Apple 073 0562 User Manual

Power Mac G4 / Macintosh Server G4  
Video Card  
Replacement Instructions  
Be sure to follow the instructions in this sheet carefully. Failure to follow these instructions  
could result in damage to your equipment and may void your warranty.  
Note: Written and video instructions covering customer-installable parts are available at  
Tools Required  
• Phillips screwdriver  
• Pliers  
Opening the Computer  
Warning: Always turn off your computer before opening it to avoid damaging its  
internal components.  
1. Place your computer on a clean, flat surface.  
2. If you think your computer is in sleep, press the power button on the front of the  
computer to wake it.  
3. Shut down your computer by opening the Special menu and choosing Shut Down.  
Then wait five minutes for the computer’s internal components to cool down.  
4. If you attached a security cable through the computer’s lockable cover latch, remove  
the cable.  
5. Unplug all other cables from the computer except the power cord.  
6. Touch the metal PCI access covers on the back of the computer. (Figure 1A)  
Important: To avoid electrostatic discharge, always ground yourself by touching the  
port access covers before you touch any parts or install any components inside the  
computer. To avoid static electricity building back up in your body, do not walk  
around the room until you have completed your installation and closed the computer.  
7. Unplug the power cord.  
073-0562 Rev. E  
• Pull the card gently to see if it is properly connected. If it resists and stays in place,  
and if its gold connectors are barely visible, the card is connected.  
4. Replace the card’s mounting screw and tighten it to secure the card.  
Closing the Computer  
1. Raise the side access panel, lift the latch, and press the panel against the case until it  
snaps securely into place.  
2. Reconnect all cables and restart your computer.  
Warning: Never turn on your computer unless all of its internal and external  
parts are in place and it is closed. Operating the computer when it is open or  
missing parts can damage your computer or cause injury.  
Apple Computer, Inc.  
© 2001 Apple Computer, Inc. All rights reserved.  
Under the copyright laws, this document may not be copied, in whole or in part, without the  
written consent of Apple.  
The Apple logo is a trademark of Apple Computer, Inc., registered in the U.S. and other  
countries. Use of the “keyboard” Apple logo (Option-Shift-K) for commercial purposes  
without the prior written consent of Apple may constitute trademark infringement and  
unfair competition in violation of federal and state laws.  
Every effort has been made to ensure that the information in this document is accurate.  
Apple is not responsible for printing or clerical errors.  
Apple Computer, Inc.  
1 Infinite Loop  
Cupertino, CA 95014-2084  
USA  
+ 1 408 996 1010  
Apple, the Apple logo, Mac, Macintosh, and the Mac logo are trademarks of Apple  
Computer, Inc., registered in the U.S. and other countries.  
Power Mac is a trademark of Apple Computer, Inc.  
Power Mac G4 Video Card - 3  
1
B
A
2
Power Mac G4 Video Card - 4  
3
C
AGP slot  
A
B
4
Power Mac G4 Video Card - 5  
5
B
B
C
A
Power Mac G4 Video Card - 6  

GE 25942 User Manual
EnGenius Technologies SN 920 User Manual
Electrolux Thermaline 9CHG584149 User Manual
Eizo FlexScan L578 User Manual 1
Dell PP14L User Manual
Dell POWEREDGE M620 User Manual
BT Glide 7163 User Manual
Autodesk XW8400 User Manual
Asus P5N E SLI User Manual
Asus Motherboard P8B75MCSM User Manual