Quick start guide
5.8 GHz Cordless
Telephone E5901/
E5902B/E5903B
with caller ID/call waiting
Installation and setup
After battery installation, the battery may have enough charge to allow some
calls. For best performance, place the handsets in the telephone base or the
charger and allow to charge for 16 hours before use.
You can keep the battery charged by returning the handsets to the telephone
base or the charger after use. When the battery is fully depleted, a recharge
takes about 12 hours. The average talk time on a fully charged battery is
about eight hours, and the standby time is approximately five days. Actual
battery life depends on usage conditions and age of battery.
1. Plug the battery securely
into the plug inside the handset
battery compartment, matching
the color-coded label.
2. Place the battery
and wires neatly inside
the compartment.
3. Slide battery compartment
cover towards the center until
it clicks into place.
4. The battery may have enough
To replace the battery,
press in and push outward
on the tab to open the bat-
tery compartment cover.
Lift out the old battery
and disconnect it from the
compartment. Follow the
instructions on this page to
install and charge the new
battery.
charge to allow for some calls.
For best performance, place
handset in telephone base or
charger to charge for at least
16 hours before first use.
Caution: Use only the supplied rechargeable battery or replacement battery (model 27910,
part number 89-0099-00-00) or equivalent. To order a replacement battery, visit our website
Quick reference guide
Cordless handset
CENTER
RIGHT
UP
LEFT
DOWN
MENU/SELECT
CID
Press to display the menu.
Once in the menu, press to
select an item or save an
entry or setting. Press the up
Press to display caller ID infor-
mation.
or down NavKey
or
to scroll up or down while in
menus. While entering names
or numbers, press the left or
right NavKey
move the cursor to the left
or right.
or
to
PHONE/FLASH
Press to make or answer a call.
During a call, press to receive
an incoming call if call waiting
is activated.
DIR
Press to display directory
entries.
MUTE/DELETE
While on a call, press to mute
microphone.
While reviewing the call log,
press to delete an individual
entry, or press and hold to clear
the caller ID log.
OFF/CLEAR
During a call, press to hang up.
While using menus, press to
cancel an operation, back up
to the previous menu, or exit
the menu display.
While predialing, press to delete
digits from a string.
REDIAL/PAUSE
Press to view redial memory.
While entering numbers, press
and hold to insert a dialing
pause.
SPEAKER
Press to activate handset
speakerphone. Press again to
resume normal handset use.
INT
Press to initiate an intercom
conversation or transfer a call.
NOTE: For more information, please refer to the user’s manual.
Quick reference guide
Feature menu
> Shows a highlighted item
Feature menu
Using menus
Press the left or down NavKey
or
>DIRECTORY
CALL LOG
DIRECTORY
CALL LOG
to scroll through menu items.
RINGER VOLUME
RINGER TONE
KEY TONE
Press MENU/SELECT to select or modify
a highlighted item.
LANGUAGE
CLR VOICE MAIL
DIAL TYPE
Press OFF/CLEAR to cancel an opera-
tion, back up to the previous menu, or
exit the menu display.
Menu
Telephone base
CHARGE
On when the cordless hand-
set is properly positioned to
charge in the telephone base.
IN USE
On when handset is in use or
when registering a handset.
Flashes while an incoming
call is ringing, when another
telephone is in use on the
same line, or when de-reg-
istering a handset from the
telephone base.
VOICEMAIL
HANDSET LOCATOR
Press to make handset(s)
beep.
Flashes when you have new
voice mail. (Requires voice
mail service subscription
from your local telephone
company.)
NOTE: For more information, please refer to the user’s manual.
Copyright © 2006 Advanced American Telephones. All rights reserved.
AT&T and the Globe symbol are trademarks of AT&T Knowledge Ventures,
licensed to Advanced American Telephones. Printed in China. Issue 2 AT&T 12/06.
96-006258-010-100
|