Combi-jet
PV 2002
PV 2005
PV 2010
Type 4691
Steam iron
English
Use Instructions
Guarantee
Service Centers
Download from Www.Somanuals.com. All Manuals Search And Download.
Praktical Guidelines
Type of Water to be Used
This iron is designed for tap water. However, if
you have hard water we recommend to use a
mixture of 1/2 part tap water and 1/2 part distilled
water from drug stores or grocery stores.
Dry ironing
Set the steam regulator 4in position « »
Jet of steam*
(coming from the
outlets pat the slim
pointed tip o):
Caution: Keep children
away from the jet of
steam and do not hold
your fingers in front of the
Spray / shot of steam
2-function button:
With the model 2010
the functions «water
•
(= steam off) (c) for dry ironing. The water
spray 7may be used at any temperature
setting to dampen the laundry. The jet of steam
6and the shot of steam 7buttons can be
activated during dry ironing, provided that the
temperature selector 1is within the continuous
red area
spray» and «shot of
steam» can be activated
with a 2-function button.
The desired function can
be selected by turning the
button 7as far as it will
go. The marking (blue =
water spray or red = shot
of steam) must point to
the respective function (f).
Turn the button from blue
(spray) to red (shot of
steam) anti-clockwise
Important: Never use distilled water (battery
water). Do not add any additives (e. g. starch) to
the water.
outlets pwhen activating this function.
When ironing within the red range
area the jet of steam function 6can
Steam ironing
(see «Table of features»)
Temperature selection: Set the temperature
selector 1within the red
range steam (b) and wait
To fill iron
1. Pull the plug out of the wall outlet.
be used (e). To do so, press the button 6 at
intervals of no less than 5 seconds. The jet of
steam has been designed not only for steaming
hard to reach areas like pleats, inside of pockets
etc., but also for steaming hanging clothing
(e. g. velvet skirts, curtains, etc.) (g). The jet of
steam functions between horizontal and upright
positions. Be careful not to touch sensitive
textiles with the hot sole plate.
2. Put the steam regulator 4in position « »
(= steam off).
•
until the iron has reached the selected
temperature (i. e. the pilot light 8goes off).
Steam ironing is possible in the entire red range.
Steam ironing at lower temperatures may cause
water drops instead of steam. Should this
happen, turn the steam regulator 4to the
and from red to blue clockwise (f).
3. Open sliding shutter 2.
4. Place the iron in the upright position and fill
with water slowly through the tank opening 2
to the «max.» marking L(a), using the beaker
q.
Storage
After ironing, always pull the plug out of the wall
outlet. Set the temperature selector 1to «min.»
position « » (= steam off) (c).
Shot of steam*
(coming from the vents
in the sole plate):
•
(b) and the steam regulator 4to « » (= steam
•
5. Close sliding shutter.
Steam regulator 4:
Select the quantity of
off) (c).
When ironing within
steam required (c) for
each garment with
the steam regulator 4.
You can increase the
the red area
the shot of
steam function can be
used. It gives an extra,
To empty the iron hold it with the open water tank
opening 2downwards (h) and shake it 1 or 2
times. The pivoting cord 9conveniently winds
up around the cord storage k.
Selecting the temperature
Connect the iron to a safely located wall outlet
and select the ironing temperature with the
temperature selector 1(b). As soon as the pilot
light 8goes out, the iron has reached the
temperature selected. To avoid water dripping,
always rest the iron upright while heating it up
quantity by turning the
steam regulator clock-
wise (wide markings) to the end of the red
marking.
particularly powerful shot of steam penetrating
deep into the textiles in order to straighten
creases, collars and pleats. The function «shot
of steam» can be used in normal ironing and
also horizontally for steaming hanging clothing
(e. g. velvet skirts, curtains etc.) (g). Press the
shot of steam button 7at intervals of no less
than 5 seconds. When steaming be careful not to
touch sensitive textiles with the hot sole plate.
IMPORTANT: Store the cool steam iron in a dry
place and always standing on its heel rest j.
The sole plate may be damaged by remaining
water if it is stored horizontally. The warranty
does not cover faults or damage resulting from
improper storage of the iron.
keep the steam regulator 4in position « »
(= steam off) (c).
•
Caution: While ironing do not turn the steam
regulator further, otherwise hot water may
come out from the sole plate (see section
«Decalcifying/Self-cleaning»).
You will usually find the following symbols in your
garments:
Maintenance and Cleaning
By turning the steam regulator ant-clockwise
you can reduce the quantity of steam or turn the
* If pressed too frequently, it can drip. Should
this happen, wait a few seconds before using it
again.
All models have an aluminium sole plate. To
prevent damaging it, do not iron over buttons or
zippers, etc. Clean the sole plate regularly,
particularly if you use starch or other ironing
aids. To remove mineral/starch residues use a
vinegar and water mixture in the ratio of 1:2.
Never use abrasive scouring pads, powders or
liquids.
steam off « » (= steam off) (see «Ironing
•
The temperature selector 1is marked with
these symbols:
Guide»).
Spray (coming from the
nozzle 3):
The spray function can be
used at any temperature,
to dampen laundry. To do
so, press the button 7
(water spray = blue).
Constant steam:
min. The iron is connected
Your Braun steam iron is equipped with a special
tank configuration to privide constant steam
even when the water level in the tank is low.
