UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 1
Model: ACC98WK (ACC98WK-T, ACC98WK-R)
For service/
support Call:
Toll Free Number
1-800-243-0000
© Copyright 2008, LG Electronics U.S.A., Inc.
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 3
Copyrights
IMPORTANT SAFETY
INSTRUCTIONS
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
It is forbidden by law to copy, broadcast, show, broadcast via cable, play in
public, or rent copyrighted material without permission. This product features
the copy protection function developed by Macrovision. Copy protection signals
are recorded on some discs. When recording and playing the pictures of these
discs picture noise will appear. This product incorporates copyright protection
technology that is protected by method claims of certain U.S. patents and other
intellectual property rights owned by Macrovision Corporation and other rights
owners. Use of this copyright protection technology must be authorized by
Macrovision Corporation, and is intended for home and other limited viewing
uses only unless otherwise authorized by Macrovision Corporation. Reverse
engineering or disassembly is prohibited.
1. Read these instructions.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION
TELEVISION SETS ARE FULLY COMPATIBLE WITH THIS PRODUCT AND
MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF
525 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED
THAT THE USER SWITCH THE CONNECTION TO THE ‘STANDARD
DEFINITION’ OUTPUT. IF THERE ARE QUESTIONS REGARDING OUR TV
SET COMPATIBILITY WITH THIS MODEL 525p UNIT, PLEASE CONTACT
OUR CUSTOMER SERVICE CENTER.
8. Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding
type plug has two blades and a third grounding prong. The wide blade or
the third prong are provided for your safety. If the provided plug does not fit
into your outlet, consult an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on or pinched particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long
periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into
the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped.
3
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 4
Welcome to your new Wireless Kit
Contents
Setting up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-6
LED indicator of Wireless Transmitter . . . . . . . . . . . . .7
LED indicator of Wireless Receiver . . . . . . . . . . . . . .7
Setting an ID of Wireless Transmitter . . . . . . . . . . . . .7
Specifications
Wireless Transmitter
External dimensions (WxHxD)
Net Weight
52.8x140x110.5 mm.
0.14 kg
Transmission
Power Supply
2.4 GHz
DC 7.5V max
CAUTION: The apparatus should not be exposed to water (dripping or splashing) and no objects
filled with liquids, such as vases, should be placed on the apparatus.
Wireless Receiver
CAUTION concerning the Power Cord
Most appliances should be placed on a dedicated circuit;
Power requirements
Power consumption
External dimensions (WxHxD)
Net Weight
Reception Output
Amplifier
120V ~ 60Hz
50W
64x252.3x213.6 mm
1.2 kg
2.4 GHz
155 W + 155 W
That is, a single outlet circuit which powers only that appliance and has no additional outlets or
branch circuits. Check the specification page of this owner's manual to be certain.
Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension
cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these
conditions could result in electric shock or fire. Periodically examine the cord of your appliance,
and if its appearance indicates damage or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an exact replacement part by an authorized servicer.
Protect the power cord from physical or mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the
point where the cord exits the appliance.
Designs and specifications are subject to change without
pior notice.
To disconnect power from the unit, unplug the unit from the outlet. When installing the product,
ensure that the plug is easily accessible.
4
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 5
Setting up
Attaching the speakers to the Wireless Receiver
a
b
Connect the power cord of the Wireless Receiver to the outlet.
Connect the wires to the Wireless Receiver.
Connect the Wireless Receiver and the rear speaker (right, left) with the speaker cable.
b
Attaching the
Wireless Transmitter
to the DVD receiver
a
b
Connect the adaptor to the
outlet and transmitter.
Connect the SOUND
a
SIGNAL connector of the
Wireless Transmitter and
rear (right, left) speaker of
the main set with the
sound signal cable.
c
Connect the Ground cable
to the DVD receiver.
Be sure to connect the ground
cable to the rear panel of the
unit by using the screw in rear
panel. If this is not connected,
the wireless system will be
come noise.
a
c
b
a
b
5
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 6
Setting up
Be careful of the following
About Ferrite Core (for EMI only) (optional)
•
•
Set the distance between this unit and Wireless Receiver within 10m.
Optimum performance can be implemented only when the Wireless
Transmitter and the Wireless Receiver within distance of 2m to 10m is used
since communication failure may occur if longer distance is used.
Be sure to match the speaker cable to the appropriate terminal on the
components: + to + and – to –. If the cables are reversed, the sound will be
distorted and will lack bass.
It takes a few seconds (and may take longer) for the Wireless Transmitter and
Wireless Receiver to communicate with each other.
When the unit is turned off, the Wireless Transmitter is in standby mode (off)
automatically after about 10 seconds.
Be sure to attach the ferrite core to the speaker cables (for connecting to
this unit).
This ferrite core can reduce noises.
•
How to attach the ferrite core (optional)
1
2
Press the stopper [a] of the ferrite core to open.
Wind the cable once on the ferrite core. Attach the ferrite core near the
unit (Refer to the fig.3 and comment.).
•
•
•
3
Close the ferrite core until it clicks.
