R
+
SWRSU-38C
Radio Replacement with Steering Wheel Control Retention for
Select Non-Amplified Subaru Vehicles 2015 - Up
RADIO REPLACEMENT
SWC RETENTION
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains select factory features in select Subaru vehicles while funcꢀoning with an aſtermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- Retains StarLink funcꢀonality.
- Retains factory Auxiliary Input.
- Retains factory backup camera (see note on diagram below).
- Includes antenna adapter.
PARTS INCLUDED:
SWRSU-38C Module
SU-38C Harness
Antenna Adapter
SWC Cable
INSTALLATION DIAGRAM:
+12V Constant
+12V ACC
Yellow
Red
Black
Ground
AFTERMARKET
RADIO
Illumina�on (+)
Antenna Turn on
Reverse Trigger Purple/White
Orange
Blue
SUBARU
SWC SETTING
(See Page 2)
AFTERMARKET
RADIO SELECTOR
(See Page 2)
Right Front (+)
Right Front (-)
Le� Front (+)
Le� Front (-)
Right Rear (+)
Right Rear (-)
Le� Rear (+)
Le� Rear (-)
Gray
Gray/Black
White
White/Black
Violet
Violet/Black
Green
Green/Black
ON RADIO VEHICLE
1
2
3
4
5
6
7
8
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
Ground
Audio Input
Red/White RCA
Yellow RCA
Cap or insulate if
not being used
12-Pin Black
Connector
(Retains Factory AUX Input)
Rear View Camera Signal
(Retain OE Camera)
Insulate with tape
if not being used
4-Pin
Connector
Kenwood/JVC (BLUE / YELLOW)
*NOTE: If the factory radio does not
have a 5 pin camera connector, plug
these connectors together to retain
the factory backup camera.
5 -Pin OEM
Camera
Connector*
28 PIN
TO FACTORY
HARNESS
10 PIN
6 PIN
5 PIN
ANTENNA ADAPTOR
(Included in Kit)
1 of 2
rev.052821
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
|