User Guide ERRATA
4.PairingtheAuraMobileBT™withaMobilePhone
• Make sure that your AMBT™ is powered on.
• Power on your Bluetooth® enabled mobile phone.
• To switch to Bluetooth® mode and connect to a
Bluetooth® mobile phone, press and hold the
Mode button
until a chime sounds. Release
.
• Press and hold the Mode button on your AMBT™.
DO NOT release the Mode button until you hear
a two note chime. The “Bluetooth” indicator will
flash BOTH blue and amber. The AMBT™ is now
ready for pairing.
NOTE: If no connection is established with a Bluetooth®
mobile phone within 60 seconds, the AMBT™ will switch
to idle mode, signaled by a flashing amber “Bluetooth”
light. In this case, you must hold the
seconds until the “Bluetooth” light flashes blue and
a tone sounds. Next, hold the button once again
button for 3
until the “Bluetooth” light flashes both blue and amber.
• Follow your mobile phone’s instruction guide to
connect to a Bluetooth® device. Typically, you will
clickonaBluetooth®iconandclick“Discoverdevice.”
• Your mobile phone should find the AMBT™ which is
displayed as “BTHS”.
• Click on“BTHS”and click“OK”if your phone prompts
you to confirm.
• Your mobile phone will then prompt you to enter a
PIN or password. Enter: 0000
• If the pairing is successful, your mobile phone will
|