If the Wireless Transmitter is turned off, the Wireless Receiver will not
function.
(fig.3)
The length
here is as
short as
possible.
6
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 7
LED indicator of Wireless
Transmitter
Setting an ID of Wireless
Transmitter
Operation
When the unit is manufactured, the ID is already set. If an interference
occurs or you use a new Wireless Receiver, an ID is set again.
LED color
BLUE
The main set is turned on, everything is connected
and transmitting.
ON Wireless Kit
RED
The wireless transmitter is in standby mode.
The adaptor is disconnected to the outlet.
1 Connect the SOUND SIGNAL connector of
transmitter and the rear (right, left) speaker
terminals of main unit with the SOUND
OFF (No display)
SIGNAL cable.:
-
2 Connect the adaptor to the outlet
and transmitter.:
LED indicator of Wireless
Receiver
-
3 Turn off the Wireless Receiver:
POWER Switch
4 Press the ID. for more than 3 seconds:
The Blue LED indicator will quickly flicker
Operation
LED color
ID.
BLUE
The Wireless Receiver is receiving a signal of
wireless transmitter
5 Turn on the Wireless Receiver:
POWER Switch
.
RED
The Wireless Receiver is in standby mode.
The Wireless Receiver is turned off.
Be careful of the following
OFF (No display)
If there is a strong electromagnetic wave product nearby, interference may
occur. Put the unit (Wireless Receiver and main unit) away from there.(Ex:
Microwave oven)
If there is no audio signal for longer than 10 minutes, the Wireless Receiver
and Wireless Transmitter will be automatically switched to standby mode. In
power saving mode, both LEDs will turn red. LEDs will turn blue when there is
any audio signal back.
If you operate main unit then wireless speakers (rear speakers) sound within a
few seconds in standby mode.
7
UW93_DUSALL_ENG_2913 9/17/08 12:13 PM Page 8
LG Electronics, Inc.
Limited Warranty - USA
This LG Electronics product, will be repaired or replaced, at LG’s option, if it proves to be defective in material or workmanship, under normal use, during the
warranty period (“Warranty Period”) listed below, effective from the date (“Date of Purchase”) of original consumer purchase of the product. This warranty is good
only to the original purchaser of the product and effective only when used in the United States, excluding U.S. Territories.
WARRANTY PERIOD:
HOW SERVICE IS HANDLED:
LABOR: 90 days from the Date of Purchase.
Call 1-800-243-0000 for instructions on getting the defective unit repaired or
replaced.
PARTS: One Year from the Date of Purchase.
Please retain dated sales receipt and your box to return the unit to LG for
repair or replacement.
* Parts replaced are warranted for the remaining portion of the original
warranty period.
Shipping both ways will be paid by LG during the first 90 days of the Warranty
Period. During the remainder of the Warranty Period (91-365 days), you pay
inbound shipping charges and LG pays return shipping charges.
Visit our website at: http://us.lgservice.com
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. TO THE EXTENT ANY IMPLIED WARRANTY IS REQUIRED BY LAW, IT IS LIMITED IN
DURATION TO THE EXPRESS WARRANTY PERIOD ABOVE. LG ELECTRONICS WILL NOT BE LIABLE FOR ANY INCIDENTAL, CONSEQUENTIAL,
INDIRECT, SPECIAL OR PUNITIVE DAMAGES OF ANY NATURE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, INCLUDING WITHOUT
LIMITATION, LOST REVENUES OR PROFITS, LOST OR CORRUPTED PROGRAMMING OR DATA, OR ANY OTHER
DAMAGE WHETHER BASED IN CONTRACT, TORT OR OTHERWISE. Some states do not allow the exclusion or limitation of incidental or consequential
damages or limitation on how long an implied warranty lasts, so the above exclusion or limitation may not apply to you. This warranty gives you specific legal rights
and you may also have other rights that may vary from state to state.
THIS LIMITED WARRANTY DOES NOT APPLY TO:
• Damages or operating problems that result from shipping, installation, adjustment of user controls, calibration, maintenance or failure to maintain, or separate
system components; and
• Damages or operating problems that result from normal wear and tear, misuse, abuse, operation outside environmental specifications or contrary to the
requirements or precautions in the Operating Guide, accident, lightning strikes or other natural causes, unauthorized modification or alteration, incorrect electrical
current or voltage, reception problem caused by inadequate home antenna or faulty antenna connections, computer software, institutional or commercial use, or
other causes not arising out of defect in material or workmanship.
Therefore, the cost of repair or replacement of such defective product shall be borne by the consumer.
CUSTOMER INTER-ACTIVE CENTER NUMBERS:
For nearest Authorized Service Center, Where to buy, Product
Assistance, or Customer Assistance
Call 1-800-243-0000 (24 hours a day, 365 days per year) and select
appropriate options from the menu.
Or visit our website at http://us.lgservice.com
LG ELECTRONICS U.S.A., INC.
1000 SYLVAN AVENUE
P/NO : MFL42932913
Issue O
ENGLEWOOD CLIFFS, NJ.
Printed in China
|