28EXT External Emitter Adapter
INSTALLATION INSTRUCTIONS
DESCRIPTION
The 28EXT External Emitter Adapter is placed between a Xantech IR system and a list of approved
electronic equipment that feature a rear panel IR input jack. These input jacks accept electrical IR
commands without the carrier frequency, and are therefore not compatible with full range IR Receivers that
output a carrier frequency along with the IR commands, such as all Xantech IR Receivers. The 28EXT
interfaces and adapts a Xantech IR receiver to these rear panel IR inputs.
INSTALLATION
• Before making any connections:
• Confirm that the source equipment to be controlled is one of the devices in table A below.
• Table A below may indicate the need for a Wire-Swap Connector for some source units. If your device
to be controlled requires this connector, make sure that it is securely plugged into the 28EXT output
connector (the one with the black connector and the warning tag). Otherwise damage to your source
unit or the 28EXT may occur, and such damage will not be covered under warranty.
• The 28EXT may not be compatible with non-Xantech IR Receivers and Connecting Blocks.
TABLE A:
APPLICATION #1 – XANTECH®
Models:
TIP
SIGNAL
HDMI3x1, HDMI4x1, HDMI4x4, WIC1200
RING
SLEEVE
+5VDC Power
GROUND
Connector marking: EXT IR or IR In
Wire-Swap Connector Not Required
APPLICATION #2 – GEFEN®
Model:
TIP
SIGNAL
Any product that uses RMT-IR Extender (for
example: 3x1, 4x1, 4x4 HDMI switchers)
Connector marking: EXT IR
RING
SLEEVE
+5VDC Power
GROUND
Wire-Swap Connector Not Required
APPLICATION #3 – OMNIMOUNT® PANEL MOUNTS
Model:
Motion52 Motorized Mount
TIP
SIGNAL
RING
SLEEVE
+5VDC Power
GROUND
Connector marking: R/C
Wire-Swap Connector Not Required
APPLICATION #4 – SIRIUS® SATELLITE TUNERS
Model:
SCH2P Sirius Connect Home Pro Tuner
Polk Audio®/Sirius SR-H1000 Home Tuner
TIP
RING
SLEEVE
+5VDC Power
SIGNAL
GROUND
Wire-Swap Connector Required
Connector marking: IR INPUT
Download from Www.Somanuals.com. All Manuals Search And Download.
|