zOt h e r Op e ra t io n s
To
Press
2
Press = or + to choose a track.
The track number and the playing order
appear.
3-867-524-11 (1)
Pla yin g o n ly t h e t ra cks
yo u w a n t (INTRO PGM Pla y)
Pause (main unit
only)
^
Pla yin g t ra cks re p e a t e d ly
(Re p e a t Pla y)
Track number
Flashing
Playing a CD right
away!
You can choose and play your favorite tracks
by scanning through the beginning of each
track in a CD.
Resume play after
pause (main unit
only)
^
You can play tracks repeatedly in normal,
INTRO PGM, shuffle or RMS (Random Music
Sensor) play modes. Repeat all the tracks,
only one track or the specified part within the
same track.
PLAY MODE
REPEAT/
ENTER
Find the beginning = once**
of the current track
(AMS*)
Playing order
3
4
5
Press REPEAT/ ENTER to program the
track.
If you want to play a CD right now, choose to use your player on house
current. Other choices are the following three: rechargeable batteries,
dry batteries (see “Power Sources” on the reverse side) and car battery.
PLAY MODE
REPEAT/
ENTER
Co m p a ct Disc
Find the beginning = repeatedly**
of previous tracks
(AMS)
Repeat steps 2 and 3 to program the
remaining tracks.
+
^
Press ^ .
Co m p a ct Pla ye r
“RMS” stops flashing and the tracks you
have chosen play in the order you
specified.
Find the beginning + once**
of the next track
(AMS)
1
During play, press PLAY MODE
repeatedly until “INTRO PGM” flashes.
=/+
1
Connect
If you press p, the program will be erased. To
prevent accidental erasure, set the RESUME
switch at the rear of the player to ON.
Flashing
Operating Instructions
Find the beginning + repeatedly**
of succeeding tracks
(AMS)
to a wall
outlet
To re p e a t a ll t h e t ra cks
Press REPEAT/ ENTER during play.
The “ ” indication appears.
Ab o u t a re a co d e
To cancel RMS play, press PLAY MODE until
“RMS” disappears from the display.
The area code of the player you purchased is shown on upper left of the bar
code label on the package.
Go forward quickly Hold down +**
2
3
Press ^ to start scanning.
The player plays about the first 15
seconds of each track and “INTRO PGM”
flashes faster.
For accessories supplied with your player, check the area code of your model
and refer to “Supplied accessories” toward the end of this manual.
To ch e ck t h e p ro g ra m
During programming:
Go backwards
quickly
Hold down =.**
Press REPEAT/ ENTER before step 5.
During RMS play:
Press PLAY MODE repeatedly until
“RMS” flashes, then press REPEAT/
ENTER.
*AMS = Automatic Music Sensor
**These operations are possible during both
play and pause.
To cancel repeat play, press REPEAT/ ENTER
again.
Press REPEAT/ ENTER while the track
you want is playing. To skip the track,
press + or just wait for the next track.
AC power adaptor
To re p e a t a sin g le t ra ck
1 Press REPEAT/ ENTER while the track you
want to repeat is playing.
Each time you press REPEAT/ ENTER, the
track number and the playing order appear in
the order you specified.
After you have gone through the CD,
“INTRO PGM” stops flashing and the tracks
you have chosen play automatically.
If you press REPEAT/ ENTER on the player to
display “
”, you can locate the tracks
continuously in the following order:
• When using +: next track n next track
...... last track n first track n second track
......
• When using =: previous track n
previous track ...... first track n last track
......
The “
” indication appears.
Headphones
Note
To finish programing before going through
the whole CD, press ^. The selected tracks
will be played.
• If you program another track after the 22nd
track, the first track programed is cleared and
the new track is programed instead.
If you press p, the program will be erased.
To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
2 Press PLAY MODE repeatedly until “1”
appears.
DC IN 4.5 V
To re m o ve t h e CD
Remove the CD while pressing the pivot.
Usin g o t h e r fu n ct io n s
To cancel INTRO PGM play, press PLAY
MODE repeatedly until the play mode
indication disappears from the display.
D-E561
D-E565
To m in im ize skip p in g (ESP2)
The ESP (Electronic Shock Protection)
function minimize skipping by using a buffer
memory that stores music data and plays it
back in the event of a shock.
2/REMOTE
To repeat another track, press = or + .
For models supplied w ith the remote control
• Connect the plug of the headphones to the remote control.
Sony Corporation ©1999 Printed in Malaysia
To cancel repeat play, press REPEAT/ ENTER
again.
The new ESP2 (ESP Squared) system uses a
new DSP (Digital Signal Processor) which can
read and store music data more efficiently,
providing a level of continuous skip
protection not found in traditional buffer
memory units. This decreases the frequency
of sound skipping and the need to utilize the
buffer memory. Use this function when
listening in a car or while walking.*
Pla yin g t ra cks in ra n d o m
o rd e r (Sh u ffle Pla y)
• Connect the headphones to the remote control firmly. A loose connection may cause noise
during playback.
