Reporter Set Motorola 2700
portable version
- operation manual -
Thank you for using a GSM interface in your broadcast system. This digital cellular telephone interface is designed for use
in the GSM (Global System for Mobile communications) network. GSM is the international standard for cellular communi-
cation, available in most European countries and many other parts of the world.
This product is in conformance with the CE approvals for GSM applications of the European Community.
Please, read the manual!
portable broadcast unit manual V 1.0
1
Reporter Set Motorola 2700 portable version
front panel view:
SIM cardreader
tape in
mic & phone connector
microphone mute
take over switch
handset
audio connectors LF active
phone
volume
mic mute
The green LED on the rear panel is the charge control for the internal battery and
indicates an external power supply.
rear panel view:
male 25pin Sub-D connector
speaker
battery charger or
cigaret lightning cable
connectors:
-
-
-
-
-
BNC
GSM antenna 900 MHz
handset Motorola 2700
microphone / headphone
tape in
RJ 45 plug
5 pol. XLR
3 pol. XLR
male
25pin Sub-D
plug-in power supply for battery charging
and permanent operation (optional)
cigarette lighter cable for battery charging
and permanent operation (optional)
portable broadcast unit manual V 1.0
3
Reporter Set Motorola 2700 portable version
technical data:
microphone in:
impedance
sensitivity
-
-
200 ohm
variable from 0,5mV – 5mV
headphone out:
tape in:
impedance(recommended) - 300 Ohm
volume
-
adjustable
amplifier capacity
impedance
sensitivity
-
-
-
10 mW
50 KOhm
variable from 100mV - 1V
power consumption:
dimensions:
-
stand by appro. 300 mA
max. 1500 mA
250 mm
95 mm
200 mm
length
breadth
height
-
-
-
-
weight:
appr. 3,6 kg (incl. battery,
bag, telephone and handset)
All audio in- and outputs are balanced and groundfree.
The seizure of the audio connectors is conform to the ARD specification no.: 3/1-8/2:
5 pol. female XLR audio connector
(both connectors parallel)
Pin 1 - shield
3 pol. female XLR audio connector
(aux in)
Pin 1 - shield
Pin 2 - microphone
Pin 3 - microphone
Pin 2 - LF (voice frequency signal)
Pin 3 - LF (voice frequency signal)
Pin 4 - headphone
Pin 5 - headphone
* NOTICE !
* The Reporter Set operates with radio signals which might be subject to interference
* to persons and equipment.
* It is recommended to use the interface with an external antenna outside of the
* building for avoidance of interferences to other electronic equipment.
portable broadcast unit manual V 1.0
4
|