USER’S INFORMATION MANUAL
®
Models HD101–HD401
Type H
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life.
AVERTISSEMENT: Assurez-vous de bien
suivres les instructions données dans cette
notice pour réduire au minimum le risque
d’incendie ou d’explosion ou pour éviter tout
dommage matériel, toute blessure ou la mort.
Do not store or use gasoline or other flammable
vapors and liquids or other combustable
materials in the vicinity of this or any other
appliance. To do so may result in an explosion
or fire.
Ne pas entreposer ni utiliser d’essence ni
d’autres vapeurs ou liquides inflammables dans
le voisinage de cet appareil ou de tout autre
appareil.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE
WHAT TO DO IF YOU SMELL GAS:
GAZ:
•
•
Do not try to light any appliance.
Do not touch any electrical switch; do
not use any phone in your building.
Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
•
•
Ne pas tenter d’allumer d’appareils.
Ne touchez à aucun interrupteur. Ne pas
vous servir des téléphones dansle bâtiment
où vous vous trouvez.
•
•
•
Appelez immédiatement votre fournisseur
de gaz depuis un voisin. Suivez les
instructions du fournisseur.
Si vous ne pouvez rejoindre le fournisseur
de gaz, appelez le sservice des incendies.
•
If you cannot reach your gas supplier,
call the fire department.
Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
L’installation et l’entretien doivent être assurés
par un installateur ou un service d’entretien
qualifié ou par le fournisseur de gaz.
CATALOG NO. 1000.521
Effective: 05-05-09
Replaces: NEW
P/N 241368 Rev. 1
3
Component Locations
Fig. 2: Component Locations – Left Side
Fig. 1: Component Locations – Angle
Fig. 3: Component Locations – Front
4
13. Check air filter and replace if necessary.
MAINTENANCE
Daily:
Suggested Minimum
1. Check that heater area is free from combustible
materials, gasoline, and other flammable vapors
and liquids.
Maintenance Schedule:
Regular service by a qualified service agency and
maintenance must be performed to ensure maximum
heater operating efficiency. Maintenance as outlined
below may be performed by the owner.
2. Check for and remove any obstruction to the flow
of combustion or ventilation air to heater.
Monthly:
Yearly (Beginning of each heating
season):
1. Check for piping leaks around circulators, mixing
valves, relief valves, and other fittings. If found,
repair at once. DO NOT use petroleum-based stop
leak compounds.
1. Annual service call by qualified service agency.
2. Visually check top of vent for soot. Call service
person to clean. Some sediment at bottom of vent
is normal.
2. Visually inspect burner flame.
3. Visually inspect venting system for proper func-
tion, deterioration or leakage.
3. Visually inspect venting system for proper func-
tion, deterioration or leakage.
4. Check air vents for leakage.
4. Check that heater area is free from combustible
materials, gasoline, and other flammable vapors
and liquids.
Quarterly:
1. Check relief valve. Refer to manufacturer’s
instructions on valve.
5. Check for and remove any obstruction to the flow
of combustion or ventilation air to heater.
2. Test low water cut-off, if used. Refer to manufac-
turer’s instructions.
6. Follow pre-start-up check in the Initial Start-up
section.
3. Check the air filter; replace if necessary.
7. Visually inspect burner flame. Should see light
blue flame. Visually inspect hot surface igniter for
damage, cracking or debris build-up.
8. Check operation of safety devices. Refer to manu-
facturer’s instructions.
9. Follow oil-lubricating instructions on circulator (if
required). Over-oiling will damage circulator.
Water-lubricated circulators do not need oiling.
10. To avoid potential of severe burn, DO NOT REST
HANDS ON OR GRASP PIPES. Use a light touch
- return piping will heat up quickly.
11. Check blower and blower motor. Clean and oil as
necessary.
12. Check for piping leaks around circulators, relief
valves and other fittings. Repair, if found. DO NOT
use petroleum based stop leak.
5
6
7
Raypak, Inc., 2151 Eastman Avenue, Oxnard, CA 93030 (805) 278-5300 Fax (805) 278-5468
Litho in U.S.A.
|