R
+
SWRTY-61N
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Toyota vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Retains OE Rear View Camera.
- Supports BT-HF/A2DP/AVRCP profile on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installation.
PARTS INCLUDED:
SWC 3.5MM PLUG ADAPTER
SWRTY-61N MODULE
SWRTY-61N HARNESS
USB Retenꢀon Cable
SWC CABLES
INSTALLATION DIAGRAM:
+12V Constant
+12V ACC
Ground
Illumination
Yellow
Red
Black
USB-TY01
USB Retention Adaptor
(included in kit)
AFTERMARKET
RADIO
Orange
Not Used
SWC for Kenwood/JVC
Right Front (+)
Blue/ White
Blue/Yellow
Gray
Gray/Black
White
TOYOTA
SWC SETTING
AFTERMARKET
RADIO SELECTOR
(See Chart)
(OFF ON OFF ON)
Right Front (-)
Left Front (+)
Left Front (-)
Right Rear (+)
White/Black
Violet
ON RADIO VEHICLE
Right Rear (-)
Left Rear (+)
Violet/Black
Green
1
2
3
4
5
6
7
8
Left Rear (-)
Vehicle Speed Sense (VSS)
Reverse Trigger
Green/Black
Red/Black
Red/White
Yellow/Black
Blue
Yellow RCA
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
(Retain OE Camera)
Parking Brake (see special note below)
Power Antenna
Rear View Camera Signal
Audio Input
Red/White RCA
SWRTY-61N
MODULE
Cap or insulate if
not being used
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
12-Pin Black
Connector
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
LIN BUS (Green)
24 PIN
28 PIN
TO FACTORY
HARNESS
10 PIN
Blue / Antenna Turn On
6 PIN
NOTE:
ANTENNA ADAPTOR
(Included in Kit)
The BLUE Antenna Turn-On wire
should ONLY be connected to
one circuit of the aftermarket
radio. Choose the one which has
a wire populated on the factory
connector side.
Blue / Antenna Turn On
1 of 3
rev.111318
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
R
+
SWRTY-61N
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
INTERFACING SOLUTIONS
24 TO 16 PIN ADAPTER:
Some vehicles do not have the 24-Pin Video Input connector. Instead, they have a 16-Pin connector that controls the
video input for the camera. Use the opꢀonal adaptor and connect to the T-harness to convert the harness to work with
the 16-Pin connector style.
TO SWC HARNESS
TO FACTORY RADIO
24-PIN
16-PIN
(male plug)
(male plug)
RED /PARKING BRAKE
(Use instead of Yellow/Black Wire on Main Harness)
VEHICLE APPLICATIONS:
TOYOTA
2012 - 2017 4Runner
2012 – 2017 RAV4
2012 - 2017 Sequoia**
2012 - 2017 Tacoma
2014 - 2017 Tundra**
2012 - 2015 Venza
2012 - 2017 Avalon
2012 - 2017 Camry
2012 - 2016 Corolla
2013 - 2017 Highlander*
*Note: 2013-2017 Highlander vehicles without OEM Navigaꢀon radio will NOT retain the factory back up camera.
** See Special Note on page 2.
rev.111318
3 of 3
Crux Interfacing Solutions • 6860 Canby Ave., Suite 104, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|