CORDLESS HAND VACS
INSTRUCTION MANUAL
CATALOG NUMBERS
HNV115BXX*
HNV215BXX*
HNV220BXX*
PLEASE READ BEFORE RETURNING THIS PRODUCT FOR
ANY REASON.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
*XX is a placeholder for the two-digit number at the end of your vacuum’s
catalog number that designates your vacuum’s color.
ADDITIONAL SAFETY
1
WARNINGS
2
a)Prevent unintentional starting. Ensure
the switch is in the off-position before
connecting to battery pack, picking up
or carrying the appliance. Carrying the
appliance with your finger on the switch
or energizing appliance that have the
switch on invites accidents.
3
4
b)Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
c) Do not use a battery pack or appliance
that is damaged or modified. Damaged
or modified batteries may exhibit
unpredictable behavior resulting in fire,
explosion or risk of injury.
6
7
5
d)Do not expose a battery pack or
appliance to fire or excessive
Wall Mounting - Figure A
The product can be attached to a wall to
temperature. Exposure to fire or
temperature above 266°F (130°C) may
cause explosion.
e)Have servicing performed by a qualified
repair person using only identical
replacement parts. This will ensure that
the safety of the product is maintained.
provide a convenient storage and charging
point for the appliance. When mounting to
a wall, make sure the mounting method is
suitable for the wall type and is appropriate
to the weight of the appliance.
• Mark the location of the charger bracket
(5) screw holes on the wall (within reach
of an electrical outlet for charging the
vacuum while it is on the wall bracket).
• Fix the mounting bracket to the wall using
appropriate screws and plugs for the type
of wall, and weight of the appliance.
• Hang the appliance by placing the
opening of the vacuum base over the
hooks in the wall mount charging bracket.
WARNING:
Do not
attempt to modify or repair the appliance
SAVE THESE INSTRUCTIONS
Symbols
•
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V..................volts
A
A..................amperes
Hz................hertz
W.................watts
min..............minutes
or AC......alternating current
or DC ..direct current
o................no load speed
................Class I Construction
(grounded)
n
................earthing terminal
...............safety alert symbol
................Class II Construction
(double insulated)
Assembly Accessories - Figure B
(HNV220B Models Only)
Your hand vac may be supplied with some
of the following accessories:
.../min or rpm...revolutions or reciprocation
per minute
• A brush tool (6) for furniture and stairs.
• A crevice tool (7) for confined spaces.
FUCTIONAL DESCRIPTION
1. On/off switch
Fitting
2. Bowl release button
3. Dust bowl
• Insert the appropriate accessory into the
front of the appliance as show in Figure B.
• Make sure the accessory is fully pushed in.
4. Charger
5. Charging bracket
HNV220B Models Only
6. Brush tool
7. Crevice tool
3
Optimizing the suction force
In order to keep the suction force optimised,
the filters must be cleared regularly during use.
B
EMPTYING AND CLEANING
THE PRODUCT.
Removing the dust bowl and
filters - Figures D & E
WARNING: The filter is reusable and
should be cleaned regularly.
• Press the bowl release button (2) and pull
the dust bowl (3) straight off as shown in
Figure D.
Charging the battery
WARNING:
For use
only with the supplied charger.
D
• Before first use, the battery must be
charged for at least 10 hours.
• Place the appliance on the charging
bracket whenever it is not in use.
WARNING: Before charging, be sure
to empty all contents and dry thoroughly if
needed to avoid damage to your appliance.
• Make sure the appliance is switched off.
• Place the appliance on the charging
bracket (5).
• While holding the dust bowl over a bin
or sink, pull out the filter (8) to empty the
contents as shown in Figure E.
• Plug in the charger.
• Leave the appliance to charge for at least
9 hours.
NOTE: While charging, the charger may
become warm. This is normal and does not
indicate a problem. The appliance can be
left connected to the charger indefinitely.
• To replace the dust bowl, push it back onto
the handle until it clicks firmly into place.
WARNING: Never use the appliance
without the filters. Optimum dust collection
will only be achieved with a clean filter.
WARNING: Do not charge the
battery at ambient temperatures below 50
°F or above 104 °F.
E
Switching On - Figure C
• To switch the appliance on, depress
the on/off button (1). Once the button is
released the vacuum will turn off.
C
Cleaning the dust bowl and filter
• The dust bowl and filter can be washed in
warm soapy water.
• Make sure the filter and the dust bowl are dry
before re-fitting.
Replacing the filters
The filters should be replaced every
6 to 9 months and whenever worn or
damaged. Replacement filters (catalog
number EVF100) are available from your
BLACK+DECKER dealer.
Dry pick up
• For everyday spills of dry material.
• Do not fill the dust bowl (3) beyond the
end of the intake chute.
4
MAINTENANCE
Use only mild soap and damp cloth to clean
the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
WARNING: Make sure the vacuum
is completely dry before using it.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
The RBRC™ Seal
The RBRC® (Rechargeable
Battery Recycling Corporation)
Seal on the lithium-ion batteries
(or battery packs) indicates
that the costs to recycle these batteries
(or battery packs) at the end of their
useful life have already been paid by
BLACK+DECKER. In some areas, it is
illegal to place spent lithium-ion batteries in
the trash or municipal solid waste stream
and the Call 2 Recycle® program provides
an environmentally conscious alternative.
Call 2 Recycle, Inc., in cooperation with
BLACK+DECKER and other battery users,
has established the program in the United
States and Canada to facilitate the collection
of spent lithium-ion batteries. Help protect
our environment and conserve natural
resources by returning the spent nickel
cadmium, nickel metal hydride or lithium-ion
batteries to an authorized BLACK+DECKER
service center or to your local retailer for
recycling. You may also contact your local
recycling center for information on where
to drop off the spent battery. RBRC® is a
registered trademark of Call 2 Recycle, Inc.
Accessories
Recommended accessories for use with
your appliance are available from your local
dealer or authorized service center.
WARNING: The use of any accessory
not recommended for use with
this appliance could be hazardous.
5
|