OWNER’S
INSTRUCTIONS
AW0505M
AW050BM
AW0595M
AW050DM
Window-type Room Air Conditioner
(Cool)
E
F
DB98-17031A(5)
Safety Precautions
The following safety precautions must be taken when using your air conditioner.
Risk of electric shock. • Can cause injury or death. • Disconnect all
WARNING
remote electric power supplies before servicing, installing or cleaning.
• This must be done by the manufacturer or its service agent or a similar
qualified person in order to avoid a hazard.
Users of this product are cautioned not to attempt repair of this product at their
own discretion. Instead, they are requested to directly contact a designated
service center or the outlet at which the product was purchased.
DURING OPERATION
Never spill any kind of liquid into the unit. Should this happen, unplug or main
switch off the unit and contact an authorized service center.
Do not insert anything between the air outlet blades because the inner fan may
be damaged and could cause injury. Keep children away from the unit.
Do not place any obstacles in front of the unit.
Do not spray liquid of any kind into the indoor unit. Should this happen, switch off
the breaker used for your air conditioner and contact your installation specialist.
Make sure that the unit is correctly ventilated at all times:
Do not place clothing or other materials over it.
If the wireless remote control will not be used for a long time, remove the
batteries. (If applicable)
When using a wireless remote control, the distance should not be more than 7
meters from the air conditioner. (If applicable)
The air conditioner must be plugged into its own specific power source, which
must be installed in compliance with national wiring,earthing and safety
regulations.
If the power cord is damaged in any way, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a hazard.
This device must be installed according to the national electrical rules.
The appliance must be installation that the plug should be easily accessible
after installation.
If the fuse on PC board is broken please change it with the type of T 3.15A 250V.
The breaker of the air conditioner should be all-pole switch; and the distance
between its two contacts should be no less than 3.5mm. Such means for
disconnection must be incorporation in the fixed wiring.
Before throwing out the device, it is necessary to pull back the battery cells and
get rid of them safely for recycling reasons.
DISPOSING OF THE UNIT
When you need to dispose of the unit, consult your dealer. If pipes are removed
incorrectly, refrigerant may blow out and come into contact with your skin,causing
injury. Releasing refrigerant into the atmosphere also damages the environments.
Please recycle or dispose of the packaging material for this product in an
environmentally responsible manner.
Never store or ship the air conditioner upside down or sideways to avoid damage
to the compressor.
OTHERS
The appliance is not intended for use by young children or infirm persons without
supervision: Young children should be supervised to ensure that they do not play
with the appliance.
Max current is measured according to IEC standard for safety and current is
measured according to ISO standard for energy efficiency.
E-2
Description of Each Component
Design and shape are subject to
change.
Air outlet
Outer air flow blades
(up/down orientation)
- Except AW0505M/AW0595M
AW050BM/AW050DM
Inner air flow
blades (right/left
orientation)
Air outlet
Ventilation lever
- Except AW0505M/AW0595M
AW050BMAW050DM
Air inlet (Inside)
Air inlet (Outside)
Air filter (Inside)
Power plug
(The type of power plug
may differ, depending on
the local power supply.)
Operating mode
selection dial
Thermostat
control
E-4
Getting Started
You have just purchased a Samsung w indow -type room air conditioner w hich should be
installed follow ing your Ow ner’s Instructions.
Your Ow ner's Instructions contain much valuable information on using your air conditioner.
Please take the time to read them as they w ill help you take full advantage of the unit's
features.
The illustrations in the step-by-step procedures use four different sym bols:
◆
NOTE
◆
PRESS
PUSH
IMPORTANT
E-5
Cooling Your Room
You must select the COOL mode if you wish to adjust the:
Cooling temperature
Fan speed when Cooling
Turn the operating mode selection dial and set it to "
" ,
1
"
" or "
"
Result: The air conditioner starts up in cool mode.
You can change modes at any time.
2
Turn the THERMOSTAT control to the desired position.
Possible temperatures: Can be set between 18 C and 29 C.
Result: The air conditioner starts cooling if the room temperature is
higher than the selected temperature.
3
To control the direction of the air flow, refer to page 9.
E-6
Ventilating Your Room
If the air in your room is stale, you can ventilate the room using the
Fan feature. (Except AW0505M / AW0595M / AW050BM / AW050DM)
1
If you wish to discharge stale air, push the ventilation lever on the front
of the unit to the right and open position ( ).
Result: The air inside the room circulates and stale air is discharged
outside.
Otherwise, push the ventilation lever to the left and closed position (
Result: The air simply circulates inside the room.
).
2
Turn the operating mode selection dial and set it to "
tion.
" or "
" posi-
Result: The air conditioner starts up in fan mode.
: The fan turns rapidly.
: The fan turns slowly.
You can change modes at any time.
3
To control the direction of the air flow, refer to page 9.
E-7
Switching the Air Conditioner Off
You can switch the air conditioner off whenever you want.
To switch the unit off, simply set the operating mode selection dial to the
1
"
"
position.
Result:
The air conditioner stops operating.
E-8
Adjusting the Air Flow Direction Horizontally
Depending on the position of the unit in your room, you can adjust
the orientation of the inner air flow blades on the unit.
Adjust the air flow blades to the desired position by sliding them side to side.
Adjusting the Air Flow Direction Vertically
The outer air flow blades can be adjusted to control the vertical air
flow direction. (Except AW0505M / AW0595M / AW050BM /AW050DM)
RECOMMENDATION When...
