psi.
Setup Like a Pro
Easy Setup Guide
Screw
Projects are easier with
Campbell Hausfeld products.
70
psi
120
psi
Thank you for deciding to purchase a
Campbell Hausfeld product. We are dedicated
to providing tools that help you to complete your
projects Like a Pro.
NOTICE: To operate this tool you will need
at least a 1 gallon compressor.
© 2009 Campbell Hausfeld/Scott Fetzer
IN727801AV 6/09
Battery Replacement
Load fasteners. See manual for further information regarding
length and type of fasteners.
Attach coupler
on air ho
nailer inl
3
4
Always disconnect the tool from
the power source when unattended,
performing any maintenance or repair, clearing a jam,
loading, unloading, or moving the tool to a new location.
Disconnect the tool from air source. Remove screw
and battery compartment cover. Insert two (2) new
batteries in the proper orientation. Do not mix old
and new batteries. Close cover. Replace screw.
Load nails into rear slot of magazine. Pull pusher back over nail clip.
Release pusher.
Setup Like a Pro
CHN70800 — Air Powered Framing Nailer
Download from Www.Somanuals.com. All Manuals Search And Download.
|