Mac Pro
PCIe/Graphics Card
Replacement Instructions
Note: Follow these instructions carefully. Failure to do so could damage your equipment and
First Steps
void its warranty.
1
2
Shut down computer.
Wait 10 minutes.
Warning: Parts inside
computer can be very
hot. Allow computer
to cool down before
continuing.
3
Unplug all external
cables except power
cord.
4
5
Touch metal PCI cover
on back of computer.
Unplug power cord.
Opening the
Computer
1
Hold side access
panel and lift latch on
back of computer.
Warning: Edges of
access panel and
enclosure can be
sharp. Be careful
when handling.
2
Remove access panel
and place it on flat
surface covered by
soft, clean cloth.
© 2009 Apple Inc. All rights reserved.
073-1248 Rev. A
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Removing the
Installed PCIe/
Graphics Card
1
Locate card.
2
3
Using Phillips #1
screwdriver, loosen 2
captive screws
securing card’s
bracket to enclosure.
Remove bracket from
enclosure.
© 2009 Apple Inc. All rights reserved.
073-1248 Rev. A
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Note: Card is held in place
by retention bar. Next two
steps explain how to
release bar.
4
5
Press button on PCIe
fan.
Move fan to left,
which releases
retention bar.
Holding card by top
corners, pull it up out of
slot.
6
Remove card from
computer.
Checklist for handling card:
•
•
•
•
When removing or installing card, handle it only by the edges. Do not touch its connectors
or any components.
Don’t rock card from side to side; instead, lift card straight up from connecotr to remove it,
and press card straight into slot to install it.
Don’t force card. If you meet a lot of resistance, pull card out. Check connector and slot for
damage or obstructions, then try inserting card again.
Pull card gently to see if it is properly connected. If it resists and stays in place and its gold
connectors are barely visible, card is connected.
© 2009 Apple Inc. All rights reserved.
073-1248 Rev. A
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Installing the
Replacement
PCIe/Graphics
Card
1
Install replacement
card.
Note: Align card’s
connector with
expansion slot and
press down until
connector is inserted
all the way into slot.
2
3
Slide PCIe fan to the
right to lock card in
place.
Replace PCI bracket
and tighten screws.
Note: Slide bracket
under circled tab
before securing
screws.
© 2009 Apple Inc. All rights reserved.
073-1248 Rev. A
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Closing the
Computer
1
Replace access panel.
Note: Make sure
latch is up before you
replace panel. If latch
is down, panel will
not seat correctly.
2
Push latch down
to close and secure
access panel.
Warning: Never turn
on computer unless
all its internal and
external parts are in
place and it is closed.
Operating computer
when open or missing
parts can cause
damage or injury.
Apple Inc.
© 2009 Apple Inc. All rights reserved.
This document is protected under U.S. Copyright Law and International Treaties, and no part of this
document may be reproduced in any form without written permission from Apple.
Apple is not responsible for typographical, printing, or inadvertent errors.
Apple Inc.
1 Infinite Loop
Cupertino, CA 95014-2084 USA
+ 1 408 996 1010
Apple, the Apple logo, and Mac are trademarks of Apple Inc., registered in the U.S. and other countries.
© 2009 Apple Inc. All rights reserved.
073-1248 Rev. A
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|