WE L L S MA N U FA C T U R I N G
I T E M N O .
WV-FG, WV-2HG, WV-2HSG
VENTLESS GRIDDLE/FRYER/COOKTOPS
The ventless hood gives you the flexibility to “set up shop” just
about anywhere from malls, stadiums and high-rise buildings
to basement kitchens and kiosks.
Griddle (All Models)
• Griddle surface (17 1/4”W x 18 1/4”D) has
enclosed tubular elements that provide even
heat distribution.
• Griddle is controlled by a positive-off thermostat
adjustable from 100ºF to 400ºF.
• Griddle features include a full-width front grease
trough, an extra-large removable front grease
drawer and a stainless steel splashguard.
Fryer (WV-FG, WV-FGRW)
• Two half-size, rear hanging, interchangeable fry
baskets are provided.
• Efficient heating element is flat, heavy-duty
stainless steel.
• Fryer on/off switch is located in recessed front
control panel.
• The positive-off thermostat controls the
element allowing for adjustable and more
consistent temperatures.
• The fryer has a manual reset safety thermostat
that will shut off the heating element if an
over-temperature condition is reached.
WV-FGRW
• Model WV-FGRW includes a Wells RW-26 built-in
(shown with optional drawer warmer)
standard double drawer warmer that replaces lower
storage cabinet.
Ventless Hood (All Models)
• Ventless Hood System exceeds EPA Standard
202 for the release of particulate matter.
Cooktop (WV-2HG, WV-2HSG, WV-2HGRW, WV-2HSGRW)
• Model WV-2HG has two solid cast iron 9" french
plate elements that are independently regulated by
an infinite control with a positive-off position.
• Interlock System will not allow heating
elements to be energized if any of the filters
are not in place.
• Model WV-2HSG has two spiral 8" elements that
are independently regulated by an infinite control
with a positive-off position.
• Airflow Sensing System continually monitors
airflow through the filtration system, optimizing
performance and grease removal.
• Models WV-2HGRW and WV-2HSGRW include a
Wells RW-26 built-in standard double drawer
warmer that replaces lower storage cabinet.
• Ansul® R-102 Fire Suppression System
is built into the ventless hood to provide
ultimate protection.
• Shatter-resistent interior light for
improved visibility.
WELLS
WE L L S MA N U FA C T U R I N G
MODEL
WV-2HSG
GRI DDLE, 2 SPI RAL ELEM ENTS
R
R
R
LISTED
E146882
STD.4
LISTED
E146882
INCH
(MM)
DI M ENSIONS:
MINIMUM CLEARANCE REQUIRED FROM UNIT
TO THE NEAREST SURFACE
BACK
NA
NA
SIDE
SEE REQUIRED
SPACERS
BOTTOM
6
(152)
TOP
8
(203)
COOKING SURFACE ILLUSTRATION
AIR
EXHAUST
GRIDDLE: 17 1/4 X 18 1/4
8 INCH SPIRAL ELEMENTS
30 3/8
(771)
47 15/16
1217
35 3/8
(898)
REQUIRED
6" CLEARANCE
SPACERS & SIDE
SHIELDS
17 3/8
(441)
OPENING
79 1/8
(2010)
CONTROL
PANEL
36
(914)
27 1/16
688
22 3/4
577
6 FT. POWER
SUPPLY CORD
AND PLUG
42 3/8
1076
WV-2HSG ELECTRICAL SPECI FICATIONS:
AMPS PER LINE 3 PHASE
MODELS VOLTS WATTS
POWER SUPPLY CORD
L1
L2
L3
WV-2HSG
WV-2HSG
208
240
208
240
8900
11100
9575
21
35
24
NEMA 15-60P
NEMA 15-60P
NEMA 15-60P
NEMA 15-60P
23
23
26
38
35
38
24
26
27
WV-2HSGRW*
WV-2HSGRW*
12000
*RW Models include optional RW-26 built-in standard double drawer warmers.
NOTE: Specifications are subject to change without notice.
SPECIAL ENVIRONMENTAL NOTICE: The hood system is designed to reduce odor emissions but will not eliminate odors.
Air exchange at the installation site must comply with requirements of the local jurisdictional authority. To ensure dilution of
odor build-up, minimum recommendation is 400 cubic feet of fresh air per minute both in and out of the area.
05/02
•
REV(-)
•
PART NO. 304421-3
WE L L S MA N U FA C T U R I N G
MODEL
WV-2HG
R
R
R
LISTED
E146882
STD.4
LISTED
E146882
GRI DDLE, 2 CAST I RON ELEM ENTS
INCH
(MM)
DI M ENSIONS:
MINIMUM CLEARANCE REQUIRED FROM UNIT
TO THE NEAREST SURFACE
BACK
NA
NA
SIDE
SEE REQUIRED
SPACERS
BOTTOM
6
(152)
TOP
8
(203)
COOKING SURFACE ILLUSTRATION
AIR
EXHAUST
GRIDDLE: 17 1/4 X 18 1/4
9" DIA SOLID CAST IRON ELEMENTS
30 3/8
48 11/16
(771)
(1237)
35 3/8
REQUIRED
(898)
6" CLEARANCE
SPACERS & SIDE
SHIELDS
17 3/8
(441)
OPENING
79 1/8
(2010)
CONTROL
PANEL
21
36
(914)
(533)
27 1/16
(687)
22 3/4
(578)
6 FT. POWER
SUPPLY CORD
AND PLUG
42 3/8
(1076)
WV-2HG ELECTRICAL SPECI FICATIONS:
AMPS PER LINE 3 PHASE
MODELS VOLTS WATTS
POWER SUPPLY CORD
L1
L2
L3
WV-2HG
WV-2HG
208
240
208
240
8000
9900
8675
16
32
23
NEMA 15-60P
NEMA 15-60P
NEMA 15-60P
NEMA 15-60P
18
19
21
35
32
35
24
26
27
WV-2HGRW*
WV-2HGRW*
10800
*RW Models include optional RW-26 built-in standard double drawer warmers.
NOTE: Specifications are subject to change without notice.
SPECIAL ENVIRONMENTAL NOTICE: The hood system is designed to reduce odor emissions but will not eliminate odors.
Air exchange at the installation site must comply with requirements of the local jurisdictional authority. To ensure dilution of
odor build-up, minimum recommendation is 400 cubic feet of fresh air per minute both in and out of the area.
WELLS MANUFACTURING COMPANY
2 ERIK CIRCLE, PO BOX 280, VERDI, NV 89439 U.S.A.
USA PHONE: (775) 689-5700 • FAX: (775) 689-5972
FOR ORDERS ONLY: (888) 356-5362 • FAX: (800) 356-5142
© 2002 WELLS MANUFACTURING
•
PRINTED IN THE U.S.A.
05/02 REV(-) PART NO. 304421-2
•
•
|