Quick-Use Guide
There are several ways to connect your new LCD TV Monitor to your other
equipment. This Quick-Use Guide shows the easiest most common connection.
Cable TV signal from
the Cable Company
2
1
OUTPUT
CH
3
4
CABLE
IN
TO TV
75Ω
Coaxial
Cable
3
TV
TV
S-VIDEO
VIDEO
DC IN
ANALOG
1
2
AUDIO OUT
75Ω jack on rear
AUDIO
of Television
Cable Box with RF In/Out Jacks
This connection will not supply Stereo sound to the LCD TV Monitor. The sound from the Cable
Box will be monaural (single-channel, not left and right).
Connect the Cable TV signal to the IN jack (or RF IN or CABLE IN) on the Cable
Box.
1
Connect an RF coaxial cable (not supplied) to the OUT jack (or TO TV or RF OUT)
of the Cable Box.
2
3
4
Connect the other end of the coaxial cable to the TV jack on the LCD TV Monitor.
Screw it down finger tight.
Set the Channel 3/4 (or Output channel) switch of the Cable Box to 3 or 4. Set the TV to
the same channel. When watching TV programming, change channels at the Cable Box,
not the LCD TV Monitor.
NOTE: To see how to make other connections, please refer to the Owner’s
Manual.
|
Sunbeam PB7610 User Manual
Sony TRV840 User Manual
Sony Handycam DCR DVD200E User Manual
Sony DCR HC85 User Manual
Sony Cyber shot DSC W560 User Manual
Sony Camcorder CX290 User Manual
Sharp Viewcam VL Z5S User Manual
Sanyo VCC 4594 User Manual
Samsung SMX F50SP User Manual
Samsung Camcorder DV300 User Manual