FEATURES
GETTING STARTED
KEYPADS
MC35
Quick Start Guide
After the AC connection is made, the charging LED indicator on the front
panel lights orange.
12 Main Battery
13 Speaker
14 Camera Lens (Optional)
15 Camera Flash (Optional)
16 Infrared (IR) Port
17 SD/MMC Expansion Slot
18 Stylus
19 Push To Talk Button
20 Power Button
21 Camera Button*
22 Battery Release Latch
1
2
3
4
5
6
Send Button
Start Button
Left Soft Button
Joystick
Right Soft Button
OK Button
7
8
9
End Button
Orange Key
Star Key
1 Install the Battery Pack
4
Install ActiveSync
follow the instructions to install ActiveSync onto the host computer.
Align the tabs on the battery pack with the groves on the MC35, then
insert the battery pack into the back of the device.
11
10
LED status during charging:
Flashing orange: Charging
Solid orange: Charging complete
10 Backlight/0 Key
11 Messaging Button
1
2
5
Connect the MC35 to a Host Computer
1
5
7
3
2
3
4
4
6
9
22
12
13
The battery pack locks to the chassis with an audible click.
14
15
2 Charge the MC35
21
20
NOTE:
5
8
7
6
Use the clip plug applicable in your country.
3
Start the MC35
After you have initially charged the MC35 for approximately eight hours,
the device is ready for use.
19
18
16
17
11
8
1
Turn on the MC35 by pressing the Power button
the right side of the device.
located on
10
9
6
Create a Partnership
Follow the onscreen ActiveSync instructions to establish a connection
between the MC35 and the computer.
1
Install the replaceable clip plug to the AC adapter. Slide the clip
plug into the clip plug holder and snap into place. The clip plug
locks to the clip plug holder with an audible click.
1
2
3
4
5
6
LCD Touch Screen
7
8
9
Connector
Microphone
Keypad
GSM Status/Notification LED
Volume Up/Down Button
Camera/Bar Code Switch
Reset Button
IMPORTANT:
Orange Key
2
3
Plug the AC adapter cable into the connector on the bottom of the
MC35.
For initial use, charge the MC35 for approximately eight hours. Thereafter,
charge the MC35 everyday to recharge the battery to full capacity. Charge
the MC35 using the USB sync cable.
* Programmable on no-camera versions.
Use this key to access the secondary layer of characters and actions.
10 Charging LED
11 Phone Speaker
> Press the
> Press the
> Press and hold the
key once to activate this mode followed by another key.
key twice to lock this mode. Press the key a third time to unlock.
key while entering characters or actions.
2
Follow the onscreen instructions on the Welcome Screen Wizard.
Connect the AC adapter power cable into an electrical outlet.
Earphone Jack
NOTE : To reset the MC35, press the reset button with the tip of the stylus.
|