●
Synthetics (acrylic, acetate)
●● Silk/rayon/nylon/polyester/
The steam vents mand jet of steam outlets p
may be cleaned with a toothpick or cotton swabs
and vinegar solution, if necessary.
cotton blends/wool
«Extra steam»*
(coming from the
●●● Cotton/linen
max. Linen
steam vents in the sole
plate): For stubborn
creases and wrinkles,
collars and cuffs.
Select the temperature you need according to
these symbols.
When ironing within
the red range
Spray, shot of steam, jet of steam
Before you start ironing, we recommend to press
the buttons 3 or 4 times, in order to activate
these functions.
area the extra steam function can
be used. You can press the button 5(d) for 3
seconds at intervals of no less than 15 seconds.
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Decalcifying / Self-cleaning
9.Wait for the sole plate to cool down and then
clean it (see «Maintenance and Cleaning»).
Ironing Guide
Guarantee
We grant a 1 year guarantee on the product
commencing on the date of purchase.
Braun Combi-jet irons have a built-in system
(anti-calc. valve) to prevent calcification. It allows
you to clean residues from the steam chamber.
Do not use commercial decalcifiers; they may
damage the sole plate. We recommend to use
the self-cleaning function every 3 months.
To begin ironing, it is best to start with fabrics
requiring a lower temperature (e. g. synthetics),
and continue with those requiring a higher
temperature (e. g. cotton, linen).
Silk and silk-like synthetics tend to waterspot,
therefore before using the water spray feature,
test it on an inconspicuous spot first.
10.Make sure that the sole plate is completely dry
before storing it.
Within the guarantee period we will eliminate,
free of charge, any defects in the appliance
resulting from faults in material or workmanship
either by repairing, or exchanging parts or
exchanging the whole appliance as we may
choose.
Cleaning the anti-calc. valve on the steam
regulator
During the time the sole plate is cooling down we
recommend to decalcify the anti-calc. valve in
the following way:
1. Put a small quantity of white vinegar (not
vinegar essence) or lemon juice into a glass or
bowl.
Fabrics
Temperature
regulator
setting
Steam
regulator
setting
Not covered by this guarantee: damage arising
from improper use or storage (operation with
incorrect current/voltage, plugging it into an
unsuitabie power point, breakage use of
commercial decalcifyers, wet storage on the
ironing surface), normal wear and defects which
have a negligible effect on the value or operation
of the appliance.
Synhetics
(acrylic, acetate)
●
(= steam off)
•
2. Immerse just the bot-
tom part of the valve in
the liquid, wait till it is
decalcified and care-
fully brush of remain-
ing residue (E).
Silk, rayon,
nylon, polyester,
cotton blends
●●
(= steam off)
to max.
•
1. Turn the steam regulator 4to the position « »
(= steam off).
•
Wool
●●
(= steam off)
to max.
•
The guarantee becomes void if repairs are
undertaken by unauthorised persons and if
original Braun parts are not used.
2. Fill the water tank to the marking «max.» L
and turn the temperature selector 1to the
●●● marking («self-cleaning» = SC) (A).
Do not use a metal
brush.
Cotton
Linen
●●●
(= steam off)
to max.
•
The guarantee only comes into force if the date
of purchase is confirmed by the dealer's stamp
and signature on the guarantee card and
registration card.
3. Plug the iron into the socket and wait till the
pilot light 8goes off.
●●●
to max.
(= steam off)
to max.
3. Then, rinse it under
running water without touching the lower end
of the valve.
•
4. Unplug the iron and hold it over a sink.
Mixed fabrics: Always select the temperature
suited for the most sensitive fibre the garment
contains. Follow manufacturer’s instructions on
the label.
This guarantee extends to every country where
this appliance is supplied by Braun or its
appointed distributor and where no import
restrictions or other legal regulations hinder or
prevent service being given under guarantee.
Re-inserting the steam regulator with anti-calc.
valve
5. Turn the steam regu-
lator 4clockwise to
the end of the red
1. Re-insert the steam regulator so that the
marking (B) and then
double-arrow
the iron (F).
aligns with the marking on
Subject to chance without notice.
6. keep turning in to the
double-arrow marking
. The steam regu-
Service under the guarantee does not affect the
expiry date of the guarantee. The guarantee on
parts or entire appliances which are exchanged
ends when the guarantee on this appliance
expires.
2. Then push it down carefully and at the same
time turn the button anti-clockwise.
This product conforms to the
EMC-Requirements as laid down by
the Council Directive 89/336/EEC.
lator will lift (C).
3. Keep turning the button
7. Pull out the steam
regulator together with
the valve vertically (D).
Do not touch the lower
end of the anti-calc.
valve with your fingers,
to avoid a possible
greasy film.
to the marking « »
•
(= steam off).
In the event of a claim under this guarantee,
hand in the complete appliance with the valid
guarantee card to your dealer, or send both to
the nearest Braun Customer Service Centre.
4. If your iron has the shot
of steam, refill the tank
with water, heat the
iron up and press the
button 73 to 4 times in
the shot of steam
All other claims including for damages resulting
from this guarantee are excluded unless our
liability is legally mandatory.
8. Allow all water to drain through the steam
vents in the sole plate, while shaking the iron
slightly. (Caution: Hot water and steam come
out from the sole plate.)
function before ironing, to rinse the iron.
Those claims arising out of the sales contract
with the vendor are not affected by this
guarantee.
ATTENTION: The iron must not be used without
the steam regulator and the anti-calc. valve.
For UK only:
This guarantee in no way affects your rights
under statutory law.
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.
|