4. Set your mobile phone to search for Bluetooth devices.
Owner’s Manual
Location of controls
Using your Bluetooth Headset
Wearing your Bluetooth Headset
Safety information
Warranty information
Powering ON/OFF
Bluetooth: Enabled
• Check local laws regarding use of a mobile handset and wireless
headset while driving. If you use the Bluetooth Headset while
driving, ensure your attention and focus remains on your driving.
• Observe all signs in the designated areas where some electronic
devices or RF radio products are required to be switched off.
These could include airplanes, hospitals, blasting areas, and
potentially explosive atmospheres.
Limited Warranty
• To turn ON, press and hold the [POWER] button until the
In the unlikely event that this product is defective, or does
not perform properly, you may within ninety (90) days from
your original date of purchase return it to the authorized
service center for repair or exchange.
Paired Devices:
*Empty *
blue indicator light turns on.
• To turn OFF, press and hold the [POWER] button until the
RED LED indicator light flashes 3 times, and then shuts off.
Indicator light
Searching for devices
TO OBTAIN WARRANTY SERVICE:
• Provide proof of the date of purchase within the package
(Dated bill of sale).
[VOLUME DOWN]
Charging port
1 found
Stop
[VOLUME UP]
• Prepay all shipping costs to the authorized service center,
and remember to insure your return.
• Include a return shipping address (no P.O. Boxes),
a telephone contact number, and the defective unit within
the package.
Answering/Ending a call
• To answer a call, press and release the [POWER] button.
• To end a call, press and release the [POWER] button.
CAUTION: Although this device enables drivers to
conduct handsfree conversations, it is still dangerous
to drive and use a mobile phone at the same time.
Always keep your full attention on your driving.
[POWER]
ON/OFF
Answer/end a call
5. When the phone finds the headset,confirm by selecting
EM237C from the list.
Microphone
• Describe the defect or reason you are returning the product.
Charging the Bluetooth Headset
Adjusting the volume
Press the [VOLUME UP] or [VOLUME DOWN] button to adjust
the volume to the desired level.
Bluetooth: Enabled
Your product will be repaired or replaced, at our option, for the same
or similar model of equal value if examination by the service center
determines this product is defective. Products received damaged
as a result of shipping will require you to file a claim with the carrier.
Product maintenance
Paired Devices:
EM237C
1. Connect the smaller end of the USB cable to the charging
port of the headset.
• Power off this product when not in use.
NOTE: You may also adjust the volume from your mobile phone’s
volume control.
2. Connect the other end of the USB cable to either the:
� • AC Charger, and plug into a wall (A/C) outlet.
� • Computer’s USB port.
• DO NOT expose this product to water or other liquids.
• DO NOT use abrasive cleaning solvents to clean theBluetooth Headset.
• If you will not use the Bluetooth Headset for long periods,be sure to
store it in a dry place, free from extreme temperature,humidity and dust.
For the best audio quality, always wear your Bluetooth
Headset on the same side of the body as your mobile phone.
Select Device:
The shipping address of the authorized service center is:
EM237C
Cancel
Southern Telecom Inc.
ATTN: Returns Department
14-C 53rd Street
• Car Charger
To make a call
Dial the number and press the send button on your mobile
phone, the call is automatically transferred to the headset.
3.The RED LED indicator light turns on.
4.The RED LED indicator light shuts off when the headset is
fully charged (approximately 4 hours).
Troubleshooting tips
Brooklyn, NY 11232
FCC and telephone company information
6. Enter passcode“0000”when prompted by the phone.
®
I cannot get the Bluetooth Headset into Pairing Mode
FCC Part 15
Bluetooth: Enabled
Should you have any questions or problems concerning this
product, please contact our customer service department at:
NOTE: When the battery is running low,the RED indicator light starts
This equipment has been tested and found to comply with the
requirements for a Class B digital device under Part 15 of the
Federal Communications Commission (FCC) rules. These
requirements are intended to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Paired Devices:
EM237C
Make sure the Bluetooth Headset is turned off before
beginning the pairing process.
to flash.
•
•
Wireless Headset
1-877-768-8483 (Toll Free)
Monday - Thursday: 9AM - 5PM (EST)
Friday: 9AM - 3PM (EST)
or
Enter numeric passkey
for EM237C:
Press and hold the [POWER] button until the RED and BLUE
lights flash alternately, this will signal that the headset is in
Pairing Mode, and ready to connect to your mobile phone.
USB Cable
0000
OK
Model: EM-237C
via e-mail at
My mobile phone is not able to pair with the Bluetooth Headset
AC Charger
Rejecting an incoming call
To reject an incoming call, press and HOLD the [POWER]
button until you hear the confirmation tone.
7. Your mobile phone will confirm that the pairing was completed,
and prompt you to accept the connection. Please respond
YES to connect the headset to your mobile phone. If the pairing
was successful,the headset’s indicator light flashes a steady blue.
Warranty service not provided
Make sure that you fully charged the headset before pairing.
Keep your Bluetooth Headset and mobile phone within 3
feet of each other during the pairing process.
•
•
In the box
This warranty does not cover damage resulting from accident,
misuse, abuse, improper installation or operation, lack of reasonable
care, and unauthorized modification. This warranty is voided in
the event any unauthorized person opens, alters or repairs this
product. All products being returned to the authorized service
center for repair must be suitably packaged.
Charging port
USB port
• Re-orient or relocate the receiving antenna.
Check that your phone’s Bluetooth feature is turned ON.
Try repeating the pairing process, see“Pairing the headset
with a Bluetooth enabled phone.”
