MAYTAG MGR8800F User Manual

30" (76.2 cm) Freestanding Gas Range  
PRODUCT MODEL NUMBERS  
MGR8800F  
PRODUCT DIMENSIONS  
GAS SUPPLY REQUIREMENTS  
Type of Gas:  
Natural Gas:  
F
This range is factory set for use with Natural gas. See “Gas  
Conversions” section. The model/serial/rating plate is located on  
the oven frame behind the top right-hand side of the oven door has  
information on the types of gas that can be used. If the types of gas  
listed do not include the type of gas available, check with the local gas  
supplier.  
LP gas conversion:  
Conversion must be done by a qualified service technician.  
C
A
No attempt shall be made to convert the appliance from the gas  
specified on the model/serial/rating plate for use with a different gas  
without consulting the serving gas supplier. See “Gas Conversions”  
section.  
B
Gas Supply Line  
3
4
Provide a gas supply line if / " (1.9 cm) rigid pipe to the range  
location. A smaller pipe on longer runs may result in insuffient  
1
2
gas supply. With LP gas, piping or tubing size can be / " (1.3 cm)  
minimum. Usually, LP gas suppliers deteremine the size and materials  
used in the system. NOTE: Pipe-joint compounds that resist the  
action of LP gas must be used. Do not use TEFLON tape.  
E
Flexible metal appliance connector:  
D
If local codes permit, a new CSA design-certified, 4 to 5 ft  
1
3
2
4
(122 to 152.4 cm) long, / " (1.3 cm) or / " (1.9 cm) I.D. (inside  
diameter), flexible metal appliance connector may be used for  
connecting range to the gas supply line.  
7
8
A. 27 / " (70.8 cm) max. depth with handle  
B. 36" (91.4 cm) cooktop height (max.)  
with leveling legs screwed in all the way*  
1
8
C. 47 / " (119.7 cm) overall height (max.)  
with leveling legs screwed in all the way*  
1
7
2
A / " (1.3 cm) male pipe thread is needed for connection to the female  
8
D. 29 / " (75.9 cm) width  
7
pipe threads of the inlet to the appliance pressure regulator.  
16  
E. 25 / " (64.6 cm) depth. Back of range  
to front of cooktop**  
Do not kink or damage the flexible metal tubing when moving the  
range.  
F. Model/serial/rating plate (located on the oven  
frame behind the top right-hand side of the oven door)  
Must include a shutoff valve:  
* Model/serial/rating plates may be rotated up from behind the control  
panel for viewing front the front of the range.  
The supply line must be equipped with a manual shutoff valve. This  
valve should be located in the same room but external to the range  
opening, such as an adjacent cabinet. It should be in a location that  
allows ease of opening and closing. Do not block access to shutoff  
valve. The valve is for turning on or shutting off gas to the range.  
** Front door and drawer may extend farther forward, depending on  
styling.  
B
A. Gas supply line  
B. Shutoff valve “open” position  
ELECTRICAL REQUIREMENTS  
A
C. To range  
A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required.  
A time-delay fuse or curcuit breaker is also recommended. It is  
recommended that a separate circuit serving only this range be provided.  
C
®TEFLON is a registered trademark of Chemours.  
Page 1 of 2  
Because Whirlpool Corporation includes a continuous commitment to improve our  
products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. W10694025  
05/20/2016  

York Sunline Magnum Dy 060 User Manual
Xerox 220 User Manual
Toshiba Rav Sm1101bt E User Manual
Toshiba B Sa4 User Manual
Samsung As09a5 6 Maf User Manual
Philips R6b4b260 User Manual
LG DVH5 08W User Manual
HITACHI 36FX49B User Manual
Hampton Bay Low Voltage 60 Watt Landscape Transformer User Manual
DELL U3014 User Manual