XE-A206 Quick Start Guide
English
The following describes how to get the cash register ready for operate. Follow these steps before you use the cash register for the first time.
Before you set up the cash register, prepare three new alkaline batteries LR6 ("AA" size) which are necessary for memory backup. Find a stable and flat surface not subject to direct radiation, to place
the cash register.
(for receipt printing)
Initializing the Cash Register
Installing the Paper Roll
1
3
To ensure the cash register operates properly, please use the following
procedure:
If you want to use a paper roll for journal printing, please refer to GETTING
STARTED section of the instruction manual.
REG
1. Make sure the power cord is unplugged and batteries are not
OPX/Z
OFF
MGR
X1/Z1
X2/Z2
1. Lift up the print roller release lever to unlock and open the print roller arm.
Print roller arm
installed on the register.
VOID
PGM
2. Insert the manager (MA) key into the mode switch and turn it to the
REG position.
3. Insert the plug of the power cord into the AC outlet. The buzzer will
Print roller release lever
sound three times.
2. Set a paper roll in the paper roll cradle as illustrated right.
IMPORTANT: This operation must be performed without batteries installed.
To the printer
Correct
NOTE: When setting a new paper roll in the paper roll cradle, be sure to cut
the paper end behind the taped (or pasted) point in advance.
4. The cash register has now been initialized.
The register display will show “0.00” with “ ”.
To the printer
Incorrect
3. Feed the end of the paper along with the paper positioning guides
as illustrated at the right.
Installing the Batteries
2
Paper positioning
guides
1. Push the printer cover forward and detach it.
2. Open the battery compartment cover next to the paper roll cradle.
4. While holding down the paper, slowly close the print roller arm, and
push down the arm until you hear a click locking the arm.
Make sure you securely push down the center of the wing part of the
arm as illustrated at the right. The paper will be fed automatically.
3. Install three new alkaline batteries LR6 (“AA” size) as shown at the
right. (Batteries are not supplied with the cash register.) Make sure
that positive (+) and negative (–) poles of each battery are properly
oriented.
5. Cut off the excess paper using the edge of the inner cover, and
replace the printer cover. Press the
key to make sure the paper
F
end comes out of the printer cover and clean paper appears.
NOTE: If the print roller arm is not securely locked, the unit will not print correctly.
If this problem occurs, open the arm, and close the arm as instructed
above.
4. When the batteries are properly installed, “ ” on the display will
disappear. Close the battery compartment cover.
|