•
•
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Bluetooth: Enabled
Headset
PC
Redialing the last number called (Dependent
on your phone supporting this feature)
Press the [VOLUME DOWN] button for 3 seconds, and
release.The last number called will be redialed.
Paired Devices:
EM237C
Limitation of Warranty:
• Consult the dealer or an experienced radio/TV technician for help.
• THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE
HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION
GIVEN BY SOUTHERN TELECOM INC. IT’S AGENTS, OR EMPLOYEES
SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE
SCOPE OF THIS WARRANTY.
Do not attempt to repair or modify this equipment.
Warning: Changes or modifications to this equipment not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
After successfully pairing my mobile phone and Bluetooth
Headset,when I shut my phone and turn it on again, my
headset did not automatically connect
Confirm connection to
EM237C?
Car Charger
Car Charger
YES
NO
/
NOTE: Make sure you charge your headset for 4 hours before
Voice dial (Dependent on your phone support-
ing this feature)
During the Standby Mode, press and HOLD the [POWER]
button until you hear the confirmation tone, and then say a
name from your phone’s contact list.
using it for the first time.
Try turning the headset OFF, and then turning it ON again.
•
•
Industry Canada
• REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY
IS THE EXCLUSIVE REMEDY OF THE CONSUMER. SOUTHERN
TELECOM INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS
OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER
OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED
BY THE LAWS OF THE STATE OF NEW YORK. EXCEPT TO THE
EXTENT PROHIBITED BYAPPLICABLE LAW, ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY
PERIOD SET FORTH ABOVE.
Bluetooth Headset
Owner’s Manual
Many mobile phones have an auto reconnect option when first
attempting to reconnect to a newly paired Bluetooth device.
Make sure you accept this option, so that your Bluetooth Headset
automatically reconnects to your mobile phone;check the user
guide of your mobile phone for more information regarding
this option.
Operation is subject to the following two conditions: (1) This
device may not cause interference and (2) This device must
accept any interference, including interference that may
cause undesired operation of the device.
Pairing the headset with a Bluetooth enabled phone
8. When attempting to reconnect the headset to your mobile
phone, you may see the message below, and your mobile
phone will prompt you to accept the connection request to
the EM237C headset, and an option not to ask this again.
Please accept the connection, and if you select“Don’t ask this
again”, your phone will automatically accept future connection
requests from your Bluetooth Headset.
1. Make sure the Bluetooth Headset is turned off.
2. Keep your Bluetooth Headset and mobile phone within 3
feet of each other during the pairing process.
3. Press and HOLD the [POWER] button until the RED and BLUE
lights flash alternately.
®
Wireless Headset
Transferring calls
The term“IC:”before the certification/registration number
only signifies that registration was performed based on a
Declaration of Conformity indicating that Industry Canada
technical specifications were met. It does not imply that
Industry Canada approved the equipment.
Model: EM-237
To transfer calls between your Bluetooth Headset and
phone during a conversation, press and HOLD the
[VOLUME UP] or [POWER] button (depending on the type
of mobile phone you have) until you hear the confirmation
tone. To transfer the call back to the Bluetooth Headset
press and HOLD the [VOLUME UP] or [POWER] button
once again until you hear the confirmation tone.
Try unpairing the headset from your phone,and repeat the pairing
procedure
•
AC Charger
USB Charging Owner’s
Cable Manual
Bluetooth: Enabled
Some states do not allow the exclusion nor limitation of incidental
or consequential damages, or limitations on how long an implied
warranty lasts so the above limitations or exclusions may not apply
to you. This warranty gives you specific legal rights, and you also may
have other rights that vary from state to state.
Paired Devices:
EM237C
Indicator light
I hear distortion, and the sound quality is poor
Accept connection request
from EM237C?
Drive Safe
For the best audio quality,always wear your Bluetooth Headset
on the same side of the body as your mobile phone.
•
•
YES
NO
Driving while talking on your mobile phone is dangerous, and
illegal in many states.
/
within 3 feet
Microphone mute
Don’t ask this again
Check that the battery is charged enough.
The sound is very low
Press and HOLD the [VOLUME DOWN] and [VOLUME UP]
buttons simultaneously until you hear the confirmation
tone. The microphone of your Bluetooth Headset will be
mute. While it i s in Mute Mode, your Bluetooth Headset
will beep every 5 seconds. To cancel mute mode, press and
HOLD the [VOLUME DOWN] and [VOLUME UP] buttons
again until you hear the confirmation tone.
Although this device enables drivers to conduct handsfree
conversations,it is still dangerous to drive and use a mobile phone
at the same time.
[POWER]
(Press & HOLD)
Manufactured by Southern Telecom Inc. Brooklyn, NY11232
© 2009 Southern Telecom Inc. All rights reserved.
Emerson and the G-Clef logo are registered trademarks of
Emerson Radio Corp. Parsippany, New Jersey USA.
The Bluetooth® word mark and logos are owned by the Bluetooth
SIG, Inc.
NOTE: The screenshots above are typical of many Bluetooth enabled
phones in the market today, and are used to assist in the
explanation of the pairing process.Your mobile phone’s
interface and interaction with the Bluetooth Headset may
slightly differ from the illustrations above.
We recommend pulling over before making or answering calls,
especially during adverse driving conditions. Please use your
mobile phone, and our product responsibly while driving!
NOTE: To enter the Pairing Mode,you must press and HOLD the
Try adjusting the volume by using the [VOLUME UP] or
[VOLUME DOWN] button on your headset; make sure the
volume on your mobile phone is turned up as well.
•
power button for approximately 10 seconds.
|