Hearing experts advise against the constant use of personal stereos played
at high volume. Constant high volume use can lead to hearing loss. If you
experience ringing in the ears or hearing loss, discontinue use and seek
medical advice.
BATTERY OPERATION (BATTERIES NOT INCLUDED)
Your unit operates on two(2)AA size alkaline batteries. Open the
CD cover and insert the batteries in the battery compartment
following the polarity diagram located inside.
Read the instruction manual before operating this unit.
Do not expose the unit to high temperature or humidity.
Use dampened soft cloth to clean the unit. Do not use strong
detergent or solvent to clean the unit.
PORTABLE CD PLAYER
.
To remove the disc from its storage case, press down on the center of
Consult your dealer if you are ever in doubt about the
the case and lift the disc out. Hold it carefully by the edges as shown
below.
CX-CD114
operation or safety of your equipment
installation,
DC IN JACK
DBBS FUNCTION
HOLD SWITCH
DBBS SWITCH
PHONE JACK
DBBS FUNCTION
The Dynamic Bass Boost System(DBBS) enhances the
low frequency(Bass) response of the output.
Set the Volume to low listening level and set DBBS switch to ON .
114
Insert the disc into the unit with the label of the disc facing UP.
Gently wipe the disc using a soft cloth from the center to the outer
direction to remove dust, fingerprints or any other particles on the
disc surface. Never use chemicals, such as record sprays , anti-static
sprays, benzene or thinners to clean the CD. These chemicals can
damage the disc surface permanently.
Note: Some CD'S with DBBS may exceed the bass response
capacity and can cause distortion.
VOLUME CONTROL
To avoid this , do not play DBBS in high volume.
Playing DBBS in high volume may cause damage to the
headphone and more importantly, to your hearing.
To avoid serious scratches on CD, keep them in the cases after each
use. Scratches can cause the laser pick-up skip in the future play.
Do not place stickers or write anything on the disc.
PRG BUTTON
MODE BUTTON
FF
BUTTON
REW
BUTTON
PLAY/PAUSE BUTTON
STOP BUTTON
OPEN BUTTON
RAN BUTTON
LCD Display
PROGRAM PLAY
(4)LCD screen will display "Er" if the unit cannot
read CD track data.
The CD mechanism and the sensitive circuitry may cause interference
to a radio tuner nearby. Do not operate this unit while operating other
radio devices.
During play, press and hold FF
REW ) button to fast forward (or
fast reverse) the current track.
(or
1. Press PROG button, the screen is read as:
2. Press FF/REW button to get the desired track.
(5)When CD track data has been read, LCD
screen will display the last track number
with the total play time.
(1) Press FF
desired track# . Press PLAY/PAUSE
button to play. Press FF (or REW
(or REW
)button to set the
Danger
This product utilizes invisible laser
REPEAT ONE TRACK
(1) Press MODE button once to repeat current track.
(2) Repeat one indicatior appears.
3. Press PROG to confirm, 01turns to 02.
it is ready to make next selection.
radiation. Avoid direct exposure to
)
1
Press FF button
the beam.
button to change the track # during the play
mode.
4. Repeat the above steps to edit up to 20 tracks.
Press PROG button to check program list.
Caution
Use of controls, adjustments or procedures not listed in
this manual may result in hazardous radiation exposure.
(6)Unit will start play from track No.1
automatically.
REPEAT ALL TRACKS
(1) Press MODE button twice to repeat all tracks.
(2) Repeat all indicatior appears.
ALL
General
5. Press PLAY/PAUSE button to start playback.
Maximum Output (Stereo Headphone..15mW+15mW(32ohm)
2
6. To stop program playback, press STOP button.
COMPACT
INTRO FUNCTION
Only compact discs identified with this mark can
be used with this player.
(2) During play, press REW
previous track.
button to play
7.To erase memory, open the CD door or cut off power.
The player will play each track for a few seconds.
(1) Press MODE button the third time,
Press STOP( )button to stop play,
and the last track Number will display.
DIGITAL AUDIO
Press REW button at the head of NO.4
NOTE: Repeat/Intro function works also under the program play mode.
INTRO indicator appears flashing.
INTRO
DC.................................................. 3V with 2 size "AA" Batteries
(2) Press PLAY/PAUSE button to start INTRO play and
INTRO indicator turns still.
(1)
is displayed when the battery voltage
reaches low.
Press PLAY/PAUSE( )button to pause
on/off alternately.
5.1"x 1.1"x 5.9"(WHD)
RANDOM FUNCTION
The player will start playback in an random order.
Time display will flash on pause mode.
(1)Press PLAY/PAUSE (
the power on.
)button to turn
(1) Press RAN button the fourth time,
(2) When the voltage is too low, the unit will
automatically turn off.
RAND
(3) During pause mode, press FF
(or REW
)
RAND indicator appears flashing.
(2) Press PLAY/PAUSE button to start RANDOM play .
RAND indicator turns still.
button to play the next track (or previous track).
The unit will keep in pause mode and time
display will flash.
(2)LCD screen will display "diSC" if CD is not
in the unit.
NOTE: To quit REPEAT/INTRO/RAN mode, just keep pressing MODE
button till funnction indicator disappears from the screen.
|