To re p e a t t h e sp e cifie d p a rt w it h in
t h e sa m e t ra ck (LOOP Pla y)
1 During play, press PLAY MODE
repeatedly until “A˜B” flashes in the
display.
You can play the tracks in a CD in random
order.
Fo r t h e cu st o m e rs in t h e USA
We lco m e !
Notes on controlling the volume w ith
the remote control
Set the VOL (volume) control on the remote
control to the maximum. Then adjust the
volume on the player to the level that you
want to be the maximum volume of the
remote control.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
PLAY MODE
2
3
Thank you for purchasing the Sony
Compact Disc Compact Player.
Before operating your player, please
read this manual and retain it for
future reference.
Place a CD
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
Flashing
* Although ESP2 provides excellent protection
against skipping, it will not prevent skipping
while jogging or running.
ESP
Notes on display
• When you press ^ or ( (when RESUME
is set to OFF), the total number of tracks in
the CD and the total playing time appear for
about 2 seconds.
• During play, the track number and the
elapsed playing time of the current track
appear.
• During pause, the elapsed playing time
flashes in the display.
• Between tracks, the time to the beginning of
the next track will appear with the “–”
indication.
Ab o u t t h is m a n u a l
2 Press REPEAT/ ENTER to set the point
(point A) where you want to start repeat
play.
During play, press PLAY MODE repeatedly
until “SHUF” appears.
The tracks play in random order.
The instructions in this manual are for the
D-E561 and D-E565. Before you start reading,
check your model number.
Point A is stored in the memory.
Light up
Flashing
Ow n e r’s Re co rd
The model and the serial numbers are located at
the bottom. Record these numbers in the spaces
provided below. Refer to them whenever you
call upon your Sony dealer regarding this
product.
Press ESP.
The ESP indication appears.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
To cancel shuffle play, press PLAY MODE
repeatedly until the play mode indication
disappears from the display.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/ TV
technician for help.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
3 Press REPEAT/ ENTER again to set the
point (point B) where you want to stop
repeat play.
Point B is stored in the memory, and repeat
play starts from point A.
Notes on handling CDs
• To keep the CD clean, handle it by its edge.
Do not touch the surface.
• Do not stick paper or tape onto the CD.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts. Do not
leave the CD in a car parked under direct
sunlight.
Model No. __________ Serial No.__________
Note
To release the ESP function, press ESP again.
Label side up
OPEN
• During shuffle play, you cannot return to
previous tracks by pressing = .
Notes
• Playing may stop when the player gets a strong
shock even with the ESP function on.
• You may hear a noise or sound skip when:
— listening to a dirty or scratched CD,
— listening to an audio test CD or,
— the player receives continuous shock.
• Sound may drop for a while if you press ESP
during play.
1Slide OPEN to open the lid.
WARNING
2Fit the CD to the pivot.
3Close the lid.
Light up
To p re ve n t fire o r sh o ck
h a za rd , d o n o t e xp o se
t h e u n it t o ra in o r
m o ist u re .
Pla yin g t ra cks in t h e o rd e r
yo u w a n t (RMS p la y)
Fo r t h e cu st o m e rs in Au st ra lia
The supply cord of the AC power adaptor cannot
be replaced; if the cord is damaged, the AC
power adaptor should be discarded.
You can program up to 22 tracks to play in
any order you choose.
Play
• When you use an optical digital connecting
cord, the ESP function will be disabled.
To change points A and B, press and hold
REPEAT/ ENTER until “A˜B” flashes in the
display, then do steps 2 and 3 again.
To a vo id e le ct rica l
sh o ck, d o n o t o p e n t h e
ca b in e t . Re fe r se rvicin g
t o q u a lifie d p e rso n n e l
o n ly.
PLAY MODE
REPEAT/
ENTER
Fo r t h e cu st o m e rs n o t in Eu ro p e
The CE mark on the unit is valid
only for products marketed in the
European Union.
To u se t h e re m o t e co n t ro l
To e n jo y m o re p o w e rfu l b a ss so u n d
(So u n d fu n ct io n )
You can enjoy a powerful bass-boosted sound.
1 Press ^.
To set points A and B on other tracks, press
= or + to select another track, then do
steps 2 and 3 again.
SOUND
1 Press (.
^
=/+
If you press p, the stored points will be
erased. To prevent accidental erasure, set the
RESUME switch at the rear of the player to
ON.
CAUTION
The use of optical instruments with this product
will increase eye hazard.
1
During play, press PLAY MODE
repeatedly until “RMS*” flashes.
Not these ways
Flashing
To cancel repeat play, press PLAY MODE
until “A˜B” disappears from the display.
2 Adjust the volume.
Press SOUND to select “MB (Mega Bass)” or
“GRV (Groove).” “GRV” is more effective.
2 Adjust the volume.
Note
• If the sound is distorted when emphasizing
bass, turn down the volume.
*RMS = Random Music Sensor
To stop play, press p.
Continue to the reverse side m
|