Heat Storm Heater User Manual

MODELS  
HS–1300-OWO  
HS-1500-OWO  
HS-1800-OWO  
HS–2000-OWO  
HS-1300-OTR  
HS-1500-OTR  
ELECTRICAL  
HEATER  
SafETy inSTRucTiOnS & OpERaTiOn ManuaL  
an electrical shock or fire. Never use  
your heater to dry washing.  
This heater is not intended for use in  
bathrooms, laundry areas and similar  
indoor locations. Never locate heater  
where it may fall into a bathtub or  
other water container.  
inTRODucTiOn  
If the heating element has stopped  
glowing it may still be live, please  
check that the heat setting indicates  
the heater is off. Always disconnect  
your appliance from the mains before  
any cleaning or replacing tubes.  
DO NOT run cord under carpeting -  
DO NOT cover cord with throw rugs,  
runners, or the like. Arrange cord  
away from traffic area and where it  
will not be tripped over  
The Heat Storm all season outdoor heater produces infrared radiant  
heat, warming people and objects rather than the air between, providing  
the only form of heat that will not blow away. The Heat Storm’s  
weatherproof design is perfect for worry-free outdoor and industrial use.  
DO NOT use the heater in areas  
where petrol, paint, or other  
flammable substances are stored.  
To disconnect heater, turn controls  
off, then remove plug from outlet.  
Always unplug the heater when not  
in use. To disconnect from the power  
supply, grip the plug and pull from the  
power socket. Never pull by the cable.  
Please read the enclosed instructions carefully before installation or use.  
Connect to properly grounded  
outlets only.  
DO NOT insert or allow foreign  
objects to enter any ventilation or  
exhaust opening as this may cause an  
electric shock or fire, or damage the  
heater.  
DO NOT direct the heater towards  
curtains, furniture or other flammable  
objects and ensure that there is a  
minimum distance from objects  
around (see figure 1, figure 2).  
iMpORTanT SafETy inSTRucTiOnS  
To prevent a possible fire, do not block  
air intakes or exhaust in any manner.  
DO NOT use on soft surfaces, like a  
bed, where openings may become  
blocked.  
WARNING: When using electrical appliances, basic safety precautions  
should always be followed. Failure to comply with these instructions  
may cause a fire, electrical shocks or other injury to persons or property  
DO NOT use this heater in  
conjunction with a timer device or  
any other device, which facilitates  
unattended switch on.  
DO NOT pull the power cable or the  
device itself to unplug it from the  
A heater has hot and arcing or  
Read all instructions before using  
DO NOT let children play with the  
sparking parts inside. DO NOT use  
flammable liquids are used or stored.  
This heater is hot when in use. To  
avoid burns, do not let bare skin  
touch hot surfaces. If provided, use  
handles when moving this heater.  
Keep combustible materials, such as  
furniture, pillows, bedding, papers,  
clothes, and curtains at least 3 feet  
(0.9m) from the front of the heater  
and keep them away from the sides  
and rear.  
Check that the voltage and frequency  
of your appliance match your mains  
voltage before plugging in.  
The power cable must be fully  
unwound before use.  
Use this heater only as described  
in this manual. Any other use not  
recommended by the manufacturer  
may cause fire, electric shock, or  
injury to persons.  
If the supply cable is damaged, it  
must be replaced by the manufacture,  
its service agent or similarly qualified  
person in order to avoid a hazard.  
This heater is hot when in use. To  
avoid burns DO NOT touch the grills  
or heating element during use or  
attempt to move the heater.  
Avoid the use of an extension cord  
because the extension cord may  
overheat and cause a risk of fire.  
However, if you have to use an  
extension cord, the cord shall be  
No.16 AWG minimum size and rated  
not less than 1500 watts.  
This product is not designed for use  
by persons (including children) who  
have reduced physical, sensory or  
mental capacities or persons with  
no experience or knowledge, unless  
they are instructed and supervised in  
the use of the appliance by a person  
responsible for their safety.  
DO NOT touch the heater with  
wet hands  
DO NOT operate any heater with  
a damaged cable or plug, or after  
the heater malfunctions, has been  
dropped, or damaged in any manner.  
Return the heater to an authorized  
service facility for examination and  
repair.  
Extreme caution is necessary when  
any heater is used by or near children  
or invalids and whenever the heater  
is left operating and unattended.  
Make sure the heater is supplied by  
the branch-circuit fitted with one  
20 amperes over current protection.  
Always unplug heater when not  
in use.  
Children should be supervised to  
ensure that they DO NOT play with  
appliance.  
DO NOT operate any heater with  
a damaged cord or plug or after  
the heater malfunctions, has been  
dropped or damaged in any manner.  
Return heater to authorized service  
facility for examination, electrical or  
mechanical adjustment, or repair.  
DO NOT attempt to repair or adjust  
any electrical or mechanical functions  
as this may void warranty.  
