69PTKH00143; 69PTKH00144;69PTKH00185
69PTKH0014C; 69PTKH0015K
PEX Crimp Tool
How to use:
1
2
3
1. Cut tubing end squarely.
Check for and remove any
burrs.
2. Slide crimp ring over end
of tubing. Insert fitting into
end of tubing until it stops.
Position the crimp ring
1/8" to 1/4" from the end
of the tubing and over the
ribs of the fitting.
3. Place the crimping end of
tool around the crimp ring
and press the handles
together.
For 69PTKH0015K
4
To remove and replace crimp heads:
1
2
3
1. With the handles.
2. Slide jaw out of
position and
remove.
3. With the side
release spring
4. Check for proper crimp
with the Go/ No-Go
gauge.
fully open, press
side release spring
upward until the
hook is above the
jaw pin.
pressed upward,
slide new jaw into
place and release
the spring.
Matthews, NC 28105
69PTKH-I_12/1/11
|