Stationary Electronics Replacement Kit
Model RP80RTS
For help, email [email protected] or call 1-800-788-4417.
For receivers and programming, call 1-866-609-9374.
For up-to-date information on receiver compatibility and
2452280
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts of the Antenna
Removing the Existing
Installing the Replacement
Overhead View (Dome Removed)
Stationary Electronics Box Stationary Electronics Box
Cable harness 1
Reflector
1.
1. Before starting, turn off the power to the unit,
and unplug the unit from the receiver.
Insert the second (larger) motor connection
into the port underneath “P4 ELEVATION” on
the replacement stationary electronics box.
Cable harness 2
Cable harness 3
2. Using a #2 Phillips screwdriver, remove the
screws holding the dome to the base.
If applicable, remove the screws connecting
the handle to the unit, and remove the
handle. Set these screws aside; you will need
them later.
LNB
2. Insert the first (smaller) motor connection
into the port underneath “P3 AZIMUTH” on
the replacement stationary electronics box.
Cable harness 4
Frame
3. Align the two holes in the electronics box
and the frame. Insert a screw through each
1
4
3. Remove the dome.
hole, and tighten with a / ” Allen wrench.
4.
4. With both hands on either side of the
reflector, carefully tilt the reflector forward.
Connect the coaxial cable running from the
left side of the LNB to the port underneath
“LNBF.” Make sure the cable still runs behind
the LNB. Tighten until fingertight, and then
tighten a quarter turn with a 7/16” wrench. Do
not overtighten!
5. With a small flat screwdriver, loosen the
two screws on the side of the power supply
connector, and remove the power supply.
Do not loosen the two screws on the top of
the power supply. Refer to the image on the
bottom of this page.
5. Connect the other coaxial cable to the
port underneath “RECEIVER.” Tighten until
fingertight, and then tighten a quarter turn
with a 7/16” wrench. Do not overtighten!
6. Loosen and remove the two coaxial cables
underneath “LNBF” and “RECEIVER” with a
7/16” wrench.
6.
Plug in the power supply connector, and tighten
the two screws on the side of the connector
with a small flat screwdriver.
Remove all cables from the cable harnesses
marked in the image to the left.
7.
8.
7.
See “Routing the Cables in Cable Harnesses”
on the next page to finish installing the
electronics box.
Remove the two screws holding the
1
4
electronics box to the frame with a / ” Allen
wrench. Gently slide the electronics box
away from the frame.
The electronics box is still
Two screws to remove from power supply
WARNING
tethered to the unit. Do not
pull on the electronics box.
9.
10.
11.
Push down the lock on the first motor
connection. Remove the first motor connection
from the port below “P3 AZIMUTH.”
Coaxial cable
underneath “LNBF”
Screw holding electronics
box to the frame
Push down the lock on the second motor
connection. Remove the second motor
connection from the port below “P4 ELEVATION.”
Coaxial cable
underneath “RECEIVER”
Power supply connector
First motor connection
Second motor connection
Screw holding electronics
box to the frame
Remove the electronics box.
12. Continue with “Installing the Replacement
Stationary Electronics Box” on this page.
Base
Download from Www.Somanuals.com. All Manuals Search And Download.
|