BLUE OX BX88271 User Manual

BX88271  
ATM Mini Fuse ByPass Switch  
Installation Instructions  
ALWAYS match the amperage of the fuse in the Fuse ByPass Switch harness to the fuse removed  
from the fuse panel.  
NEVER install a fuse with more than a 20 amp rating in the Fuse  
ByPass Switch harness.  
REMOVE any fuse from the Fuse ByPass Switch harness.  
BEFORE YOU BEGIN: Consult the owner’s manual for the  
towed vehicle to determine which fuse must be removed from the  
“towed” vehicle. Confirm that the pins on the Fuse ByPass Switch wires match the pin sizes on the  
fuse you removed. You must have the correct fuse wire ends for your fuse box.  
1. Install the two (2) small wire pins into the fuse panel location from where you removed the fuse in  
the “towed”. Press in on the pins until fully seated.  
Note: On Honda vehicles you will need to press the wire pins to the outside edges of the fuse  
opening since these panels have the connectors on the sides of the opening, not at the bottom.  
Insure that fuse panel cover can be replaced. If necessary use wire ties (not supplied) to hold the  
wiring firmly in place insuring a firm physical and electrical connection.  
2. Find a suitable location on a plastic surface (1/4” thick or less) next to the fuse box to mount the  
Fuse ByPass. It is highly recommend that installation is on the outer, removable panel used to  
access the fuse panel.  
Confirm that there is ample space for the switch and that there is no metal behind the area you  
have chosen. Be sure that you can reach the back of the Fuse ByPass in order to install the  
mounting nut and to reattach the wires.  
Note: On 2007 Honda CRV’s, the switch might be mounted on the side of the dash area coin  
holder; on newer CRV’s install the Fuse ByPass on the lower dash tray.  
3. Carefully drill a 3/4” diameter hole into the plastic panel using a flat power auger. Avoid drilling into  
or damaging any nearby wiring.  
4. Remove the 2 wires from the switch by carefully and firmly pulling on the connectors one at a time.  
5. Place the switch into the hole, install the mounting nut with the serrated side towards the panel  
and hand tighten it.  
6. Reattach the wires to the switch by sliding the connectors over the terminals on the switch.  
7. Slide the black split loom over the wiring connections and if necessary, secure with electrical tape.  
405-0977  
Page 1 of 2  
2/8/12  

U Line Combo Sp18 User Manual
Snapper 204400 User Manual
Schumacher Ssc 1000a User Manual
Savin 8020d User Manual
Samsung Us18a9 0 Rcfd User Manual
Samsung Clx 8380nd User Manual
Lexmark X652 Mfp User Manual
BLACK DECKER GW3010V User Manual
BLACK DECKER DCM900B User Manual
ASUS ZEN AIO ZN24 User Manual