Adjust the blades to face...
Cooling
Upwards.
Adjust the air flow blades to the desired position, by pushing them
upwards or downwards.
If you orient the air flow blades downwards and the unit operates
in Cool mode for long periods of time, dew may:
-
-
Form on the surface of the blades
Drip from the blades
E-9
Power Failure
If a power failure occurs, the air conditioner is switched off.
When the power comes back on, the air conditioner starts up again
automatically.
Temperature and Humidity Ranges
The follow ing table indicates the temperature and humidity ranges
w ithin w hich the air conditioner can be used.
Mode
Indoor
Outdoor
Indoor Humidity
Temperature
Temperature
Cooling
21 C to 32 C approx.
21 C to 43 C approx.
80% or less
If the air conditioner is used at...
Then...
Higher temperature
The automatic protection feature may be triggered
and the air conditioner stopped.
Lower temperature
A water leakage or some other malfunction may happen
if the heat exchanger freezes.
Higher humidity levels
Water may condense on and drip from the surface of the unit
if it is used for long periods.
E-10
Cleaning Your Air Conditioner
Be sure to clean the air filter periodically to maintain the air conditioner
in the best condition for a long period of time.
When cleaning the air conditioner, turn it off and pull out the
power plug.
1
Open the front grille by pulling the tabs on both sides of the grille.
Then lift it up slightly to open the front grille completely.
2
3
Grab the tabs on the filter and pull it up and out.
Remove all dust on the air filter with a vacuum cleaner or brush.
4
5
When you have finished, insert the air filter back into its original position.
Wipe the surface of the unit with a neutral detergent
and then wipe it again with dry cloth.
(Be sure not to use benzene, solvent or other chemical products.)
If you...
Then...
Set the fan going for a few
hours to dry the inside of the air
conditioner thoroughly.
Will not be using the
air conditioner for a
long period of time
Switch the air conditioner off and
unplug it from the wall socket.
Clean the filter and outer surfaces.
Set the fan going for a few hours to
dry the inside of the air conditioner
thoroughly.
Have not used the air
conditioner for a long
period of time
E-11
Solving Common Problems
Before contacting an authorized service center, perform the follow ing simple checks.
They may save you the time and the expense of an unnecessary call.
Problem
Explanation / Solution
◆ Check for a power failure.
◆ Check the voltage.
The air conditioner
does not operate at all.
(See the technical specifications)
◆ Check the power plug for disconnection.
◆ Check to see whether the operating mode selection dial is placed in the
"
" position. (Set it to the desired position.)
◆ Check to see whether the room temperature is too low.
- Refer to page 10 for details about temperature condition.
◆ Set the THERMOSTAT control to the desired position.
- When the number on the THERMOSTAT control is too high,
the room temperature may be too warm.
The air comes out smoothly,
but cooling is not effective.
◆ Check to see whether there is an open window or leakage of cool
air to the outside.
- Close the window, and fill the gap.
◆ Check to see whether there is any obstacle adversely affecting
the flow of the air inside and outside the room.
- Remove the obstacle or change the position of the air conditioner.
◆ Check to see whether the air filter is clogged with dust or
contaminated with foreign substances.
- Clean the air filter.
◆ Check to see whether there is any direct sunlight facing the air conditioner.
- Block the sunlight with a sunshade.
◆ Check to see whether there is any electric device generating heat.
- Do not use the air conditioner together with any heating device.
Odors are permeating the
◆
Ventilate the room.
room during air conditioning.
E-12
Technical Specifications
Design and specifications are subject to change without notice.
Model
Power Supply
AW0505M AW050BM
115V~, 60Hz
AW050DM
AW0595M
E-13
YOUR SAMSUNG ROOM AIR CONDITIONER
WARRANTY
Limited Warranty to Original Purchaser
Samsung will repair or replace, at our option, this product if found defective within the warranty
period beginning from the original date of purchase. This Samsung Product is warranted by
SAMSUNG ELECTRONICS CANADA Inc. against manufacturing defects in materials or
workmanship for the period specified.
Labor
Parts
1 Year (In home)
1 Year
Limited 5-Years Compressor Warranty
Within one year of purchase Samsung Electronics Canada Inc. will provide a replacement
compressor if it is found to be defective in material or workmanship. During the existing four
years (second through fifth year) Samsung Electronics Canada Inc. will provide a replacement
only, without charge, if it is found to be defective in material or workmanship. Labor to install
the compressor during these existing four years is not included in the warranty. All warranty
repairs must be performed by a Samsung Authorized Service Centre.
Obligation of the Original Owner
The original dated purchase receipt must be retained as proof of purchase and presented to
the Authorized Service Centre before warranty services are rendered.
Exclusions of the Warranty
This warranty does not cover damage due to accident, fire, flood and/or other Acts of God:
misuse, incorrect line voltage, improper installation, improper or unauthorized repairs,
commercial use, or damages which occur in shipping. Exterior and interior finish and plastic
parts, are not covered under this warranty, Customer adjustments which are explained in the
instruction manual are not covered under the terms of this warranty. This warranty will
automatically be voided for any unit found with a missing or altered serial number.
This warranty is valid only on products purchased and used in Canada.
SAMSUNG ELECTRONICS CANADA INC.
55 Standish Court, Mississauga, Ontario L5R 4B2
Printed in Korea
|