KEEPTHESE INSTRUCTIONS.  
This heater must be mounted in a  
high position which is not less than  
72 inches (1.8m) for U.S market and  
98 inches (2.4m) for Canada market  
from the floor. And must keep a  
minimum clearance to adjacent  
combustibles: from top: 24 inches  
(0.6m), from sides: 18 inches (0.45m).  
DO NOT insert or allow objects to  
touch the heating element and never  
place anything on the heater safety  
guard (e.g. towels), as this may  
Remove product from the packaging  
and ensure it is in good condition.  
damage the heater and could cause  
WORKSpacE  
TRaDESMan  
1 Heater (x1)  
1 Heater (x1)  
2 SelfTapping Screw (x2)  
3 Plastic Plug (x2)  
2 Wall Bracket Assembly (x1)  
3 M4x8 Screw (x2)  
4 SelfTapping Screw (x2)  
5 Plastic Plug (x2)  
4 Wall Bracket (x1)  
5 Heater Bracket (x1)  
6 Heater Bracket Plate (x2)  
7 M4 Screw (x2)  
8 M6 Screw (x2)  
9 Spring Washer (x2)  
10 Rubber Washer (x2)  
7
3
5
2
Mount wall bracket to desired surface.  
Mount heater bracket to pole on  
back of heater.  
3
4
9
Mount heater bracket to  
back of heater.  
Mount wall bracket to desired surface,  
then connect heater bracket to the wall bracket.  
10  
8
Connect heater bracket to wall bracket.  
inSTaLLaTiOn  
OpERaTinG inSTRucTiOn  
PRECAUTION:  
WARNING:  
Installation should always  
be carried out by a qualified  
electrician or a competent person  
Do not use the heater directly  
near a bathtub, a shower, a  
swimming pool.  
Do not use the heater directly near a bathtub, a shower or  
a swimming pool.  
Never plug the appliance into the socket with wet hands  
The energy supply must be done  
through a properly grounded  
socket.  
Ensure that there is no possibility  
of inflammable material coming  
into contact with the heater, or  
lies near the heater.  
WORKSPACE  
1 Before plugging in heater, turn switch to off position.  
2 Firmly plug power cord into a socket.  
3 Turn on /off with heater switch.  
The heaters should always be  
installed horizontally and should  
always only use the mounting  
brackets or chains provided.  
Heaters should not be installed  
in areas where hazardous vapors  
may be present. Defined in  
BS5345.  
The heater should not be facing  
the ceiling or inflammable  
substances.  
TRADESMAN  
The heaters are fitted with safety  
guards. These are intended only  
to stop large objects from hitting  
the emitters. On no account  
with the guard removed.  
1 Turn on heater by firmly plugging in the power cord.  
2 Turn off heater by unplugging power cord.  
The heater must be installed so  
as to prevent that the switches  
are in the shower.  
cLEaninG & MainTEnancE  
WARNING:  
WaLL MOunTinG  
Before cleaning, unplug from the power supply and wait a few minutes  
to cool down.  
ONly USE SUPPlIED BRACKETS.  
This heater contains no moving parts, it needs very little maintenance.  
However, when the heater builds up heavy dirt, use a soft cloth to wipe  
it off.  
1 Ensure the power cable does not touch the reflector of the heater or  
hangs into the heated area.  
2 Ensure the power cable can reach an indoor socket. Do not twist or  
bend the power cable.  
HEATING ElEMENT REPlACEMENT:  
3 This heater is IP65 protection, and can be used indoors or outdoors.  
If using outdoors and you need a extend socket, the cable and the  
socket system must be waterproof.  
If the heating element malfunctions and needs to be replaced, it should  
only be changed by a service agent.  
MODEL iMaGES  
cuSTOMER SERVicE  
Repairs must be carried out by authorized specialists to ensure electrical  
safety. Please contact the service agent or a suitably qualified electrician.  
MODEL  
TRaDESMan  
Improper repairs could lead to danger. The warranty does not cover  
damage or failure that results from alteration, accident, misuse, abuse,  
neglect or improper maintenance.  
Due to ongoing product development we reserve the right to change the  
product specifications and documentation without notice.  
For more information:  
ENERGyWISE SOlUTIONS  
PO BOx 4681  
MODEL  
WORKSpacE  
lOGAN, UT 84323  
877 891 7333  
heatstorm.com  
PlEASE RECyClE  
Electric Products should not be disposed of with household waste.  
Check with your local authority or retailer for recycling advice.  

Tripp Lite Bp Series User Manual
Thermo Products 14 Seer User Manual
Soleus Air Sg Wac 15ese User Manual
Sanyo Cr2430 User Manual
Panasonic Kx Pw11clh User Manual
Maxair Range Hood User Manual
KENWOOD KRF V7050D User Manual
BROTHER HL L2386DW User Manual
ASUS X550V 02 User Manual
ASUS VG249QM1A User Manual