Figure 1.
Workpiece
Guide
Board
BOARD STRAIGHTENERS™
INSTRUCTION SHEET
D3119 Board Straighteners™
Introduction
You can now cut straight boards from irregular-edged
boards without using a jointer! The SHOP FOX®
Model D3119 Board Straighteners™ hold a board with
an irregular edge to a guide board with a known
straight edge. This stable arrangement can then be slid
along the table saw fence, producing a straight cut on
the irregular board.
Guide board
is against
fence
Workpiece
• READ and UNDERSTAND this instruction
sheet and your table saw instruction manual
before you use Board Straighteners™. Otherwise,
serious personal injury may occur.
Figure 2.
• If you are using BOARD BUDDIES® or any other
anti-kickback device on your table saw, make sure
that no interference or unsafe condition exists if
used in conjunction with Board Straighteners™.
How to Use Your Board Straighteners™
To hold and cut an irregular-edged board without the use
of a jointer, do these steps and see Figures 1 and 2.
1. Choose a straight and square
piece of 1⁄2" thick wood for the
guide board, which is the same
• Always use two or more Board Straighteners™ to
hold the workpiece to the guide board; otherwise,
the boards can slip apart, causing kickback. It is
often better to use too-many Board Straighteners™
than too-few.
11⁄2
"
length or longer than the
workpiece you will cut; and
3⁄16"
3
make a ⁄16" deep by 11⁄2" wide
rabbet cut the complete length
of your needed guide board.
• ONLY use Board Straighteners™ for holding an
irregular-edged board to a guide board for cutting
on your table saw. Board Straighteners™ are not
designed for cutting warped boards, which do not
sit flat on the table. DO NOT modify Board
Straighteners™ for any other task, but rather, use
“C” clamps, vises, jigs, and bar clamps for
associated clamping and gluing needs.
2. Position the guide board and workpiece to either side of
the Board Straighteners™ as shown in Figure 1.
3. Tighten the thumbscrews until the boards are securely held.
For long boards–use additional Board Straighteners™ DO
NOT over tighten the thumbscrews.
4. Slide the guide board against the fence and make your
first cut, remove the workpiece from the Board
Straighteners™, and put the freshly-cut side of the
workpiece against the fence and make your second cut.
The workpiece is now square.
• Woodstock International Inc. shall not be
responsible for damage or injuries caused by
improper use of the Board Straighteners™. If you
have any questions about the use of this tool,
contact Woodstock International Inc.
For questions contact Woodstock International Technical Support at 360-734-3482, or send e-mail to: [email protected].
COPYRIGHT© APRIL 2003 BY WOODSTOCK INTERNATIONAL, INC. WARNING: NO PORTION OF THIS DOCUMENT MAY BE
REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
Download from Www.Somanuals.com. All Manuals Search And Download.
|