| For customers who purchased this product in the   USA   Important Safety   Instructions   Precautions   Specifications   Please register this product on line at   Proper registration will enable us to send you   periodic mailings about new products, services,   and other important announcements. Registering   your product will also allow us to contact you in   the unlikely event that the product needs   adjustment or modification. Thank you.   Play the unit on the power source specified in   “Specifications”.      Time display   1) Read these instructions.   12-hour System   Frequency range   Band   2) Keep these instructions.   To disconnect the AC power cord (mains lead),   pull it out by the plug, not the cord.   The unit is not disconnected from the AC   power source (mains) as long as it is connected   to the wall outlet, even if the unit itself has been   turned off.   The nameplate and important information   concerning safety are located on the bottom   exterior.   Do not leave the unit in a location near a heat   source such as a radiator or airduct, or in a   place subject to direct sunlight, excessive dust,   mechanical vibration, or shock.   3) Heed all warnings.   4) Follow all instructions.   Frequency   5) Do not use this apparatus near water.   6) Clean only with dry cloth.   FM   87.5 – 108 MHz   530 – 1 710 kHz   7) Do not block any ventilation openings.   Install in accordance with the manufacturer’s   instructions.   WARNING   To reduce the risk of fire or electric shock, do   not expose this apparatus to rain or   moisture.   To reduce the risk of fire, do not cover the   ventilation of the apparatus with newspapers,   tablecloths, curtains, etc. And do not place lighted   candles on the apparatus.   To reduce the risk of fire or electric shock, do not   expose this apparatus to dripping or splashing,   and do not place objects filled with liquids, such   as vases, on the apparatus.   AM     Speaker   8) Do not install near any heat sources such as   radiators, heat registers, stoves, or other   apparatus (including amplifiers) that produce   heat.   9) Do not defeat the safety purpose of the   polarized or grounding-type plug. A polarized   plug has two blades with one wider than the   other. A grounding type plug has two blades   and a third grounding prong. The wide blade   or the third prong are provided for your safety.   If the provided plug does not fit into your   outlet, consult an electrician for replacement   of the obsolete outlet.   10)Protect the power cord from being walked on   or pinched particularly at plugs, convenience   receptacles, and the point where they exit   from the apparatus.   11)Only use attachments/accessories specified by   the manufacturer.   Approx. 6.6 cm (2 5/8 inches) dia., 8 Ω   Power output   180 mW (at 10% harmonic distortion)   Power requirements   120 V AC, 60 Hz   Allow adequate air circulation to prevent   internal heat build-up. Do not place the unit on   a surface (a rug, a blanket, etc.) or near   materials (a curtain) which might block the   ventilation holes.   Should any solid object or liquid fall into the   unit, unplug the unit and have it checked by   qualified personnel before operating it any   further.   To clean the casing, use a soft cloth dampened   with a mild detergent solution.    For power backup: 3 V DC, one CR2032 battery   Dimensions   Approx. 178.9 × 121.8 × 88.5 mm (w/h/d)   (71/8 × 47/8 × 31/2 inches) incl. projecting parts and   controls     Do not install the appliance in a confined space,   such as a bookcase or built-in cabinet.   Mass   Approx. 638 g (1 lb 6.5 oz) incl. CR2032 battery   Do not expose the batteries (battery pack or   batteries installed) to excessive heat such as   sunshine, fire or the like for a long time.   Design and specifications are subject to change   without notice.   As the main plug is used to disconnect the unit   from the mains, connect the unit to an easily   accessible AC outlet. Should you notice an   abnormality in the unit, disconnect the main plug   from the AC outlet immediately.   NOTES ON LITHIUM BATTERY   Wipe the battery with a dry cloth to assure a    good contact.   12)Use only with the cart, stand, tripod, bracket,   or table specified by the manufacturer, or sold   with the apparatus. When a cart is used, use   caution when moving the cart/apparatus   combination to avoid injury from tip-over.   Be sure to observe the correct polarity when    installing the battery.   Do not hold the battery with metallic tweezers,    You are cautioned that any changes or   modifications not expressly approved in this   manual could void your authority to operate this   equipment.   otherwise a short-circuit may occur.   If you have any questions or problems concerning   your unit, please consult your nearest Sony dealer.   CAUTION   Danger of explosion if battery is incorrectly   replaced. Replace only with the same or   equivalent type.   13)Unplug this apparatus during lightning storms   or when unused for long periods of time.   14)Refer all servicing to qualified service   personnel. Servicing is required when the   apparatus has been damaged in any way, such   as power-supply cord or plug is damaged,   liquid has been spilled or objects have fallen   into the apparatus, the apparatus has been   exposed to rain or moisture, does not operate   normally, or has been dropped.   For the state of california, USA only   Perchlorate Material –special handling may apply, See   Perchlorate Material: Lithium battery contains   perchlorate   Troubleshooting   Should any problem occur with the unit, make   the following simple checks to determine whether   or not servicing is required.   If the problem persists, consult your nearest Sony   dealer.   This symbol is intended to alert the user to   the presence of uninsulated “dangerous   voltage” within the product’s enclosure that   may be of sufficient magnitude to constitute   a risk of electric shock to persons.   The clock flashes “AM 12:00”.   A power interruption occurred and the backup   battery is low. Replace the battery. Remove the   old battery and install a new one.    This symbol is intended to alert the user to   the presence of important operating and   maintenance (servicing) instructions in the   literature accompanying the appliance.   The buzzer, radio or melody alarm does not   sound at the preset alarm time.   Check that the buzzer, radio or melody alarm is   activated (the ALARM A (or B) indicator lights   up).    INFORMATION   The radio alarm is activated but does not   sound at the preset alarm time.   This equipment has been tested and found to   comply with the limits for a Class B digital device,   pursuant to Part 15 of the FCC Rules. These limits   are designed to provide reasonable protection   against harmful interference in a residential   installation. This equipment generates, uses and   can radiate radio frequency energy and, if not   installed and used in accordance with the   Features   Large, easy to-see, 1.4 inch green LED.   Dual alarm FM/AM Clock radio.   Various types of alarms — buzzer, radio and   melody.   Automatic time set — When you plug the clock   in for the first time, the current time will be   shown in the display.   Automatic Daylight Saving Time/Summer time   adjustment.   Check that the volume is not set to minimum.       When daylight saving time begins, the clock   does not employ the daylight saving time   automatically.    Make sure the clock is set correctly.   Press and hold DST for at least 3 seconds to   activate the automatic DST/summer time   adjustment.     instructions, may cause harmful interference to   radio communications. However, there is no   guarantee that interference will not occur in a   particular installation. If this equipment does   cause harmful interference to radio or television   reception, which can be determined by turning   the equipment off and on, the user is encouraged   to try to correct the interference by one or more    Date button to display month, day and year.   Brightness control (High/Middle/Low).   No Power No Problem™ alarm system to keep   the clock and the alarm operating during a   power interruption with a CR2032 battery   installed.   Extendable snooze — Snooze time can be   extended from 10 up to 60 minutes.   Progressive Alarm Speed (buzzer only).      of the following measures:     — Reorient or relocate the receiving antenna.   — Increase the separation between the equipment   and receiver.   — Connect the equipment into an outlet on a circuit   different from that to which the receiver is   connected.   — Consult the dealer or an experienced radio/TV   technician for help.   WARNING   Replace the battery for the clock backup with a   Sony CR2032 lithium battery. Use of another   battery may present a risk of fire or explosion.   Battery may explode if mistreated. Do not   recharge, disassemble or dispose of in fire.   Dispose of used battery promptly. Keep away   from children.      This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset   to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product.   |