Maytag MGC7536W User Manual

30" (76.2 cm) and 36" (91.4 cm) Gas Built-In Cooktop  
PRODUCT MODEL NUMBERS  
The cooktop should be installed in a location away from strong draft areas, such as  
windows, doors and strong heating vents or fans.  
MGC7430W  
MGC7536W  
MGC7630W  
MGC7636W  
All openings in the wall or floor where cooktop is to be installed must be sealed.  
IMPORTANT: To avoid damage, check with your builder or cabinet supplier to  
make sure that the materials used will not discolor, delaminate or sustain other  
damage.  
Type of Gas  
Natural Gas: This cooktop is design-certified by CSA  
International for use with Natural gas or, after proper  
conversion, for use with LP gas.  
Mobile Home - Additional Installation Requirements  
The installation of this cooktop must conform to the Manufactured Home  
Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal  
Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When  
such standard is not applicable, use the Standard for Manufactured Home  
Installations, ANSI A225.1/NFPA 501A or with local codes.  
In Canada, the installation of this cooktop must conform with the current standards  
CAN/CSA-A240-latest edition, or with local codes.  
This cooktop is factory set for use with Natural gas. If  
converting to LP gas, see the “LP Gas Conversion”  
instructions provided in the package containing literature.  
The model/serial rating plate located on the underside of  
the cooktop base has information on the types of gas that  
can be used. If the types of gas listed do not include the  
type of gas available, check with the local gas supplier.  
LP Gas Conversion: Conversion must be done by a  
PRODUCT DIMENSIONS  
qualified service technician.  
30" (76.2 cm) Model  
No attempt shall be made to convert the cooktop from the  
gas specified on the model/serial rating plate for use with a  
different gas without consulting the serving gas supplier. See  
the Gas Conversion instructions provided in the package  
containing literature.  
A
Gas Supply Line  
Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the  
B
cooktop location. A smaller size pipe on longer runs may  
result in insufficient gas supply. Pipe-joint compounds that  
resist the action of LP gas must be used. Do not use  
TEFLON®† tape. With LP gas, piping or tubing size should  
be ¹⁄₂" minimum. Usually, LP gas suppliers determine the  
size and materials used in the system.  
C
†®TEFLON is a registered trademark of E.I. Du Pont Nemours and  
Company.  
LOCATION REQUIREMENTS  
IMPORTANT: Observe all governing codes and ordinances.  
D
Do not obstruct flow of combustion and ventilation air.  
It is the installer’s responsibility to comply with installation  
clearances specified on the model/serial rating plate. The  
model/serial rating plate is located on the underside of the  
cooktop base.  
E
36" (91.4 cm) Model  
A
A
B
A. Model/serial rating plate  
To eliminate the risk of burns or fire by reaching over  
heated surface units, cabinet storage space located above  
the surface units should be avoided. If cabinet storage is to  
be provided, the risk can be reduced by installing a range  
hood that projects horizontally a minimum of 5" (12.7 cm)  
beyond the bottom of the cabinets.  
C
The cooktop must be a specified cooktop that is approved  
to be installed either alone or over an undercounter built-in  
oven. Check the cooktop base approved installation label  
for your cooktop model number and approved  
combinations of cooktops and ovens that can be installed.  
If you do not find this label, your cooktop may not be  
approved for use over an undercounter built-in oven.  
Contact your dealer to confirm that your cooktop is  
approved.  
D
E
Ovens approved for this type of installation will have an  
approval label located on the top of the oven. If you do not  
find this label, contact your dealer to confirm that your  
oven is approved. Refer to oven manufacturer’s Installation  
Instructions for approval for built-in undercounter use and  
proper cutout dimensions.  
Page 1 of 2  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. W10268392A  
10/26/09  

IBM P260 User Manual
Intel D915PGN User Manual
Intel D945GSEJT User Manual
Jenn Air JGC7536 User Manual
Microstar G41M User Manual
Miele KM427 User Manual
Motorola MPC8260 User Manual
NEC MultiSync L182R4 User Manual
Philips Brilliance 200PW8ES User Manual
Philips DVP3236X User Manual